High pass filter with above IC integrated SrTiO3 high K MIM capacitors

This paper describes realization and characterization of SrTiO₃ (STO) high K MIM capacitors above BiCMOS integrated circuit (IC). These capacitances are connected to IC and are used as coupling capacitors in order to realize a high pass filter. Surface capacitance achieved is 10 nF/mm² with capacitance value of 1.2 nF. The process for STO MIM fabrication does not exceed 400 °C, which is compatible with interconnections. Typical K and dielectric losses values obtained are, respectively 110% and 2%. Yield obtained reaches 83% for capacitors. A functional high pass filter using these STO capacitors was realized in this study. It exhibits a cut-off frequency at 6.5 kHz and a constant gain at higher frequencies of −1.3 dB.     

White Electrofluorescence Switching from Electrochemically Convertible Yellow Fluorescent Dyad

A fluorescent naphthalimide‐tetrazine dyad (NITZ) was examined for electrofluorochromism. The reversible electrochemistry of the tetrazine was accompanied by the fluorescence change through a quasi‐complete energy transfer in an electrochemical cell prepared by the mixture of polymer electrolyte and naphthalimide‐tetrazine dyad. Owing to the energy transfer within the dyad (naphthalimide and tetrazine), the fluorescence efficiency of NITZ was much enhanced and the effective fluorophore concentration in this system was much less than other tetrazine based electrofluorochromic device (EFD). Thus the yellow fluorescence of NITZ was switched on and off remarkably even with small quantity of NITZ (1 wt.%) in an EFD upon application of step potentials for different redox state. Furthermore, multi‐color fluorescence switching was achieved by blending a naphthalimide to the electrofluorochromic layer, to show white‐blue‐dark state of fluorescence. Since the tetrazine and naphthalimide units have their emission quenched at different potentials, the emission color could be tuned by quenching emission at selected wavelengths, reversibly, under low working potentials.     

Coupling dense and landmark-based approaches for nonrigid registration

In this paper, we investigate the introduction of cortical constraints for non rigid intersubject brain registration. We extract sulcal patterns with the active ribbon method, presented by Le Goualher et al. (1997). An energy based registration method (Hellier et al., 2001), which will be called photometric registration method in this paper, makes it possible to incorporate the matching of cortical sulci. The local sparse similarity and the photometric similarity are, thus, expressed in a unified framework. We show the benefits of cortical constraints on a database of 18 subjects, with global and local assessment of the registration. This new registration scheme has also been evaluated on functional magnetoencephalography data. We show that the anatomically constrained registration leads to a substantial reduction of the intersubject functional variability.     

Asymptotic global confidence regions for 3-D parametric shape estimation in inverse problems.

This paper derives fundamental performance bounds for statistical estimation of parametric surfaces embedded in R3. Unlike conventional pixel-based image reconstruction approaches, our problem is reconstruction of the shape of binary or homogeneous objects. The fundamental uncertainty of such estimation problems can be represented by global confidenceregions, which facilitate geometric inference and optimization ofthe imaging system. Compared to our previous work on global confidence region analysis for curves [two-dimensional (2-D) shapes], computation of the probability that the entire surface estimate lies within the confidence region is more challenging because a surface estimate is an inhomogeneous random field continuously indexed by a 2-D variable. We derive an asymptotic lower bound to this probability by relating it to the exceedence probability of a higher dimensional Gaussian random field, which can, in turn, be evaluated using the tube formula due to Sun. Simulation results demonstrate the tightness of the resulting bound and the usefulness of the three-dimensional global confidence region approach.     

Formation of silicon nanocrystals by thermal annealing of low-pressure chemical-vapor deposited amorphous SiNx (x=0.16) thin films

Silicon nanocrystals have been produced by thermal annealing of SiN_x thin film obtained by low pressure chemical vapor deposition using a mixture between disilane and ammonia. Morphological, structural, and photoluminescence properties of the thin film were investigated using X-ray diffraction, scanning electron microscopy, Raman spectroscopy and photoluminescence spectroscopy. The results revealed a high crystallinity of film with a crystalline volume fraction exceeded 70%, and a dominance of silicon nanocrystallites having the sizes within the range 2.5–5 nm and density ~1.98.10¹²/cm². The PL peaks consist of nanocrystalline silicon and amorphous silicon. The luminescence from the silicon nanocrystals was dominant.     

A new hybrid constraint-based approach for 3G network planning

This letter proposes a novel constraint-based 3G network planning model and a novel hybrid approach for optimizing the 3G network planning problem. Computational results show that the model and the approach are more efficient than the mathematical model and the existing heuristics. Optimal solutions are always obtained for small and medium sized problems. For larger sized problems, the final results are on average within 5.77%-7.48% of the lower bounds. The proposed hybrid approach can be an efficient tool for tackling a wide range of combinatorial NP-hard problems.     

Optimal data gathering paths and energy-balance mechanisms in wireless networks

This paper studies the data gathering problem in wireless networks, where data generated at the nodes has to be collected at a single sink. We investigate the relationship between routing optimality and fair resource management. In particular, we prove that for energy-balanced data propagation, Pareto optimal routing and flow maximization are equivalent, and also prove that flow maximization is equivalent to maximizing the network lifetime. We algebraically characterize the network structures in which energy-balanced data flows are maximal. Moreover, we algebraically characterize communication links which are not used by an optimal flow. This leads to the characterization of minimal network structures supporting the maximal flows.We note that energy-balance, although implying global optimality, is a local property that can be computed efficiently and in a distributed manner. We suggest online distributed algorithms for energy-balance in different optimal network structures and numerically show their stability in particular setting. We remark that although the results obtained in this paper have a direct consequence in energy saving for wireless networks they do not limit themselves to this type of networks neither to energy as a resource. As a matter of fact, the results are much more general and can be used for any type of network and different types of resources.     

Une optimisation en temps de calcul pour la prédiction de zones de couverture radioélectriques

This article presents a method which optimises the computation time for the prediction of a radio coverage, whatever the propagation model used. The principle consists in reducing the number of application points of the propagation model in relation to a classical technique. The proposed method is based on a multi resolution analysis of measured signals carried out around 2 GHz, and on an electromagnetic analysis of the propagation environment. The performances of the method are evaluated in term of reduction in computation time and of accuracy, in comparaison with the classical technique.     

Nanostructured Bulk Silicon as an Effective Thermoelectric Material

Thermoelectric power sources have consistently demonstrated their extraordinary reliability and longevity for deep space missions and small unattended terrestrial systems. However, more efficient bulk materials and practical devices are required to improve existing technology and expand into large‐scale waste heat recovery applications. Research has long focused on complex compounds that best combine the electrical properties of degenerate semiconductors with the low thermal conductivity of glassy materials. Recently it has been found that nanostructuring is an effective method to decouple electrical and thermal transport parameters. Dramatic reductions in the lattice thermal conductivity are achieved by nanostructuring bulk silicon with limited degradation in its electron mobility, leading to an unprecedented increase by a factor of 3.5 in its performance over that of the parent single‐crystal material. This makes nanostructured bulk (nano‐bulk) Si an effective high temperature thermoelectric material that performs at about 70% the level of state‐of‐the‐art Si_0.8Ge_0.2 but without the need for expensive and rare Ge.