C-t analysis of MOS capacitors under constant current stress

The effect of high oxide field stress is studied using capacitance-time (C-t) measurements of MOS capacitors. The stress results in parallel shifts of the C-t curve along the time axis. The flatband voltage shift ΔV_FB obtained from the initial deep depletion capacitance C(t=0⁺) follows the same trend as that from the high-frequency C-V characteristics. However, the discrepancy between the two flatband voltages becomes larger as the stress increases due to the effect of interface charges on C-t characteristics. The flatband voltage difference is converted to interface trap density, showing a steady increase of interface trap density with stress, similar to that from low-frequency C-V measurements     

A fully soft-switched extended-period quasi-resonantpower-factor-correction circuit

This paper presents the design criteria, procedure, and implementation of a soft-switched power-factor-correction (PFC) circuit based on the extended-period quasi-resonant (EPQR) principles. All power electronic devices including switches and diodes in the circuit are fully soft switched. The design method is demonstrated in a prototype circuit. The operating principles are confirmed with computer simulation and experimental results. A comparison of the EP-QR operation and zero-voltage-transition (ZVT) pulse-width modulation (PWM) method     

Automatic fault detection, isolation, and recovery in transparentall-optical networks

Network fault identification is an important network management function, which is closely related to fault management and has an impact on other network management functions such as configuration management, and performance management. This paper investigates fault surveillance and fault identification mechanisms for a transparent optical network in which data travels optically from the source node to the destination node without going through any optical-to-electrical (O/E) or electrical-to-optical (E/O) conversion. Mechanisms and algorithms are proposed to detect and isolate faults such as fiber cuts, laser, receiver, or router failures. These mechanisms allow nonintrusive device monitoring without requiring any prior knowledge of the actual protocols being used in the data transmission     

A new lateral MOS-gated thyristor with controlling base-current

A new lateral MOS-gated thyristor, called the Base-Current-Controlled Thyristor, is described. This device is designed so that most holes at the on-stage reach the P base through the floating P⁺ region adjacent to the P base and the on-state MOSFET. At the turn-off stage, the interruption of the hole current to the P base due to switching off the above MOSFET occurs simultaneously with the conventional turn-off operation. The concept of this device is verified experimentally by using the fabricated lateral device with the external MOSFET. This device exhibits a better trade-off relation between the on-state voltage and the turn-off time compared uith the conventional MOS-gated thyristor     

Series equivalence/operation of current-controlled boost-typesingle-phase voltage source converters for bidirectional power flow

Single-phase voltage source power converters (VSCs) under consideration are AC-DC current-controlled boost-type power converters with bidirectional power-handling capability. Equivalence between two series-connected two-level power converters and a single three-level power converter is considered here. Further considered is the series operation of three-level power converters. Simulation results and experimental verification for both are provided. Economical configurations of three-level power converters leading to multilevel waveforms are presented thereafter     

A wafer level monitoring method for plasma-charging damage usingantenna PMOSFET test structure

A novel monitoring method for plasma-charging damage is proposed. This method performs a quick and accurate evaluation using antenna PMOSFET. It was found that not only hot-carrier (HC) lifetime but transistor parameters such as initial gate current and substrate current were changed according to the degree of plasma-charging damage. However, the present work suggests that monitoring the shift of drain current after a few seconds of HC stress is a more accurate method to indicate plasma-charging damage. The monitoring method using the present test structure is demonstrated to be useful for realizing highly reliable devices     

Perineurioma: an unusual cause of an external auditory canal polyp

BACKGROUND: Home parenteral nutrition (HPN) is used to treat intestinal failure. A minority of HPN patients are dependent on opiates and benzodiazepines to control pain and anxiety. The aim of this study was to determine what effects such drug dependence had on patient outcomes. METHODS: Ten dependent patients were prospectively compared with 10 well-matched, nondependent HPN patients for the same 12-month period. Episodes of line sepsis and other complications were documented and the cost of treatment estimated. Health status was measured using the SF36 and EuroQol instruments. RESULTS: The dependent group had significantly more episodes of central line sepsis (p = .0007) as well as other complications (p = .0002). This led to significantly longer periods of inpatient care (p = .0004) and therefore higher costs of treatment. Health status was lower in the dependent group; they reported more pain (p = .04) and less energy (p = .04). CONCLUSIONS: The complication rate and increased cost of treatment for opiate- and sedative-dependent patients receiving HPN significantly detract from the overall outcome of this therapy.     

Biosynthesis of the escherichia coli K4 capsule polysaccharide. A parallel system for studies of glycosyltransferases in chondroitin formation

Escherichia coli K4 bacteria synthesize a capsule polysaccharide (GalNAc-GlcA(fructose))n with the carbohydrate backbone identical to chondroitin. GlcA- and GalNAc-transferase activities from the bacterial membrane were assayed with acceptors derived from the capsule polysaccharide and radiolabeled UDP-[14C]GlcA and UDP-[3H]GalNAc, respectively. It was shown that defructosylated oligosaccharides (chondroitin) could serve as substrates for both the GlcA- and the GalNAc-transferases. The radiolabeled products were completely degraded with chondroitinase AC; the [14C]GlcA unit could be removed by beta-D-glucuronidase, and the [3H]GalNAc could be removed by beta-N-acetylhexosaminidase. A fructosylated oligosaccharide acceptor tested for GlcA-transferase activity was found to be inactive. These results indicate that the chain elongation reaction of the K4 polysaccharide proceeds in the same way as the polymerization of the chondroitin chain, by the addition of the monosaccharide units one by one to the nonreducing end of the polymer. This makes the biosynthesis of the K4 polysaccharide an interesting parallel system for studies of chondroitin sulfate biosynthesis. In the biosynthesis of capsule polysaccharides from E. coli, a similar mechanism has earlier been demonstrated for polysialic acid (NeuNAc)n (Rohr, T. E., and Troy, F. A. (1980) J. Biol. Chem. 255, 2332-2342) and for the K5 polysaccharide (GlcAbeta1-4GlcNAcalpha1-4)n (Lidholt, K., Fjelstad, M., Jann, K., and Lindahl, U. (1994) Carbohydr. Res. 255, 87-101). In contrast, chain elongation of hyaluronan (GlcAbeta1-3GlcNAcbeta1-4)n is claimed to occur at the reducing end (Prehm, P. (1983) Biochem. J. 211, 181-189).     

Evaluating the impact of CASE: an empirical comparison of retrospective and cross-sectional survey approaches

The purpose of this paper is to evaluate two methods of assessing the productivity and quality impact of Computer Aided Software Engineering (CASE) and Fourth Generation Language (4GL) technologies: (1) by the retrospective method; and (2) the cross-sectional method. Both methods involve the use of questionnaire surveys. Developers' perceptions depend on the context in which they are expressed and this includes expectations about the effectiveness of a given software product. Consequently, it is generally not reliable to base inferences about the relative merits of CASE and 4GLs on a cross-sectional comparison of two separate samples of users. The retrospective method that requires each respondent to directly compare different products is shown to be more reliable. However, there may be scope to employ cross-sectional comparisons of the findings from different samples where both sets of respondents use the same reference point for their judgements, and where numerical rather than verbal rating scales are used to measure perceptions.     

Electrical linewidth test structures fabricated in monocrystallinefilms for reference-material applications

The physical widths of reference features incorporated into electrical linewidth test structures patterned in films of monocrystalline silicon have been determined from Kelvin voltage measurements. The films in which the test structures are patterned are electrically insulated from the bulk-silicon substrate by a layer of silicon dioxide provided by SIMOX (Separation by the IMplantation of OXygen) processing. The motivation is to facilitate the development of linewidth reference materials for critical-dimension (CD) metrology-instrument calibration. The selection of the (110) orientation of the starting silicon and the orientation of the structures' features relative to the crystal lattice enable a lattice-plane-selective etch to generate reference-feature properties of rectangular cross section and atomically planar sidewalls. These properties are highly desirable for CD applications in which feature widths are certified with nanometer-level uncertainty for use by a diverse range of CD instruments. End applications include the development and calibration of new generations of CD instruments directed at controlling processes for manufacturing devices having sub-quarter-micrometer features