Bone grafts to the nose in Binder's syndrome (maxillonasal dysplasia): a follow-up of eleven patients with the use of profile roentgenograms

Bone grafts are used to lengthen the dorsum and elevate the tip of the nose in patients with Binder's syndrome. Disappointing long-term results in some patients generally have been assumed to be a result of resorption and/or displacement of the grafts. Treatment outcome was studied in 11 patients with the use of serial profile roentgenograms. At 40 months, the mean values after surgery were reduction of the initial transplant length by 28 percent and reduction of the transplant angle by 4 degrees. The initial nose length was increased by 1 mm, and nose tip projection was increased by 2 mm. Although the mean changes of nose length and nose tip projection seemed small, treatment outcome varied considerably between patients. In contrast with earlier assumptions, no correlation could be found between the degree of transplant resorption and/or displacement and the effect of surgery on nose length and nose tip projection.     

Comparison of a contactor catalytic membrane reactor with a conventional reactor: example of wet air oxidation

A wet air oxidation reaction was carried out in a gas/liquid catalytic membrane reactor of the contactor type. The oxidation of formic acid was used as a model reaction. The mesoporous top-layer of a ceramic tubular membrane was used as catalyst (Pt) support, and was placed at the interface of the gas (air) and liquid (HCOOH solution) phases.

A similar reaction was carried out in a conventional batch reactor, using a steering rate high enough to avoid gas-diffusion limitations, and exactly identical conditions than for the CMR (amount of catalyst, pressure, etc.). At room temperature, the CMR showed an initial activity three to six times higher than the conventional reactor. This activity increase was attributed to an easier oxygen access to the catalytic sites. Nevertheless, the catalytic membrane gradually deactivated after a few hours of operation. Different deactivation mechanisms are presented.     

Experimentelle Ermittlung von Bauteilbelastungen eines Power Tool Antriebsstrangs durch indirektes Messen in realitätsnahen Anwendungen als ein Baustein in der Teilsystemvalidierung

This article shows by experimental studies on angle grinders, how application-equivalent stresses on the components can be determined. For this purpose a distance measurement technique is applied with which the movement of the shaft is detected while the angle grinder is in operation. The research results support validation activities in product development and contribute to early validation. It helps to analyzing the dynamic and working life of the power tool and therefore construction targets are derived. The related applications are considered and power tools with measuring equipment in the lab are tested. The measurement results are presented and possible causes and effects on the life of the components are discussed. With the method of investigation it is possible to study the behavior of subsystems already in development phases in which the overall system is not physically present.     

Automated extraction of DNA from blood and PCR setup using a Tecan Freedom EVO liquid handler for forensic genetic STR typing of reference samples

We have implemented and validated automated protocols for DNA extraction and PCR setup using a Tecan Freedom EVO liquid handler mounted with the Te-MagS magnetic separation device (Tecan, M?nnedorf, Switzerland). The protocols were validated for accredited forensic genetic work according to ISO 17025 using the Qiagen MagAttract DNA Mini M48 kit (Qiagen GmbH, Hilden, Germany) from fresh whole blood and blood from deceased individuals. The workflow was simplified by returning the DNA extracts to the original tubes minimizing the risk of misplacing samples. The tubes that originally contained the samples were washed with MilliQ water before the return of the DNA extracts. The PCR was setup in 96-well microtiter plates. The methods were validated for the kits: AmpF?STR Identifiler, SGM Plus and Yfiler (Applied Biosystems, Foster City, CA), GenePrint FFFL and PowerPlex Y (Promega, Madison, WI). The automated protocols allowed for extraction and addition of PCR master mix of 96 samples within 3.5h. In conclusion, we demonstrated that (1) DNA extraction with magnetic beads and (2) PCR setup for accredited, forensic genetic short tandem repeat typing can be implemented on a simple automated liquid handler leading to the reduction of manual work, and increased quality and throughput.     

Spacecraft formation reconfiguration with collision avoidance

In this paper we present a behavioral control solution for reconfiguration of a spacecraft formation using the Null-Space Based (NSB) concept. The solution is task based, and aims to reconfigure and maintain a rigid formation while avoiding collisions between spacecraft. A model of relative translation is derived, together with a passivity-based sliding surface controller which globally stabilizes the equilibrium point of the closed-loop system. The NSB control method is implemented by giving each task different priorities and then calculating desired velocity and a Jacobian matrix for each spacecraft and each task. The velocity vector for each task is then projected into the null-space for higher prioritized tasks to remove conflicting velocity components. Simulation results are presented, showing that each spacecraft moves into the predefined formation without breaking any rules for the higher priority tasks, and all collisions are avoided.     

Trace Elements in the Si Furnace-Part II: Analysis of Condensate in Carbothermal Reduction of Quartz

Silicon feedstock for production of solar-grade silicon should be as pure as possible to decrease the cost of manufacturing of solar cells. Impurities in quartz, carbonaceous materials, electrodes, and refractories are mostly present in the form of oxides. These oxides can be reduced to volatile gaseous compounds in presence of SiO(g) and CO(g) atmosphere and potentially leave the furnace or stay in the condensed reaction products, metal, and slag. This work investigates the conditions under which volatile impurities report to the gas phase in laboratory experiments with lumpy and pelletized mixtures of SiO₂, SiC, and Si at 1923 K and 2123 K (1650 °C and 1850 °C), respectively, were carried out. The volatile compounds were generated by the reduction of quartz and collected in the form of condensate. The effects of the reaction temperature, quartz type, charge composition, pellets, and lumps on the composition of the condensate were studied. The trace elements in the charge input, reacting charge, and condensate were analyzed using inductively coupled plasma (ICP)-mass spectroscopy (MS) and X-ray diffraction (XRD). CO(g) and SiO(g), which are the major components in reduction reactions, formed four types of condensate: white, brown, green, and orange. The condensate constituents were amorphous SiO₂, 3C:SiC, Si, and α-quartz. Each impurity present in the quartz charge entered the gas phase during quartz reduction and was detected in the condensate. Al and Fe show limited volatility. The volatility of Mn, P, and B depends on the charge mix: a higher P_CO enhances the concentration of these elements in the gas phase. Fluid inclusions, common in hydrothermal quartz, enhance the distribution of the contaminants to the gas phase. Industrial campaigns on Si and Fe-Si production confirm the experimental results.     

Enhanced O2 Flux of CaTi0.85Fe0.15O3−δ Based Membranes by Mn Doping

Dense symmetric membranes of CaTi_0.85?xFe_0.15Mn_xO_3?δ (x = 0.1, 0.15, 0.25, 0.4) are investigated in order to determine the optimal Mn dopant content with respect to highest O₂ flux. O₂ permeation measurements are performed as function of temperature between 700°C–1000°C and as function of the feed side ranging between 0.01 and 1 bar. X‐ray photoelectron spectroscopy is utilized to elucidate the charge state of Mn, and synchrotron radiation X‐ray powder diffraction (SR‐XPD) is employed to investigate the structure symmetry and cell volume of the perovskite phase at temperatures up to 800°C. The highest O₂ permeability is found for x = 0.25 over the whole temperature and ranges, followed by x = 0.4 above 850°C. The O₂ permeability for x = 0.25 reaches 0.01 mL(STP) min^?1 cm^?1 at 925°C with 0.21 bar feed side and Ar sweep gas. X‐ray photoelectron spectroscopy indicates that the charge state of Mn changes from approx. +3 to +4 when x > 0.1, which implies that Mn mainly improves electronic conductivity for x > 0.1. The cell volume is found to decrease linearly with Mn content, which coincides with an increase in the activation energy of O₂ permeability. These results are consistent with the interpretation of the temperature and dependency of O₂ permeation. The sintering behavior and thermal expansion properties are investigated by dilatometry, which show improved sinterability with increasing Mn content and that the thermal expansion coefficient decreases from 12.4 to 11.9 × 10^?6 K^?1 for x = 0 and x = 0.25, respectively.     

Classification of Amyloidosis by Model-Assisted Mass Spectrometry-Based Proteomics

Amyloidosis is a rare disease caused by the misfolding and extracellular aggregation of proteins as insoluble fibrillary deposits localized either in specific organs or systemically throughout the body. The organ targeted and the disease progression and outcome is highly dependent on the specific fibril-forming protein, and its accurate identification is essential to the choice of treatment. Mass spectrometry-based proteomics has become the method of choice for the identification of the amyloidogenic protein. Regrettably, this identification relies on manual and subjective interpretation of mass spectrometry data by an expert, which is undesirable and may bias diagnosis. To circumvent this, we developed a statistical model-assisted method for the unbiased identification of amyloid-containing biopsies and amyloidosis subtyping. Based on data from mass spectrometric analysis of amyloid-containing biopsies and corresponding controls. A Boruta method applied on a random forest classifier was applied to proteomics data obtained from the mass spectrometric analysis of 75 laser dissected Congo Red positive amyloid-containing biopsies and 78 Congo Red negative biopsies to identify novel “amyloid signature” proteins that included clusterin, fibulin-1, vitronectin complement component C9 and also three collagen proteins, as well as the well-known amyloid signature proteins apolipoprotein E, apolipoprotein A4, and serum amyloid P. A SVM learning algorithm were trained on the mass spectrometry data from the analysis of the 75 amyloid-containing biopsies and 78 amyloid-negative control biopsies. The trained algorithm performed superior in the discrimination of amyloid-containing biopsies from controls, with an accuracy of 1.0 when applied to a blinded mass spectrometry validation data set of 103 prospectively collected amyloid-containing biopsies. Moreover, our method successfully classified amyloidosis patients according to the subtype in 102 out of 103 blinded cases. Collectively, our model-assisted approach identified novel amyloid-associated proteins and demonstrated the use of mass spectrometry-based data in clinical diagnostics of disease by the unbiased and reliable model-assisted classification of amyloid deposits and of the specific amyloid subtype.     

Chemical characterization of 21 species of marine macroalgae common in Norwegian waters: benefits of and limitations to their potential use in food and feed

BACKGROUND

In the past few years, much effort has been invested into developing a new blue economy based on harvesting, cultivating and processing marine macroalgae in Norway. Macroalgae have high potential for a wide range of applications, e.g. as source of pharmaceuticals, production of biofuels or as food and feed. However, data on the chemical composition of macroalgae from Norwegian waters are scant. This study was designed to characterize the chemical composition of 21 algal species. Both macro‐ and micronutrients were analysed. Concentrations of heavy metals and the metalloid arsenic in the algae were also quantified.

RESULTS

The results confirm that marine macroalgae contain nutrients which are relevant for both human and animal nutrition, the concentrations whereof are highly dependent on species. Although heavy metals and arsenic were detected in the algae studied, concentrations were mostly below maximum allowed levels set by food and feed legislation in the EU.

CONCLUSION

This study provides chemical data on a wide range of algal species covering the three taxonomic groups (brown, red and green algae) and discusses both benefits of and potential limitations to their use for food and feed purposes. © 2017 The Authors. Journal of The Science of Food and Agriculture published by John Wiley & Sons Ltd on behalf of Society of Chemical Industry.     

Coffee and cancer risk,epidemiological evidence,and molecular mechanisms

Although early studies suggested that coffee consumption might increase risk of some cancers, more comprehensive epidemiological and experimental data now generally indicate either neutral or beneficial effects. In this review, we summarize the current evidence for associations between breast, prostate, colorectal, and liver cancers and the consumption of coffee, and discuss the experimental evidence for potential chemopreventive mechanisms of coffee and coffee constituents. The epidemiological evidence consistently indicates that coffee protects against liver cancer, and also point toward protective effects for risk of colorectal cancers (with relative risks of 0.50 (95% CI: 0.42–0.59) and 0.83 (95% CI: 0.75–0.92), respectively, in the most recent meta‐analyses). There seems to be no association between the overall risk of breast and prostate cancer and coffee intake. However, for subgroups such as postmenopausal breast cancers, advanced prostate cancers, and breast and prostate cancer survivors, an inverse association with coffee intake is indicated. Potential mechanisms for chemopreventive effects of coffee phytochemicals includes inhibition of oxidative stress and oxidative damage, regulation of DNA repair, phase II enzymatic activity, apoptosis, inflammation, as well as having antiproliferative, antiangiogenetic effects and antimetastatic effects. The experimental evidence for effects of coffee and coffee constituents on each of these processes is discussed.