A thermal monitoring sheet with low influence from adjacent waterbolus for tissue surface thermometry during clinical hyperthermia

This paper presents a complete thermal analysis of a novel conformal surface thermometer design with directional sensitivity for real-time temperature monitoring during hyperthermia treatments of large superficial cancer. The thermal monitoring sheet (TMS) discussed in this paper consists of a 2-D array of fiberoptic sensors embedded between two layers of flexible, low-loss, and thermally conductive printed circuit board (PCB) film. Heat transfer across all interfaces from the tissue surface through multiple layers of insulating dielectrics surrounding the small buried temperature sensor and into an adjacent temperature-regulated water coupling bolus was studied using 3-D thermal simulation software. Theoretical analyses were carried out to identify the most effective differential TMS probe configuration possible with commercially available flexible PCB materials and to compare their thermal responses with omnidirectional probes commonly used in clinical hyperthermia. A TMS sensor design that employs 0.0508-mm Kapton MTB and 0.2032-mm Kapton HN flexible polyimide films is proposed for tissue surface thermometry with low influence from the adjacent waterbolus. Comparison of the thermal simulations with clinical probes indicates the new differential TMS probe design to outperform in terms of both transient response and steady-state accuracy in selectively reading the tissue surface temperature, while decreasing the overall thermal barrier of the probe between the coupling waterbolus and tissue surface.      

Discovering Homophily in Online Social Networks

Mobile Networks and Applications - During the last ten years, Online Social Networks (OSNs) have increased their popularity by becoming part of the real life of users. Despite their tremendous...     

A 0.18 μm CMOS direct down-converter for highly integrated 3G receivers

This paper presents the design of a high dynamic range direct down-converter for 3G cell-phone applications. The mechanisms responsible for second-order intermodulation distortion are discussed in details, leading to the following design strategy: the transconductor is degenerated by means of an RC filter, an LC network resonating at RF frequency loads the switching pair and carefully matched resistors are used in the output load. Prototypes realized in 0.18 μm CMOS show: +78 dBm IIP2 minimum among 40 samples, +10 dBm IIP3, 4 nV/√Hz input-referred noise density while burning only 4 mA from 1.8 V.     

Heterogeneity of subunit composition in lupin globulins. Comparison of proteins from a single seed and from a number of seeds

The subunit compositions of a legumin-like (globulin 8) and a vicilin-like protein (globulin 4) extracted from a plurality of seeds and from a single seed both in commercial and in a selected cultivar of Lupinus albus were studied. In the case of globulin 4, a very similar number of bands were observed in SDS-PAGE, in the protein extracted from a batch of seed and in the same globulin isolated from a single seed. For globulin 8 the SDS-PAGE pattern showed fewer subunits in the protein from the batch of seeds than in that from a single seed. This is more pronounced in the single seed and in the plurality of seeds of a selected cultivar. Reasons for this behaviour are discussed.     

Detection of vesicoureteral reflux using microwave radiometry-system characterization with tissue phantoms

Microwave (MW) radiometry is proposed for passive monitoring of kidney temperature to detect vesicoureteral reflux (VUR) of urine that is externally heated by a MW hyperthermia device and thereafter reflows from the bladder to kidneys during reflux. Here, we characterize in tissue-mimicking phantoms the performance of a 1.375 GHz radiometry system connected to an electromagnetically (EM) shielded microstrip log spiral antenna optimized for VUR detection. Phantom EM properties are characterized using a coaxial dielectric probe and network analyzer (NA). Power reflection and receive patterns of the antenna are measured in layered tissue phantom. Receiver spectral measurements are used to assess EM shielding provided by a metal cup surrounding the antenna. Radiometer and fiberoptic temperature data are recorded for varying volumes (10-30 mL) and temperaturesg (40-46°C) of the urine phantom at 35 mm depth surrounded by 36.5°C muscle phantom. Directional receive pattern with about 5% power spectral density at 35 mm target depth and better than -10 dB return loss from tissue load are measured for the antenna. Antenna measurements demonstrate no deterioration in power reception and effective EM shielding in the presence of the metal cup. Radiometry power measurements are in excellent agreement with the temperature of the kidney phantom. Laboratory testing of the radiometry system in temperature-controlled phantoms supports the feasibility of passive kidney thermometry for VUR detection.     

Theory and simulation of a thermally matched micromachined thermopile in a wearable energy harvester

In this paper, a new theoretical concept in the thermoelectric theory is discussed, which is important for design optimization of a thermoelectric energy harvester. The general conditions are defined, which are required to make a thermoelectric converter effective in energy harvester application. The necessity of the work has been prompted by the fact that while modeling the harvesters neither a constant temperature difference nor a constant heat flow can be assumed. It is shown that the proposed equations allow thermal optimization of energy harvesters to reach their top performance characteristics. The example of thermal optimization in case of MEMS thermopiles is discussed then. It is shown that the knowledge of thermal properties of the environment, i.e., those of a heat source and a heat sink, play the key role in the optimization procedure.     

Analysis of the Effect of the I/Q Base-Band Filter Mismatch in an OFDM Modem

In digital communication modems in which a very high rate system clock is used, it is necessary to use analog base-band shaping filters in the inphase (I) and quadrature (Q) paths of the modulator. However, this type of implementation inherently produces a mismatch of the I and Q paths. In the present paper, results of the analysis of the transmitter (TX) I/Q mismatch in an Orthogonal Frequency Division Multiplexing (OFDM) system with Differential Coherent Quadrature Phase Shift Keying (DQPSK) modulation is presented. Theoretical analysis shows that the Signal-to-Noise (SNR) degradation due to the I/Q mismatch can be represented by a mismatch transfer function on the basis of which one can compute the maximum affordable amplitude and phase mismatch of the TX filters transfer functions.