Low RF noise and power loss for ion-implanted Si having an improved implantation process

Very-low-transmission line noise of <0.25 dB at 18 GHz and low power loss /spl les/0.6 dB at 110 GHz have been measured on transmission lines fabricated on proton-implanted Si. In contrast, a standard Si substrate gave much higher noise of 2.5 dB and worse power loss of 5 dB. The good RF integrity of proton-implanted Si results from the high isolation impedance to ground, as analyzed by an equivalent circuit model. The proton implantation is also done after forming the transmission lines at a reduced implantation energy of /spl sim/4 MeV. This enables easier process integration into current VLSI technology.     

The hydration phase and pore structure formation in the blends of sulfoaluminate-belite cement with Portland cement

Sulfoaluminate-belite (SAB) cements are an attractive class of low-energy cements from the viewpoint of saving energy and releasing less CO₂ into the atmosphere during their production. Their hydraulic activity, however, does not match that of the ordinary Portland cement (PC) and needs improvement before they can be used on their own. However, SAB cements when blended with PC have the potential to be used effectively in traditional applications as shown by this study. Mortars made with blends of SAB cements and PC, and a cement-to-sand ratio of 1:3 by weight and a water-to-cement ratio of 0.5, indicate a superior protection against corrosion of steel to those made with blends of PC and blast-furnace slag (BFSPC). The prepared mortars were stored at 20 °C for 90 days under either a 60% relative humidity (RH)-dry air, or 100% RH-wet air conditions. With further improvement in the SAB cement quality through better understanding of their characteristics, a genuine competition between SAB/PC and BFSPC can be expected in practice.     

Effect of irradiation with low-energy Ar ions on the characteristics of the working and rear sides of single-crystal GaAs substrate

Contactless methods were used to study the characteristics of the front and rear sides of single-crystal GaAs wafers whose rear side was irradiated with low-energy Ar ions. Variations in the optical and photoelectric properties of irradiated and unirradiated sides were detected. A solitonic mechanism for the penetration of defects into the crystal bulk is suggested.     

Manipulation of microenvironment with a built-in electrochemical actuator in proximity of a dissolved oxygen microsensor

Biochemical sensors for continuous monitoring require dependable periodic self diagnosis with acceptable simplicity to check its functionality during operation. An in-situ self-diagnostic technique for a dissolved oxygen microsensor is proposed in an effort to devise an intelligent microsensor system with an integrated electrochemical actuation electrode. With a built-in platinum microelectrode that surrounds the microsensor, two kinds of microenvironments, called the oxygen-saturated or oxygen-depleted phases, can be created by water electrolysis, depending on the polarity. The functionality of the microsensor can be checked during these microenvironment phases. The polarographic oxygen microsensor is fabricated on a flexible polyimide substrate (Kapton) and the feasibility of the proposed concept is demonstrated in a physiological solution. The sensor responds properly during the oxygen-generating and oxygen-depleting phases. The use of these microenvironments for in-situ self-calibration is discussed to achieve functional integration, as well as structural integration, of the microsensor system.     

QoS enhancement for adaptive streaming services over WCDMA

This paper presents a new method to adapt the quality-of-service (QoS) in a wideband code-division multiple-access (WCDMA) system, called radio network feedback (RNF). The concept of RNF is in general applicable to all the services requiring a minimum quality (i.e., non best effort) and in this paper, the focus is on streaming. In this context, RNF makes it possible for a streaming server to adapt its source bit rate to a WCDMA radio link, whose bandwidth may vary in time due, for example, to decongestion/congestion situations over the air interface or to handover. This is very beneficial for the end user as it allows to increase the bandwidth (i.e., the quality) when possible and to decrease it (instead of just dropping the service) when needed. RNF was compared with Client-based adaptation solutions. Simulation results show that RNF is fast and accurate and performs better than Client-based adaptation. For example, rebuffering occurs only with Client-based method. Moreover, with RNF the up-switch is performed only when needed, whereas the up-switch performed by means of the Client-based method is often erroneous and may annoy the end user.     

On the sensitivity of coupled resonator filters without some direct couplings

This paper presents an analysis of the sensitivity of coupled resonator filters in which some direct couplings are missing. The effect of changes in the coupling coefficients and resonant frequencies of the resonators is investigated by directly computing the gradient of the scattering parameters. It is shown that structures that are modular in the input-to-output direction are much less sensitive than those with modularity in the orthogonal direction for the same frequency response.     

The civilian battlefield [transportation network security]

In this paper, the authors describe how the tragic events of 11 September 2001 have resulted in an urgent requirement for improved and enhanced security measures at airports, larger facilities and transportation networks.     

An Eshelbian approach to the nonlinear mechanics of constrained solid-fluid mixtures

Summary.  Looking at rational mixture theories within the context of a new perspective, this work aims to put forward a proposal for an Eshelbian approach to the nonlinear mechanics of a constrained solid-fluid mixture, made up of an inhomogeneous poroelastic solid and an inviscid compressible fluid, which do not undergo any chemical reaction. Received July 26, 2001; revised May 15, 2002 Published online: January 16, 2003