A Methodology for Calculating the Natural Gas Compressibility Factor for a Distribution Network

This work describes a methodology that allows an accurate correlation for natural gas compressibility factor to be obtained. This methodology was applied to the Parana State natural gas distribution network in Southern Brazil, whose operating conditions were characterized by more than 14,000 pairs of pressure–temperature readings, measured along eight months. Compressibility factors calculated following Peng-Robinson, Patel-Teja-Valderrama, Shell Oil Company, Soave-Redlich-Kwong, and Van der Waals were compared to those given by the American Gas Association equation, which is used by most natural gas companies. Finally, an alternative correlation was proposed, which is highly accurate within the network operating range.     

The influence of the CO inhibition effect on the estimation of the H2 purification unit surface

The CO inhibition effect on H₂ permeance through commercial Pd-based membranes was analysed by means of permeation measurements at different CO compositions (0–30% molar) and temperatures (593–723 K) with the aim to determine the increase of the membrane area in order to compensate the H₂ flux reduction owing to the CO inhibition effect. The permeance of H₂ fed with carbon monoxide was observed to decrease with respect to the case of pure hydrogen. At 647 K the H₂ permeance of a pure feed of 316 μmol m⁻² s⁻¹ Pa^−0.5 reduces progressively until 275 μmol m⁻² s⁻¹ Pa^−0.5 when 15% or more of CO is present in the system, until it reaches a plateau at 20%. The inhibition effect occurring when CO is present in the feed stream reduces with the progressive temperature increase; the reduction of the permeance decreases exponentially by 23% at 593 K and by 3% at 723 K with 10% of CO. The inhibition effect is seen to be reversible. An H₂ flux profile in a Sieverts' plot shows the effect produced by the increase of the CO composition along the Pd-based membrane length. The H₂ flux profile allows the area of a Pd-based membrane to be evaluated in order to have the same permeate flow rate of H₂ when it is fed with CO or as a pure stream. Moreover, a qualitative comparison between the H₂ flux profiles and a previously proposed model has been carried out.     

Fracture Behaviour of Nickel-Titanium Laser Welded Joints

In this study, the effects of Nd:YAG laser welding on the fracture behavior of Ni-rich nickel-titanium sheets are analyzed by experimental investigations. The welding was carried out in open air conditions by using a special shielding/clamping system to avoid the chemical contamination of the molten zone and the formation of hot cracks. Mechanical tests of standard dog bone-shaped and single edge crack specimens were carried out to measure the stress-strain response and the fracture resistance of both the base and the welded materials. Furthermore, scanning electron microscopy observations of the fracture surfaces were carried out in order to better understand the failure mechanisms. Finally, systematic comparative studies between base and laser-welded materials were carried out.     

Low Risk Synthesis of Energetic Poly(3‐Azidomethyl‐3‐Methyl Oxetane) from Tosylated Precursors

Azidated oxetanic polymers such as poly(3‐azidomethyl‐3‐methyl oxetane), are under investigation as “energetic” binder to be used as an alternative to polybutadiene in solid rocket propellants. The classic synthetic route for the production of the polymer is through an azidated monomer where the N₃⁻ functionality has been previously introduced by nucleophilic displacement of a suitable, usually a halogen, leaving group. However, this could involve critical steps with manipulation of a highly unstable liquid monomer. Here it is shown that the azidation can be performed as the final step of the preparation by substitution of the tosyl group in a preformed polymer. The procedure assures good yield and purity of the product and satisfactory rate of reaction, being the energetic functionality always kept in a safe form, which shows low shock and friction sensitivity. Poly(3‐azidomethyl‐3‐methyl oxetane) was prepared by azidation of poly(3‐tosyloxymethyl‐3‐methyl oxetane) in dimethylsulfoxide, testing several operating conditions. Moreover, hypothesizing a second order kinetics, the rate constant and the activation energy for the azidation step have been estimated.     

Characterization and modeling of quantum cascade lasers based on aphoton-assisted tunneling transition

A detailed characterization and modeling of long-wavelength (λ~10 μm) quantum cascade (QC) lasers based on a photon-assisted tunneling transition are presented. In particular, the influence of the finite lifetime of the lower state of the laser transition on the current-voltage and threshold current versus temperature characteristics have been studied both theoretically and experimentally. It is shown that, for our structure, the value of the lower state lifetime can be extracted from the voltage-current curve; the value we found was 2.6 ps. In addition, this model allows to understand the abrupt degradation of the performance of the device for T>150 K. Low temperature (T=10 K) threshold current densities of 1.1 kA/cm² and a tuning range of 85 cm^-1 in pulsed mode are reported. In continuous-wave mode, the emission linewidth of a free-running laser was determined to be 3.9 MHz     

Effect of protein malnutrition on the glycolytic and glutaminolytic enzyme activity of rat thymus and mesenteric lymph nodes

Genotyping of hepatitis C virus (HCV) of liver disease patients in the Dominican Republic was performed. Eighty-four samples positive for HCV antibody, which were confirmed by ELISA, particle agglutination, and recombinant immunoblot assay III tests, were subjected to HCV genotyping by polymerase chain reaction using type-specific primers located in the nonstructural protein 5 region. Of the 84 samples tested, 50 (59%) were found to have genotype 1a/I and this genotype was the most frequent type detected in the present study. The numbers of isolates of genotypes 1b/II, 2a/III, 2b/IV, and 3a/V were three (3.6%) six (7.1%), two (2.4%), and two 2.4%), respectively. The number of samples having mixed genotype populations was 16 (19%). The possible causes of the high prevalence of genotype 1a/I in the Dominican Republic compared with other countries and of the high detection ratio of samples having mixed genotypes are discussed.     

Melting and solidification in microgravity of sintered aluminum powder alloys

Results of melting and solidification experiments in μ-g of sintered aluminum powder alloys (with 4 pct and 7 pct of A1₂O₃) are presented. Thin oxide films have been used as tight containers which remain adherent during melting and solidification. Convective motion in melted metals in μ-g are indicated from observations of the oxide particle distribution after melting and solidification. Effects of Marangoni convection are always observed in relatively large cylindrical samples, 5 mm diameters, melted and solidified in μ-g. Thin disc-shaped samples do not present evidence of convective motions in μ-g. Even in the absence of convective motion in the thin samples, some particle aggregation occurs, depending on the interactions with the solidification front and conditioned by diffusion controlled critical radii for capture in the solid. This paper is based on a presentation made in the symposium “Experimental Methods for Microgravity Materials Science Research” presented at the 1988 TMS-AIME Annual Meeting in Phoenix, Arizona, January 25–29, 1988, under the auspices of the ASM/MSD Thermodynamic Data Committee and the Material Processing Committee.     

Epidemiology of acute hepatitis B in a university hospital in S?o Paulo, Brazil: retrospective study of two five-year periods

CONTEXT: HBV infection is endemic in Brazil and acute HBV infection is still a common disease. OBJECTIVE: To analyze incidence, risk factors and evolution of acute HBV infection. SETTING: University Hospital. PATIENTS: 357 patients with acute HBV infection, comparing two periods: 1985-1989 vs. 1990-1994. RESULTS: The overall incidence declined from 50 new cases/year in 1985-89 (30% of all cases) to 25 new cases/year in 1990-94 (8% of all cases). Transmission among male homosexuals (3.9% of cases in 85-89) declined to 1.3% in 90-94 (p > 0.05). Amongst health care workers (HCW) it declined from 8.2% to 2.0% (p = 0.02). Conversely, heterosexual transmission increased from 4.8% to 10.1% (p = 0.06). Chronification of HBV infection following the acute episode was observed in 1.7%. Fulminant hepatic failure was seen in 3.4%. However, 27.2% of patients were lost to follow-up before normalization of the biochemical tests. CONCLUSIONS: The different patterns of risk factors observed is probably related to measures for preventing AIDS and to HCW vaccination programs. Chronification following acute episodes was not a common event.