On a Distributed Cognitive MAC Protocol for IEEE 802.11s Wireless Mesh Networks

A distributed frequency agile medium access control (MAC) extension to the IEEE 802.11s for the next generation wireless mesh networks is proposed. The introduced protocol enhancements are capable of concurrent deployment of existing frequency opportunities in order to coordinate simultaneous data transmissions. The root concept is mainly based on the deployment of well-known ISM frequency bands, where the legacy 802.11-based wireless equipments operate, as the common control channel in order to establish contemporaneous transmissions. We apply the aforementioned key concept to the IEEE 802.11s common channel framework to attain two important goals: To improve the channel utilization using the concept of cognitive radio, and to lower the access delay. Through extensive event-driven simulations, taking into account primary user appearance in non-ISM frequency bands, performance of the proposed MAC enhancement is evaluated showing its higher efficiency compared to the existing solutions, in addition to its better wireless medium management.     

Optical properties of photoluminescent polycrystalline CuLa0.98Eu0.02O2 thin film prepared by pulsed laser deposition at room temperature

Smooth CuLa_0.98Eu_0.02O₂ thin film has successfully been prepared by pulsed laser deposition method at room temperature. Crystal structure of the obtained film was almost same as that of CuLa_0.98Eu_0.02O₂ polycrystalline ceramic. Orange luminescence with high intensity due to ⁵D₀ – ⁷F_0,1 transitions of Eu³⁺, which was an evidence of Eu³⁺ substitution for La³⁺ site in LaO₆ octahedra with the inversion symmetry, was also observed in the obtained film. The optical band gap of CuLa_0.98Eu_0.02O₂ was measured to be 2.85 eV from absorption spectroscopy.     

Surface Waves on Superfluid <Superscript>4</Superscript>He Under Reduced Gravity

Superfluid ⁴He was produced on a small jet plane for the first time using a small GM-refrigerator to condense the liquid and a scroll pump to get the superfluid by evaporation. The surface wave on superfluid under 0.5g _E, 0.1g _E and 0.05g _E, together with 2g _E and 1g _E, was successfully examined by an optical method utilizing parabolic flight. Here, g _E is the gravitational constant on the ground. Assuming that only the fundamental mode was excited as determined by the sample cell width, the resonance peak in the frequency domain was well reproduced by the gravity wave with corresponding gravity constant.     

Fabrication of 80 mm diameter-sized solid oxide fuel cells using a water-based NiO–YSZ slurry

Solid oxide fuel cells (SOFCs) are very attractive for their high energy conversion efficiency and low emissions. Generally, a supported layer of SOFCs is fabricated by tape casting, using an organic solvent. Recently, a slurry based on water instead of an organic solvent has been sought in order to avoid environmental pollution. In this study, the anode of SOFCs was fabricated by aqueous tape casting, and the electrolyte and the cathode were deposited by screen printing. The I–V characteristics of the cell thus obtained were evaluated. As a result, an 80 mm diameter-sized cell with a power density of 0.33 W/cm² at 800 °C was successfully fabricated by controlling sintering conditions.     

Condensation of organic binary mixtures flowing horizontally in a horizontal tube bundle

Both heat and mass transfer in the gas phase and heat transfer in the liquid phase are examined experimentally for film condensation of organic binary mixtures such as ethanol-water and methanol-water. Experimental results on the average heat flux, vapor-liquid interface temperature and liquid-phase Nusselt number are compared with analytical solutions based on stagnant film theory and heat-transfer relationships for film condensation from a pure vapor. Experimental heat transfer results agree well with the analytical solutions, except that the experimental liquid-phase Nusselt numbers under conditions of low mass fraction of water are considerably higher than predicted by the analytical solutions. This high value of the liquid-phase Nusselt number is considered to be caused by dropwise condensation in the liquid phase. However, its effect on the tube bundle is not so remarkable compared with that in gravity-controlled condensation on a vertical surface. This is considered to be caused by the condensate inundation effect. © 1997 Scripta Technica, Inc. Heat Trans Jpn Res, 25(6): 342–361, 1996     

Serum Amyloid A3 Promoter-Driven Luciferase Activity Enables Visualization of Diabetic Kidney Disease

The early detection of diabetic nephropathy (DN) in mice is necessary for the development of drugs and functional foods. The purpose of this study was to identify genes that are significantly upregulated in the early stage of DN progression and develop a novel model to non-invasively monitor disease progression within living animals using in vivo imaging technology. Streptozotocin (STZ) treatment has been widely used as a DN model; however, it also exhibits direct cytotoxicity to the kidneys. As it is important to distinguish between DN-related and STZ-induced nephropathy, in this study, we compared renal responses induced by the diabetic milieu with two types of STZ models: multiple low-dose STZ injections with a high-fat diet and two moderate-dose STZ injections to induce DN. We found 221 genes whose expression was significantly altered during DN development in both models and identified serum amyloid A3 (Saa3) as a candidate gene. Next, we applied the Saa3 promoter-driven luciferase reporter (Saa3-promoter luc mice) to these two STZ models and performed in vivo bioluminescent imaging to monitor the progression of renal pathology. In this study, to further exclude the possibility that the in vivo bioluminescence signal is related to renal cytotoxicity by STZ treatment, we injected insulin into Saa3-promoter luc mice and showed that insulin treatment could downregulate renal inflammatory responses with a decreased signal intensity of in vivo bioluminescence imaging. These results strongly suggest that Saa3 promoter activity is a potent non-invasive indicator that can be used to monitor DN progression and explore therapeutic agents and functional foods.     

Compositional Dependence of Normal Spectral Emissivity of Molten Cu-Fe Alloy

Metallurgical and Materials Transactions B - Normal spectral emissivity of molten Cu-Fe alloy with different compositions was measured at the wavelength of 807&nbsp;nm using an electromagnetic...     

Steam reforming on Ni-samaria-doped ceria cermet anode for practical size solid oxide fuel cell at intermediate temperatures

Direct internal and external reforming operations on Ni-samaria-doped ceria (SDC) anode with the practical size solid oxide fuel cell (SOFC) at intermediate temperatures from 600 to 750 °C are carried out to reveal the reforming activities and the electrochemical activities, being compared with the hydrogen-fueled power generation. The cell performance with direct internal and external steam reforming of methane and their limiting current densities were almost the same irrespective of the progress of reaction in the methane reformate at 700 and 750 °C. The durability test for 5.5 h at 750 °C with direct internal reforming operation confirmed that the cell performance did not deteriorate. The operation temperature of the cell controlled the reforming activities on the anode, and the large size electrode gave rise to high conversion due to the slow space velocity of the steam reforming. Direct internal steam reforming attained sufficient level of conversion for SOFC power generation with methane at 700 and 750 °C on the large Ni-SDC cermet anode.     

What is the significance of nitrogen-vacancy centers in the doping into diamond?

In order to advance quantum computer after successful synthesis of a qubit (quantum-bit) using a NV (nitrogen-vacancy) center in diamond crystal, the innovation of a NOT processor is strongly demanded. A candidate of it can be one NV center associated with an additional N atom, which is called a NV–N center. Making use of a classical molecular dynamics simulation of N ion implantation into pure diamond with an energy of 200 eV, we have examined the crystallographic structure of “NV–N” centers. However, at low temperature of 30 K, most implanted N atoms became interstitials, thus it was difficult to identify even NV centers.