Optimization of biohydrogen production by Clostridium butyricum EB6 from palm oil mill effluent using response surface methodology

Clostridium butyricum EB6 successfully produced hydrogen gas from palm oil mill effluent (POME). In this study, central composite design and response surface methodology were applied to determine the optimum conditions for hydrogen production (P_c) and maximum hydrogen production rate (R_max) from POME. Experimental results showed that the pH, temperature and chemical oxygen demand (COD) of POME affected both the hydrogen production and production rate, both individually and interactively. The optimum conditions for hydrogen production (P_c) were pH 5.69, 36 °C, and 92 g COD/l; with an estimated P_c value of 306 ml H₂/g carbohydrate. The optimum conditions for maximum hydrogen production rate (R_max) were pH 6.52, 41 °C and 60 g COD/l; with an estimated R_max value of 914 ml H₂/h. An overlay study was performed to obtain an overall model optimization. The optimized conditions for the overall model were pH 6.05, 36 °C and 94 g COD/l. The hydrogen content in the biogas produced ranged from 60% to 75%.     

真空缓冷铸渣机冷却炉渣选铜的研究

介绍了真空缓冷炉渣的工艺矿物学特性。试验研究结果表明，该炉渣属于中等可碎性偏难，硬度系数在８￣１６之间，在磨矿细度为－０．０１６ｍｍ占８９％时，粗、扫选抛尾粗精矿再磨再选，以Ｚ－２００、ＳＮ－９和丁胺为混合捕收剂，最终得到铜精矿产率为４．５９％，精矿含铜２３．４８％，含金５．８ｇ／ｔ，铜回收率为８３．７０％；尾矿含铜０．２２％，含金０．１８ｇ／ｔ。     

Use of Palm Mid-Fraction in White Chocolate Formulation

Samples of two types of palm mid-fraction (PMF I, a commercial sample and PMF II, from a laboratory-scale acetone fractionation of PMF I) and a Malaysian deodorised cocoa butter sample were used as the main components in the fat phase for white chocolate formulation. The monounsaturatedtriacylglycerol contents of these fats were 853, 899 and 903 g kg⁻¹, respectively.All the fats had free fatty acid contents of less than 10 g kg⁻¹ and melting points in the range of 34·0–34·5°C. The solid fat content profiles for the three fats were very steep. Differential scanning calorimeter analyses showed that all the fats had two melting peaks, T1 and T2. Results of the study showed that the tempering time to produce a well-tempered chocolate using PMF I was longer than that using PMF II, whereas, the time to produce a well-tempered cocoa butter chocolate increased with increase in the tempering temperature. Chocolates made with PMF I and II were well tempered between 17 and 19°C and with cocoa butter at 23°C. Thermal analyses, carried out on the chocolate showed that PMF I and II produced three melting peaks, T1, T2′ and T2 whereas most of the cocoa butter chocolates exhibited only one melting peak, T2. Storage studies showed that most of the chocolates had good bloom resistance for up to 12 weeks storage.     

Synthesis and characterization of (poly (N-vinyl formamide)—pregelled starch—graft copolymer

Bromate / cyclohexanone redox system was investigated as a novel initiator for graft copolymerization of N-vinyl formamide onto pregelled starch. A number of variables in the grafting reaction were investigated including N-vinyl formamide, cyclohexanone, bromate ion, sulphuric acid and pregelled starch concentrations, material to liquor ratio along with polymerization time and temperature. The graft copolymers were evaluated in terms of graft yield, graft reaction efficiency and homopolymer formation (%). The optimum conditions for grafting of N-vinyl formamide onto pregelled starch are: N-vinyl formamide 50% based on weight of substrate, cyclohexanone 15 mmol / l, bromate ion, 30 mmol / l, liquor ratio 10, pH 6, time 120 min., and temperature 40°C. On the other hand, characterizations of the resultant copolymers with respect to swelling capacity, solubility %, metal ion up-take and suitability as a sizing agent for cotton textiles were investigated. The results obtained reflect that, the resultant copolymer shows better results for the aforementioned properties in comparison with that obtained from native pregelled starch as a starting substrate.     

End-use energy analysis in the Malaysian industrial sector

The industrial sector is the second largest consumer of energy in Malaysia. In this energy audit, the most important parameters that have been collected are as follows: power rating and operation time of energy-consuming equipments/machineries; fossil fuel and other sources of energy use; production figure; peak and off-peak tariff usage behavior and power factor. These data were then analyzed to investigate the breakdown of end-use equipments/machineries energy use, the peak and off-peak usage behavior, power factor trend and specific energy use. The results of the energy audit showed that the highest electrical energy-using equipment was an electric motor followed by pumps and air compressors. The specific energy use has been estimated and compared with four Indonesian industries and it was found that three Malaysian industries were more efficient than the Indonesian counterpart. The study also found that about 64% electrical energy was used in peak hours by the industries and the average power factor ranged from 0.88 to 0.92. The study also estimated energy and bill savings using highly efficient electrical motors along with the payback period.     

Quality-aware images.

We propose the concept of quality-aware image, in which certain extracted features of the original (high-quality) image are embedded into the image data as invisible hidden messages. When a distorted version of such an image is received, users can decode the hidden messages and use them to provide an objective measure of the quality of the distorted image. To demonstrate the idea, we build a practical quality-aware image encoding, decoding and quality analysis system, which employs: 1) a novel reduced-reference image quality assessment algorithm based on a statistical model of natural images and 2) a previously developed quantization watermarking-based data hiding technique in the wavelet transform domain.     

基于Duf fing 方程参数敏感性提取 谐振型传感器频率的仿真研究

由于谐振型传感器在感测被测之量变化时 ,表现为谐振频率的偏移 ,因此 ,为提高传感器的分辨率和灵敏度 ,对探索频偏的精确测定很为重要 .本文首先对 Duffing方程进行仿真 ,指出 Duffing方程在从混沌状态到大周期转变时 ,同时具有幅值敏感性和频率敏感性 ,进一步提出频率敏感性可应用于传感器微弱频率变化的提取 .仿真表明该方法还能实现对不同频率变化精度的预性测量 ,文中还进一步分析了其理论基础 ,提出了驱动力等效性观点     

基于局部模型网络的超声波浓度测量和在线校正

在很多情况下 ,液体浓度是其声速的函数 ,而且在不同的温度点上 ,这种函数关系是不同的 .针对浓度、声速和温度关系的这种特点 ,本文提出了基于局部模型网络的浓度和声速、温度关系的拟合和校正方法 .这种方法比普通的多项式拟合具有更多的灵活性和适用性 ,易于在线进行 .     

Thermal management of high heat flux nanoelectronic chips

Driven by the continuing Moore’s Law evolution in chip technology, power dissipation of nanoelectronics chips could exceed 300W, with heat fluxes above 150W/cm², within the next few years, along with localized, sub-millimeter zones with heat fluxes in excess of 1kW/cm². New and novel cooling techniques, with the ability to selectively cool sub-millimeter “sun spots” while providing effective global cooling for high heat flux chips are needed. Several promising approaches, including the application of miniaturized silicon and BiTe thermoelectric coolers and direct cooling with dielectric liquids through thin film evaporation, will be described.