Adaptive S-ALOHA CDMA as an alternative way of integrating servicesin mobile environments

Code-division multiple-access (CDMA) schemes appear to be very promising access techniques for coping with the requirements of third-generation mobile systems, mainly because of their flexibility. This paper proposes an adaptive S-ALOHA DS-CDMA access scheme as a method for integrating nonreal-time (i.e., Internet applications) and real-time (i.e., voice) services in a multicell scenario by exploiting the potentials of CDMA under time-varying channel load conditions. The adaptive component makes data terminals autonomously change their transmission rate according to the total (voice+data) channel occupancy, so that the minimum possible data delay, which can be analytically obtained by defining a birth-death process, is almost always achieved. Moreover, by means of a simplified cellular model, the proposed algorithm revealed the same behavior, i.e., it tries to select the most suitable transmission rate at any time slot, when it is affected by intercell interference and even by power control imperfections. Finally, in order to gain more insight into the potentials of such an access strategy, the adaptive S-ALOHA CDMA scheme is then compared to a reservation time-division multiple-access (TDMA)-based protocol (PRMA++), showing the benefits of the CDMA-based solution in terms of capacity, flexibility, and data delay performance     

Shallow acceptors in strained Ge/Ge1−x Six heterostructures with quantum wells

The energies of localized acceptor states in quantum wells (strained Ge layers in Ge/Ge_1?x Si_x heterostructures) were analyzed theoretically in relation to the quantum well width and the impurity position in the well. The impurity absorption spectrum in the far IR range is calculated. Comparison of the results of the calculation with experimental photoconductivity spectra allows an estimation of the acceptor distribution in the quantum well to be made. In particular, it was concluded that acceptors may largely concentrate near the heterointerfaces. The absorption spectrum is calculated taking into account the resonance impurity states. This allows the features observed in the short-wavelength region of the spectrum to be interpreted as being due to transitions into the resonance energy levels “linked” to the upper size-quantization subbands.     

Cu/low-k dielectric TDDB reliability issues for advanced CMOS technologies

With the wide application of low-k and ultra-low-k dielectric materials at the 90 nm technology node and beyond, the long-term reliability of such materials is rapidly becoming a critical challenge for technology qualification. Low-k time-dependent dielectric breakdown (TDDB) is usually considered as one of the most important reliability issues during Cu/low-k technology development because low-k materials generally have weaker intrinsic breakdown strength than traditional SiO₂ dielectrics. This problem is further exacerbated by the aggressive shrinking of the interconnect pitch size due to continuous technology scaling. In this paper, three critical issues of low-k TDDB characteristics during low-k development and qualification will be reviewed. In the first part, a low-k TDDB field acceleration model and its determination will be discussed. In the second part, low-k dielectric time-to-breakdown (t_BD) statistical distribution and TDDB area scaling law for reliability projection will be examined. In the last part, as low-k TDDB has been found to be sensitive to all aspects of integration, the effects of process variations on low-k TDDB degradation will be demonstrated. Some key aspects which need to be carefully addressed to control overall low-k TDDB performance from process and integration side will be discussed.     

Characterization of copper grain growth limitations inside narrow wires depending of overburden thickness

With the downscaling of feature dimensions, copper interconnects exhibit properties differing from bulk or film material. Resistivity increases and limits electrical performances, and reliability of interconnects becomes a more important challenge for each new technological node. In this study, we present an approach of copper grain growth control inside narrow wires by adding a step between the copper electro-chemical deposition (ECD) and the chemical-mechanical polishing (CMP). This step corresponds to a partial CMP step (pre-CMP) and is applied after ECD and before anneal in order to modify the copper overburden thickness. Depending on the targeted thickness, copper grain growth occurs during anneal with different efficiencies. Crystallization and grain growth behaviour inside wires is investigated with focused ions beam (FIB). We present here our methodology for sample preparation and characterization. Results are focused on electrical variations and on morphological aspects of copper crystallization and grain growth inside lines observed with various overburden thicknesses.     

Analytical Model for Cross-Gain Modulation and Crosstalk in Quantum-Well Semiconductor Optical Amplifiers

An analytical model of the dynamic characteristics of a quantum-well (QW) semiconductor optical amplifier (SOA) is developed. Closed-form expressions for the optical gain and cross-gain modulation (XGM) for arbitrary input pulses are derived. The model takes into account the carrier capture and escape transitions between the QW and the continuum states. This model is also used to derive a closed-from expression for interchannel XGM crosstalk in multichannel SOA systems. The model/analysis provides insight into the effect of the SOA parameters on the performance of a wavelength-division multiplexed system. We found that crosstalk in a multichannel SOA system can be reduced by reducing the escape lifetime.     

Precise Tip Positioning of a Flexible Manipulator Using Resonant Control

A single-link flexible manipulator is fabricated to represent a typical flexible robotic arm. This flexible manipulator is modeled as an SIMO system with the motor torque as the input and the hub angle and the tip position as the outputs. The two transfer functions are identified using a frequency-domain system identification method, and the resonant modes are determined. A feedback loop around the hub angle response with a resonant controller is designed to damp the resonant modes. A high-gain integral controller is also implemented to achieve zero steady-state error in the tip position response. Experiments are performed to demonstrate the effectiveness of the proposed control scheme.     

The Asymmetric Golden Code for Fast Decoding on Time-Varying Channels

The golden code is a full-rate full-diversity space–time code for the two-input two-output channel with good performance but high decoding complexity. The overlaid Alamouti codes were recently proposed as an alternative; in exchange for a slight performance penalty, they have lower decoding complexity on quasistatic channels with QAM alphabets. However, the complexity advantage of the overlaid codes vanishes for time-varying channels. This paper proposes the asymmetric golden code, a novel full-rate and full-diversity space–time code for the two-input two-output channel that offers reduced-complexity decoding on both quasistatic and time-varying channels.     

A physically based stochastic-deterministic procedure for the estimation of flood frequency

A procedure based on the method of derived distributions is proposed for the estimation of flood frequency from ungauged watersheds. The results of previous research on rainfall characteristics and watershed response are incorporated into the proposed procedure. These rainfall characteristics are storm depth, storm duration, space and time distribution. A simplified watershed model is used which has previously given good simulation of the watershed response. Some of the rainfall and watershed model parameters are stochastic in nature and are assumed to follow various probability distributions. Monte Carlo simulation is used for the generation of the various parameter values and simulation of the peak flow hydrographs. After 5000 realizations, the frequency of the hourly and daily peak flow and the flood volume is estimated. The proposed procedure is applied to eight coastal British Columbia watersheds and the results compare well with the observed data and with fitted probability distributions. The method is easy to apply, requires limited data and is shown to be reliable. Sensitivity analysis shows that the procedure is not very sensitive to uncertainty of the parameter values and is not dependent on the parameter probability distributions used.     

Relationship between thermal treatment of milk and hysteresis of the milk protein system. II. Studies on casein micelles (author's transl)]

The association of colliodial calcium phosphate with the casein micelles is the principal reason for hysteresis of the milk protein system. Because of this association the secondary calcium phosphate cannot be titrated at its pK = 7.2, but only at lower pH values depending on the previous thermal treatment of the milk. However after overcoming certain energy barriers it can be titrated (between pH 5.8 and 5.2), but then clacium phosphate is separated irreversibly from the micelles. Therefore in the subsequent base titration other molecular conditions are passed through than in acid titration. The consequence is a hysteresislike titration curve. By heating, the surface of the micelles are covered successively with serum proteins. Due to this coating additional diffusion barriers are constructed. The diffusion of the protons into the interior of the micelles is measurably retarded. The expansion of the hysteresis loop can be determined quantitatively.