Evaluation of method for simultaneous determination of pesticide residues in fruits and vegetables by collaborative study

A collaborative study involving 8 laboratories was conducted to evaluate a method for the simultaneous determination of pesticide residues in 6 types of fruits and vegetables (spinach, tomato, apple, radish, cabbage and carrot). The method of analysis was the same as reported by Kakimoto et al. in 2003. One hundred and thirty-nine pesticides were spiked by each of 8 laboratories at levels of 0.1 microg/g (pesticides analyzed by GC/MS) or 0.5 microg/g (pesticides analyzed by HPLC) into the 6 kinds of samples. Statistical analysis showed that 111 pesticides could be analyzed with practical precision by this method. For screening purposes, the method could analyze 118 pesticides. The median values of the limits of detection were 0.001-0.041 microg/g. The calibration curves were linear in the range of 0.5-5 microg/mL for most pesticides with median correlation coefficients of 0.983-1.000.     

A numerical analysis of two-dimensional flow past a rectangular prism by a discrete vortex model

A discrete vortex model is developed to analyse the two-dimensional fully separated unsteady flow past a rectangular prism. The effects of viscous diffusion of vortices and the loss in vorticity after the stationary prism with a thickness ratio ranging from 0.5 to 2.0. The formation of Karman vortices, the vortex shedding frequency, and the fluid forces acting on the body are favourably compared with the experimental results by various research workers. The method of analysis is also shown to be applicable to the flow past a prism that is in forced vibration.     

Characterization of the chemical conversion films that form on Mg−Al alloy in colloidal silica solution

Chemical conversion treatment of Mg−Al alloy (AZ91) using colloidal silica as an alternative to chromate conversion was investigated as a function of solution pH, temperature, solution conditions, and treatment time. The solution used for the colloidal silica coating consisted of colloidal silica, titanium sulfate, and cobalt ions to maintain good anti-corrosion and adhesion properties. Adding CoSO₄ to the colloidal silica solution enhanced the adhesion force between the silica film and magnesium substrate. The optimum conditions for the chemical conversion treatment solution were pH 2, 90-sec treatment, and 25°C.     

Effects of rice cleaning and cooking process on the residues of flutolanil,fenobucarb, silafluofen and buprofezin in rice

We studied the effect of cleaning and cooking on the residues of flutolanil, fenobucarb, silafluofen and buprofezin in rice. The rice had been sprayed in a paddy field in Wakayama city, with 3 kinds of pesticide application protocols: spraying once at the usual concentration of pesticides, repeated spraying (3 times) with the usual concentration of pesticides and spraying once with 3 times the usual concentration of pesticides. The residue levels of pesticide decreased during the rice cleaning process. Silafluofen, which has a higher log Pow value, remained in the hull of the rice. Fenobucarb, which has a lower log Pow value, penetrated inside the rice. The residue concentration of pesticide in polished rice was higher than that in pre-washed rice processed ready for cooking. During the cooking procedure, the reduction of pesticides in polished rice was higher than that in brown rice.     

Characterization of polymer-adhesive interfaces on a nanometre scale by elemental mapping and image EELS using EFTEM

Energy-filtering transmission electron microscopy (EFTEM) was applied for investigating interfaces between a polymer and an adhesive. The sample employed in this work is polybutylene terephtharate (PBT) sheets laminated with an epoxy adhesive. It was found that heat aging of the PBT at 180 degrees C in air for > 9 h prior to adhesion decreases the adhesion strength drastically. To investigate this unfavourable aging effect on the adhesion strength, we performed elemental mapping and image EELS using EFTEM. A weak boundary layer with a thickness of < 50 nm was visualized at the PBT-adhesive interface by elemental mapping in the sample subjected to the heat aging and image EELS revealed the origin of this layer. Thus, we clearly correlated the nanoscale interfacial structure with the adhesion strength by EFTEM.     

Anisotropic proton-conducting membranes prepared from swift heavy ion-beam irradiated ETFE films

Poly(ethylene-co-tetrafluoroethylene) (ETFE) films were irradiated by swift heavy ion-beams of ¹²⁹Xe²³⁺ with fluences of 0, 3 × 10⁶, 3 × 10⁷, 3 × 10⁸ and 3 × 10⁹ ions/cm², followed by γ-ray pre-irradiation for radiation grafting of styrene onto the ETFE films and sulfonation of the grafted ETFE films to prepare highly anisotropic proton-conducting membranes. The fluence of Xe ions and the addition of water in the grafting solvent were examined to determine their effect on the proton conductivity of the resultant membranes. It was found that the polymer electrolyte membrane prepared by grafting the styrene monomer in a mixture of 67% isopropanol and 33% water to the ETFE film with an ion-beam irradiation fluence of 3.0 × 10⁶ ions/cm² was a highly anisotropic proton-conducting material, as the proton conductivity was three or more times higher in the thickness direction than in the surface direction of the membrane.     

Confined‐error‐diffusion algorithm for flat‐panel display

Abstract— The reduction of a structural pattern at specific gray levels caused by digital halftone methods is the subject of this paper. This problem is more severe in some flat‐panel displays because their black levels typically are brighter than other display blocks. A patented halftone algorithm, confined error diffusion (CED), that confines the error‐carry within the dither mask is described and extended. First, the CED algorithm that dynamically applies random error diffusion or the ordered‐dither method, depending upon image content, is described in detail. Finally, we propose an advanced CED algorithm for improving the gradation characteristics of the CED algorithm. The performance of the proposed algorithms is compared to the experimental results for natural test images. In order to verify the halftone quality, a structural similarity measure for color images by taking into account the interrelation between color channels is proposed, and the results based on the proposed method, the color similarity measure method, is given.     

A New Model of Learning

Abstract

Most learning machines are of a single type. Input patterns are transformed into some other patterns by a processor then classified by a discriminant function. Such machines are considered to offer poor information processing capability. This paper proposes a new and unusual model of learning. In conventional machines only the classification of input patterns is learned; however, the new model can memorize the input patterns themselves in the learning, that is, an input pattern appears as an output if it has been seen sufficiently often. Basic to the formulation of the new model are the multiplexing of local processing and the use of connections which operate on a manner similar to presynaptic inhibition.     

Adsorption properties of amphiphilic polyoxyalkylenated dimethylpolysiloxane derivatives on keratin

Adsorption properties of two types of dimethylpolysiloxane backbone derivatives, perfluoroalkyl polyoxyethylenated dimethylpolysiloxane (FPD) and polyoxyethylenated dimethylpolysiloxane (PD), onto keratin surfaces were investigated. Both polymers are amphiphilic, since they possess hydrophilic polyoxyethylene groups. FPD contains a perfluoroalkyl group that provides both water-and oil-repellent properties, whereas PD lacks these groups. Adsorption properties of these polymers onto keratin surfaces are considered a good index to evaluate these compounds as nonionics used in hair-coating agents, since keratin is a major component of hair. FPD was more likely to be adsorbed and less likely to be eliminated from the keratin surface than PD. Once FPD had been adsorbed onto the keratin surface, it was very slowly washed from the surface when it was immersed in stationary water, whereas PD polymers were quickly washed from the keratin surface. Even in running water, rapid elimination of FPD was not observed. The strong resistance to loss of FPD after washing with a large quantity of water may be due to the water-repellent nature of the perfluoroalkyl groups. As a comparison, FPD adsorption onto a glass surface was also investigated. The affinity to the glass surface was found to be less than to the keratin surface.