Electrolytic regeneration of bleach solution in the motion picture industry

Cyclic voltammetric and galvanostatic experiments have been carried out with both synthetic and commercial bleach solutions with a view to regenerating the same. Maximum efficiency could be achieved if the oxidation is carried out below an anodic potential of 0·80 V vs SCE. The data obtained in galvanostatic experiments with RCE confirm the results of the earlier technique.     

Numerical analysis of solar cell current-voltage characteristics

This paper presents the determination of solar cell (SC) characteristics in double-exponential modelling using current-voltage (I–V) curve data for one-illumination level. The approach of the numerical analysis is based on the Newton-Raphson technique. Particular attention has been paid throughout to the set-up of the initial values to provide the best convergence of the iteration procedure and high accuracy of determined parameters.     

The evaluation of weekly hepatic arterial infusion of high-dose 5-FU for liver metastases from colorectal cancer

OBJECTIVE: The degree to which patient education in the areas of diet, exercise, and stress management can improve symptoms of irritable bowel syndrome (IBS) through healthier lifestyle behaviors is unknown. The aim of this study was to determine the effects of outpatient education on the short and long term outcomes, and the association between health-promoting behaviors and symptoms. METHODS: Pender's Health Promotion Model provided the theoretical framework. The study had a prospective longitudinal design. A consecutive sample of 52 adult outpatients with IBS attended a structured class that taught health-promoting modifications of lifestyle. Participants completed the Health-Promoting Lifestyle Profile (HPLP) and selected items from a Bowel Disease Questionnaire (BDQ) before the class and 1 month and 6 months later. Spearman rank correlations were used to assess the association between HPLP and symptom scores. Wilcoxon rank sum tests compared changes in scores versus their baseline values. RESULTS: Response rates at 1 and 6 months were 75% and 83%, respectively. Results revealed significant 1- and 6 month-improvements in pain and Manning symptoms (p < 0.01) and in some HPLP scores (exercise at 1 month, p < 0.05; stress management at 6 months, p < 0.01). Significant associations were found between some, but not all, HPLP and symptom scores over time. CONCLUSION: A structured IBS educational class for patients with IBS improved symptoms and some health-promoting behaviors. However, relationships among specific behaviors and specific symptoms did not consistently correspond with this improvement.     

A quaternary partial-response class-IV transceiver for 125 Mbit/sdata transmission over unshielded twisted-pair cables: principles ofoperation and VLSI realization

The paper describes an experimental transceiver for full-duplex transmission at a rate of 125 Mbit/s over unshielded twisted-pair cables of ordinary voice-grade quality, intended for use in a fiber distributed data interface (FDDI) network. Quaternary partial-response class-IV (QPRIV) overall-channel signaling with near-end crosstalk (NEXT) cancellation and maximum-likelihood sequence detection is employed. The spectral shape of the QPRIV signals facilitates equalization and achieving compliance with EMC regulations. Since in an FDDI system each transmitter can be clocked independently, the receiver must cope with phase drift between NEXT signals to be cancelled and signals received from the remote transmitter. With the chosen transceiver architecture, digital-to-analog conversion of transmit signals, analog-to-digital conversion of receive signals, and adaptive NEXT cancellation are performed synchronously with the transmitter clock. The rate change from transmit timing to controlled receive timing is accomplished by an adaptive equalizer in conjunction with an elastic buffer and occasional coefficient shifts. The equalizer is adjusted rapidly enough to allow for a maximal phase drift of ±100 ppm. The implementation of all digital signal-processing functions in a single 0.5 μm CMOS VLSI prototype chip is discussed. The employed standard-cell design resulted in a power consumption of 6 W. Significantly lower power consumption can be achieved by custom design of highly repetitive processing elements