THE EFFECT OF FURNACE ATMOSPHERE DUE TO COMBUSTION UPON HYDROGEN CONTENT IN LIQUID STEEL

<正> 在炼钢过程中,炉气中水汽是钢液中含氢的主要来源。就平炉而言,除了空气湿度和炼钢原材料带入炉中的水分以外,还有煤气燃烧生成的水汽。根据过去的研究结果,由于空气湿度直接或间接引起的水汽分压,一般波动于0.01—0.08个大气压之间,而煤气燃烧废气中的水汽分压则经常在0.1个大气压以上,有时甚至可以超过0.2     

CHARAC TERIZATION OF TiAl POWDER PRODUCED BY MECHANICAL ALLOYING

The microstructure,alloying reaction and sintering behavior of the powder produced by Mechanical Al-loying(MA)for 8 h from 64 wt.-% Ti powder and 36 wt.-% Al powder were studied by scanning electronmicroscopy,optical microscopy,X-ray diffractometry,differential scanning calorimetry(DSC)and dilatometry.The mechanically alloyed powder partictes are Ti-Al composite particles.Thus,titanium aluminides can formeasily in the powder through diffusion during heat treatment.It is shown that the sintering behavior of this pow-der,different from the behaviors of TiAl alloy powder and mixed powder of 64 wt.-% Ti powder and 36 wt.-%Al powder,changes from expansion at temperatures below 1000℃ to shrinkage at temperatures above 1000℃.Homogeneously alloyed TiAl material with a density over 96% of the theoretical density can be produced fromthe mechanically alloyed powder by compaction-sintering.     

共晶自生复合材料的晶形转变

自生复合材料的晶形转变受到成分过冷与曲面过冷两个因素的控制.非金属相具有较大的熔化熵且易形成小平面是改变领先相的因素,而领先相的改变则可能是晶形转变的根本原因.     

PREDICTION OF THE PROBABILITY OF SPHEROIDIZATION IN NODULAR CAST IRON BY PARAMETRIC DIAGRAM OF CHEMICAL BOND

<正> 本文试图从化学键理论出发,探讨石墨球化的规律。鉴于用键参数图法总结与化学键有关的规律性往往见效,故本文从球化剂元素和反球化元素在键参数图中的分布规律入手进行研究。 球化剂元素(或反球化元素)对石墨球化的影响应与该元素和C_(石墨)间的相互作用有关,其键参数函数写成如下形式:     

AN INVESTIGATION OF CASSITERITE FLOTATION USING MIXED TOLYL ARSONIC ACID

本文介绍了用混合甲苯胂酸浮选锡石的研究工作,试验表明混合甲苯胂酸对锡石的捕收能力优于对位和邻位甲苯胂酸。当混合比为45:55时,锡石产率出现“峰值”,可得到较高的浮选指标。为降低药剂成本,利用化工厂废弃的冷母液制造混合甲苯胂酸,在工业生产中证明是十分成功的。     

A NEW ELECTROMAGNETIC IMAGING SCHEME

ＡＮＥＷＥＬＥＣＴＲＯＭＡＧＮＥＴＩＣＩＭＡＧＩＮＧＳＣＨＥＭＥ①ＺｈａｎｇＲｏｎｇｆｅｎｇ，ＨｅＪｉｓｈａｎＣｏｌｅｇｅｏｆＲｅｓｏｕｒｃｅ，ＥｎｖｉｒｏｎｍｅｎｔａｎｄＣｉｖｉｌＥｎｇｉｎｅｒｉｎｇ，ＣｅｎｔｒａｌＳｏｕｔｈＵｎｉｖｅｒｓｉｔｙｏ...     

六铝酸钙材料的合成及其显微结构研究

分别采用轻质碳酸钙和活性氧化铝 ,或纯铝酸钙水泥和活性氧化铝为初始原料 ,反应烧结合成了六铝酸钙 (CA6)材料 ,研究了原料和成型压力对合成材料的烧结性能和显微结构的影响 ,同时借助于XRD、TG -DSC、SEM和EDAX等测试手段对其反应过程、物相变化和显微结构进行了分析和观察。研究结果表明 :(1) 130 0℃时 ,合成材料的主晶相为刚玉相和CA2 ,并开始有CA6形成 ;温度升至14 0 0℃ ,CA6大量生成 ;15 0 0℃时反应完成 ,产物全部为CA6相。 130 0～ 15 0 0℃时 ,上述反应表现为体积膨胀过程 ,试样的体积密度和径向线收缩率随温度的变化不大 ;而高于 15 0 0℃时 ,试样明显趋向烧结 ,体积密度升高 ,线收缩率加大。采用纯铝酸钙水泥和活性氧化铝合成的试样的体积密度均高于采用轻质CaCO3 和活性氧化铝的 ,尤其在烧成温度高于 15 0 0℃时。坯体的成型压力对这两种合成试样的烧结性能均没有显著影响。 (2 )合成六铝酸钙材料的晶粒形貌与合成工艺有关 ,制备片状晶粒的六铝酸钙材料需满足两个条件 :一是晶核有足够的发育空间 ,二是从晶核生长形成片状结构需足够的物质扩散。采用纯铝酸钙水泥和活性氧化铝为原料的试样 ,其CA6晶核很容易发育成片状晶形 ,且随着坯体成型压力的增加 ,片状CA6有向等轴状发展的趋势 ;采用     

聚丙烯结构壁管专用料的开发

阐述了塑料结构壁管的基本情况和国内外现状．重点就扬子石油化工股份有限公司研究院研制的聚丙烯结构壁管专用料的情况进行了介绍。     

Possible Energy Network with polygeneration system and CCS for China

On basis of adopting polygeneration systems for power and alternative fuels,capturing CO2 with near zero energy penalties,and storing CO2 on sites,a new kind of Energy Network can integrate energy utilization,CO2 capture,transportation and storage synthetically.Techno-economic analysis of this solution focusing on Inner Mongolia and the Yangtze River Delta districts had been carried with comparison to the chain method for energy utilization and CO2 sequestration.This solution can save 21.5% of energy,and re...     

Analysis of junction temperatures in high-power GaN-based LEDs

We presented the analysis of the incomplete conduction in bonding medium in high power GaN-based light-emitting diode (LED) packages. A numerical study was carried out with parametric model to understand the junction temperature variation due to bonding medium defects. Transient thermal measurement was performed to evaluate LED’s junction temperature. Thermal resistance from chip to lead frame was 20 K/W in our sample LED. It was suggested that only 60% of the surface area of the bonding medium was involved...