低插损窄带型10.7MHz压电陶瓷滤波器的研制

介绍了低插损窄带型10.7 MHz压电陶瓷滤波器的一种设计制作方法。结合压电陶瓷能陷模理论,通过对滤波器分割电极设计和制造工艺控制技术的研究,强调了工艺控制的重要性。产品达到日本村田同类产品水平,对国产化窄带型10.7 MHz压电陶瓷滤波器的研发和生产具有十分重要的意义。认为选用高Qm值压电陶瓷材料、分割电极和耦合电容的设计、焊接和点蜡工艺的控制等是研制低插损窄带型10.7 MHz压电陶瓷滤波器的重点。     

平面阵列波导光栅波导模式参量的分析

用周期波导的方法分析平面阵列波导光栅(AWG)的本征方程及波导模式参数,结果表明波导传播常数是带状分布的,与波导间隔有关。分析结果对器件的优化设计有一定的指导意义。     

Ru/MCM-41催化剂上苯的液相加氢反应

 以Si-MCM-41、Al-MCM-41(1) (n(Si)/n(Al)=15)、Al-MCM-41(2) (n(Si)/n(Al)=10)以及用NH4NO3或HAc的醇溶液分别与Si-MCM-41离子交换所得的H-MCM-41(N)和H-MCM-41(H)为载体制备了系列Ru/MCM-41催化剂。采用N2吸附、XRD和H2-TPR表征了负载Ru前后催化剂的结构及Ru在各种载体表面上的分散状态。以0.5%（质量分数）苯的环己烷溶液为模型化合物，在298K、3.0MPa反应条件下，考察了上述催化剂的苯液相加氢反应性能，并与Ru/HY、Ru/H和Pt/MCM-41催化剂进行了比较。结果表明，载体MCM-41的n(Si)/n(Al)和表面化学组成等性质对Ru在其表面上的分散状态、还原性及催化性能均有影响。对苯的转化率与反应时间的关系曲线进行拟合，发现其遵循一级动力学方程，加氢反应速率常数按照Ru/Al-MCM-41(2)相似文献   

同沉积压扭断层在柴达木盆地西部南区油气成藏中的意义

柴达木盆地西部南区逆断层断面产状呈上陡下缓的铲式特征,生长系数变化在1.3~2.5之间,断距纵向上向浅层逐渐变小和横向上向一个方向逐渐增大,总体表现为典型的同沉积压扭断层。指出该断层演化主要经历了同生冲断期、褶皱发育期、平静期及二次活动期4个阶段,长期活动的NWW向主干断层除控制构造带的展布格局外,还控制着烃源岩、储集层、盖层及其组合的空间发育,同时还有效地沟通着源岩与圈闭并成为有效输导体系的一部分,近N S向展布的次级断层决定着局部构造的发育特点,与NWW向断层联合控制着油气的局部富集。     

Optimal Block Design for Asynchronous Wake-Up Schedules and Its Applications in Multihop Wireless Networks

In this paper, we consider the problem of designing optimal asynchronous wake-up schedules to facilitate distributed power management and neighbor discovery in multihop wireless networks. We first formulate it as a block design problem and derive the fundamental trade-offs between wake-up latency and the average duty cycle of a node. After the theoretical foundation is laid, we then devise a neighbor discovery and schedule bookkeeping protocol that can operate on the optimal wake-up schedule derived. To demonstrate the usefulness of asynchronous wake-up, we investigate the efficiency of neighbor discovery and the application of on-demand power management, which overlays a desirable communication schedule over the wake-up schedule mandated by the asynchronous wake-up mechanism. Simulation studies demonstrate that the proposed asynchronous wake-up protocol has short discovery time which scales with the density of the network; it can accommodate various traffic characteristics and loads to achieve an energy savings that can be as high as 70 percent, while the packet delivery ratio is comparable to that without power management.     

SO4^2-／ZrO2固体超强酸的制备及其催化合成ETBE的研究

采用沉淀一浸渍法制备了负载型SO4^2-／ZrO2固体超强酸催化剂，运用IR、XRD等方法表征所制备催化剂的物化性质。结果表明，所制备的催化剂具有固体超强酸催化剂的特征，酸性与焙烧温度有关，适当提高焙烧温度有利于样品酸强度的提高，但焙烧温度过高会导致脱硫；浸渍液H2SO4浓度高有利于提高催化剂的硫含量，但是浓度过高，会在催化剂上形成硫酸盐，从而降低催化剂的比表面积和酸性。采用制备的催化剂气相催化乙醇与叔丁醇合成乙基叔丁基醚反应，乙基叔丁基醚的选择性为54．71％。     

关于加强监理单位对监理机构管理的探讨

监理机构是监理单位向业主提供工程项目管理服务的现场机构。监理单位可以通过建立和健全监理机构管理制度、加强对其监控和考核等方法，达到提高监理机构的现场服务质量、增加业主满意的目的。     

固体铝电解电容器用导电高分子制备工艺进展

依据近年的相关专利,综述了用于固体铝电解电容器的导电高分子的最新制备工艺,介绍了导电高分子固体铝电解电容器的结构,详细描述了制备导电高分子的两种主要方法——化学聚合和电化学聚合——及其进展历程。介绍了新颖掺杂剂的发现与使用,对各种工艺的特点进行了评述。     

Ni-Al2O3纳米复合电镀工艺的初步研究

初步研究了复合电镀各工艺条件：电流密度、镀液pH值和温度以及搅拌方式对Al2O3纳米微粒在镍基复合镀层中含量的影响。研究表明：电流密度增大不利于提高镀层中纳米微粒的含量；pH值增大也明显使复合量降低;镀液温度升高，镀层中微粒的复合量随之略有改变；电镀时，加强搅拌或适当改变搅拌方式，可以使复合镀居中的纳米微粒含量提高。还利用扫描电镜及能谱对Ni-Al2O3镀层表面进行了观察与分析。     

Oxidation of Hastelloy-XR Alloy for Corrosion-Resistant Glass-Coating

The oxidation behavior of Hastelloy-XR alloy was investigated to obtain the optimum surface condition for corrosion-resistant glass-coatings. The surface morphology of oxide scales changed significantly with variation of temperatureand oxygen partial pressure (po2 ). The oxidation kinetics was mainly parabolic independent of oxidation conditions.The oxide scales were consisted of inner Cr2O3 and outer spinel layers. The phase component of spinel layers wereMn1.5Cr1.5O4 and (Mn,Ni)(Cr,Fe)2O4 for the oxygen partial pressures po2<10 kPa and po2>10 kPa, respectively.The optimum oxidation condition to obtain an oxide scale for well-adhered glass-coating to the substrate was 1248 Kand po2 =0.01 kPa for the oxidation time of 43 ks.