a-Si alloy three-stacked solar cells with high stabilized-efficiency

a-Si alloy three-stacked solar cells have been studied to improve the stabilized efficiency of a-Si: H based solar cells. Based on the analysis by the individual characterization method of the component cells in stacked type cells, the a-Si :H middle cell was replaced with an a-SiGe :H cell. Furthermore, the optical confinement technology was improved to obtain a high-output current with thin i-layer thickness in the a-SiGe :H bottom cell. By this device design, the initial conversion efficiency was improved up to 12.4% and more than a 10% stabilized efficiency was obtained in a-SiC :H/a-SiGe :H/a-SiGe :H three-stacked cells. These cell characteristics were confirmed by measurements at the JQA Organization (the former JMI Institute).     

Area- and time-specific marginal capacity costs of electricity distribution

Marginal costs of electricity vary by time and location. In the past, researchers attributed the variations to factors related to electricity generation and transmission. These authors, however, have not analyzed possible variations in marginal distribution capacity costs (MDCC). The objectives of this paper are:

1. (i) to show that large MDCC variations are due to the dispersion in distribution capital expenditures by time and space,

2. (ii) to propose a method for quantifying the area- and time-specific MDCC in the presence of lumpy investments, and

3. (iii) to compare our MDCC estimates to those commonly used in the electric utility industry.

Our proposed method and its results were adopted by the California Public Utilities Commission (CPUC) in 1992 for Pacific Gas and Electric Company (PG&E), the largest privately owned electric utility in the U.S.     

Duration of spinal anaesthesia is determined by the partition coefficient of local anaesthetic

We have compared the duration of motor block produced by four local anaesthetics administered into a chronically implanted subarachnoid catheter in rabbits. Each group (n = 6) received four different doses of amethocaine, bupivacaine, lignocaine or procaine, and the duration of the resulting motor block was assessed. Dose-response curves were plotted for each drug. As a measure of activity of the anaesthetics, we used the dose of each drug required to produce block of 60-min duration (D60 min) and the correlation between D60 min and different drug properties was examined. An inverse linear correlation (r = 0.995; P < 0.01) was observed between log D60 min and the log of the partition coefficient of the local anaesthetics. No correlation was found between the effect and degree of protein binding, pKa or molecular weight. These results suggest that, in spinal anaesthesia, the partition coefficient could be used as a predictor of the duration of anaesthetic action.     

Resonance assignment of methionine methyl groups and chi 3 angular information from long-range proton-carbon and carbon-carbon J correlation in a calmodulin-peptide complex

Several simple 3D experiments are used to provide J correlations between methionine C epsilon methyl carbons and either the C gamma H2 protons or C beta and C gamma. The intensity of the J correlations provides information on the size of the three-bond J couplings and thereby on the chi 3 torsion angle. In addition, a simple 3D version of the HMBC experiment provides a sensitive link between the C epsilon H3 methyl protons and C gamma. The methods are demonstrated for a 20 kDa complex between calmodulin and a 26-residue peptide fragment of skeletal muscle myosin light chain kinase.     

Aortic valve papillary fibroelastoma. A diagnosis by transthoracic echocardiography

Cardiac papillary fibroelastomas are unusual, frond-like growths typically found on cardiac valves, diagnosed incidentally on autopsy or cardiac surgery, but rarely during life. We report a rare case of an aortic valve papillary fibroelastoma detected by transthoracic echocardiography and confirmed by histologic study.     

Ubiquitin expression in inclusion body myositis. An immunohistochemical study

Ubiquitin has been shown by immunohistochemical studies to be a component of many of the filamentous inclusion bodies that are known in neuropathology. In the current study, we examined the expression of ubiquitin in 14 cases of typical inclusion body myositis, in skeletal muscle specimens from four cases of typical amyotrophic lateral sclerosis, and in muscle specimens from three normal controls. In the cases of inclusion body myositis, rimmed vacuoles were ubiquitin immunoreactive in all cases. Intrasarcoplasmic inclusions were positive in the nine cases that had them. In four cases, there were positive intranuclear inclusions, and in seven, there was homogeneous staining of nuclei. Atrophic fibers and necrotic fibers were positive in 11 and nine cases, respectively. In the cases of amyotrophic lateral sclerosis, atrophic fibers were positive in three cases, and focal nuclear staining was seen in two. In one of the three control cases, a few atrophic fibers had faint sarcoplasmic positivity; no other staining was seen. We conclude that ubiquitin is a component of the inclusions that characterize inclusion body myositis. However, ubiquitin expression in skeletal muscle disease is not pathognomonic of inclusion body myositis.     

Methodological issues in outcome studies of school-based interventions for the prevention of adolescent depression.

Several methodological and ethical issues are addressed in the context of 3 related school-based studies of the primary and targeted prevention of depressive symptoms and disorder in high school adolescents. These issues include obtaining S consent and the protection of confidentiality, minimizing attrition over long-term follow-up periods, the "unit of assignment" issue common to most school-based research, and ensuring therapist fidelity to the intervention protocol. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

The evolution of custom microarray manufacture

Given the enormous size of the genome and that there are potentially many other types of measurements we need to do to understand it, it has become necessary to pick and choose one's targets to measure because it is still impossible to evaluate the entire genome all at once. What has emerged is a need to have rapidly customizable microarrays. There are two dominant methods to accomplish custom microarray synthesis, Affymetrix-like microarrays manufactured using light projection rather than semiconductor-like masks used by Affymetrix to mass manufacture their GeneChip/sup TM/ arrays now, or the ink-jet printing method employed by Agilent. The manufacture of these custom Affymetrix-like microarrays can now be done on a digital optical chemistry (DOC) machine developed at the University of Texas Southwestern Medical Center, and this method offers much higher feature numbers and feature density than is possible with ink-jet printed arrays. On a microarray, each feature contains a single genetic measurement. The initial DOC prototype has been described in several publications, but that has now led to a second-generation machine. This machine reliably produces a number of arrays daily, has been deployed against a number of biomedical questions, is being used in new ways and has also led to a number of spin-off technologies.