OTDM transmitter using WDM-TDM conversion with an electroabsorptionwavelength converter

An all-optical multiplexing technique using wavelength division multiplexing (WDM)-time division multiplexing (TDM) conversion with an electroabsorption wavelength converter has been proposed and demonstrated. The effectiveness of this WDM-TDM conversion technique for various pulsewidth settings was experimentally investigated. The fluctuation of the signal performance, which was inevitably caused by the coherent crosstalk between adjacent pulses in the conventional optical time division multiplexing (OTDM) technique, were successfully suppressed, even in the case of wide pulse duration. High Q-factor performance has been maintained for a wide range of duty ration from 36% to 74%. By introducing this technique to the optical time division multiplexer, a highly stable and high-quality 40-Gb/s optical signal can be effectively produced without generating the short pulse or setting two tributaries at orthogonal polarization states, and without introducing high-speed electronics for signal multiplexing. The WDM-TDM conversion with an electroabsorption wavelength converter was extended to 60-Gb/s operation by using three 20-Gb/s tributaries. A clear eye opening was confirmed for a waveform after the WDM-TDM conversion of the 60-Gb/s signal     

The effects of pressure on the isothermal fluid behavior of bituminous coals

An investigation into the effects of pressure (helium gas) on the isothermal fluid behavior includes: (1) the effect of pressure on the rate of melting and coking as evidenced by the rate constants k(melt) and k(coke); (2) the effect of pressure on the energies of activation of melting and coking; (3) the effects of pressure on the characteristic times; (4) the effects of pressure on the maximum isothermal fluidity. Results from the effects of pressure on k(melt) revealed that it was generally the high total sulfur, low nitrogen, low reactives/mineral matter ratio, medium rank coals which show the greatest increase in k(melt), whereas the highest rank coals show the least decrease in k(coke). The energies of activation of melting and coking were not significantly affected by pressure. The investigation also reveals increases or decreases in the respective times of softening, maximum fluidity, resolidification and total time of fluid behavior under isothermal pressurized conditions. There appears the possibility that these shifts may be rank dependent. Additionally, the lower rank coals show the largest relative increase in their fluidities when subjected to pressure. Empirical relationships were derived in order to quantitatively predict the maximum isothermal fluidity for most (fluid) coals at a given pressure.     

A STUDY OF THE PRIMARY PHASE OF FOOD FREEZE-DRYING IN VACUO

In the development of a novel freeze-drying technique in a fluidized bed at atmospheric pressure, a parallel study was undertaken using a conventional vacuum equipment. Two kinetically distinct phases were observed during freeze drying of representative Pood samples:

(1) a period during which the rate of drying was constant and (2) a second period during which the drying rate sufferedcontinual reduction. This paper focused attention on the primary drying period which corresponded with the kinetics of sublimation of pure     

IEEE Richard Harold Kaufmann Award Call for Nominations

This letter further discusses the difference between different definitions of voltage unbalance. Contrary to an earlier letter (see P. Pillay et al., ibid., vol.5, p.50-1, 2001), it is concluded that different definitions may give significantly different results. The two IEEE definitions that were not discussed in the earlier letter give different results and both deviate significantly from the true value (ratio of negative, and positive-sequence voltage) when a zero-sequence component is present.     

Collision Detection and Multitone Tree Search for Multiple-Access Protocols on Radio Channels

The carrier sense multiple access with collision detection (CSMA-CD) protocol cannot be applied directly to radio channels because of the difficulty in sensing remote carrier in the presence of local transmission. Only recently, a new protocol called the CSMA with timesplit collision detection (CSMA-TCD) was introduced to overcome this problem on radio channels. This paper presents an extension of the CSMA-TCD protocol, called CSMA-TCD with multitone tree search (CSMA-TCD-MTTS). In CSMA-TCD, a preamble is transmitted before data transmission. For CSMA-TCD-MTTS, the preamble is modulated with one out ofNtones. In case of a collision, a resolution algorithm splits the terminals involved into anN-degree tree according to the tone chosen. This paper presents the throughput and approximate delay analysis of the CSMA-TCD-MTTS protocol.     

Front Cover

In this paper, the authors present the results of experiments which clearly demonstrate a technical basis confirming that the carrier frequency harmonics data can be used for diagnostics relative to motor stator insulation degradation.     

MetaModel: a program for modelling and control analysis of metabolic pathways on the IBM PC and compatibles

MetaModel is a user-friendly program for calculating steady-state fluxes and metabolite concentrations of metabolic systems on the IBM PC and compatible computers. For any steady state that is obtained, one can then calculate a matrix of elasticity coefficients at that steady state, or a matrix of control and response coefficients. It thus offers a simple way to calculate the control structure of a pathway: it provides not only an educational tool that allows the student to verify empirically the classic summation relationships of metabolic control analysis but also a research tool for addressing 'what if?' questions about the behaviour of metabolic systems. Results can not only be printed or stored in a file, but can also be written to a special file that can be read by popular spreadsheet programs, thereby giving access to rapid, flexible and powerful methods for subsequent analysis and plotting of these results.     

Anfangsvorgänge bei Lichtenbergschen Figuren

Zusammenfassung Aufnahmen von Lichtenbergschen Figuren mit kurzen Spannungsstößen zeigen, daß bisher bekanntgewordene Bilder solcher Entladungsfiguren bereits ein verhältnismäßig weit vorgeschrittenes Stadium darstellen. Es gelingt mittels kurzer Stöße erste lawinenartige Anfänge der Figuren festzuhalten und einiges über Vorgänge im Anfangsstadium herauszulesen. Die negative Figur beginnt lawinenförmig an bevorzugten Stellen der Kathode. Bei nebeneinander entstandenen Lawinen ist sehr gut die gegenseitige Abstoßung infolge gleicher Ladung zu beobachten. Die Entladung hat einen geschichteten Aufbau. Die positiven Figuren bilden sich später aus. Es sprechen jedoch bisher keinerlei Anzeichen für ein Hinwachsen der Fäden zur Anode. Die Kanäle verjüngen sich zur Anode hin und selbst bei kurzen Stoßzeiten endet kein einziger vor der Anode. Auch die Art der gegenseitigen Abstoßung der positiven Fäden spricht mehr für ein Vorwachsen von der Anode aus. Aus den Farbaufnahmen ergibt sich für die filmschwärzende Strahlung eine Wellenlänge unter 450 m.