Rheology of concentrated solutions of hyperbranched polyesters

The solution rheology of different generations of hyperbranched polyesters in N‐methyl‐2‐pyrrolidinone (NMP) solvent was examined in this study. The solutions exhibited Newtonian behavior over a wide range of polyester concentrations. Also, the relative viscosities of poly(amidoamine) (PAMAM) dendrimers in ethylenediamine were compared with those of the hyperbranched polyesters in NMP. Both types of dendritic polymers have relative viscosities that are exponential functions of their molar fraction in solution. The slopes of these relative viscosity curves show a linear relationship with respect to the generation number. PAMAM dendrimers have the greater slopes for each generation, reflecting their relatively larger intrinsic viscosity values.     

Transducin-alpha C-terminal peptide binding site consists of C-D and E-F loops of rhodopsin

The binding of heterotrimeric GTP-binding proteins (G-proteins) to serpentine receptors involves several independent contacts. We have deduced the points of interaction between mutant bovine rhodopsins and alphat-(340-350), a peptide corresponding to the C terminus of the alpha subunit (alphat) of bovine retinal G-protein, transducin. Direct binding of alphat-(340-350) to rhodopsin stabilizes the activated metarhodopsin II state (M II), consequently uncoupling the rhodopsin-transducin interaction. This peptide action requires two segments on the cytoplasmic domain of rhodopsin: the Tyr136-Val137-Val138-Val139 sequence on the C-D loop and the Glu247-Lys248-Glu249-Val250-Thr251 sequence on the E-F loop. We propose that a tertiary interaction of these two loop regions forms a pocket for binding the alphat C terminus of the transducin during light transduction in vivo. In most G-proteins, the C termini of alpha subunits are important for interaction with receptors, and, in several serpentine receptors, regions similar to those in rhodopsin are essential for G-protein activation, indicating that the interaction described here may be a generally applicable mode of G-protein binding in signal transduction.     

Rapid determination of the membrane potential of mitochondria in small biopsy specimens of the liver

In liver transplantation, graft viability is ideally to be determined before implantation. Integrity of mitochondria may be a prerequisite to a viable graft. A new method is presented, which allows for the determination of the membrane potential of mitochondria (MPM; mV) in state 4 respiration within 50 min in 40-mg specimens, employing rhodamine 123 as a probe. Normal control showed a MPM of 239.2 mV. Storage in saline at 37 degrees C yielded an impaired MPM of 153.5 mV within 3 h. The cold storage at 1 degree C could preserve MPM at quasi-normal after 3 h but reduced it significantly after 24 h to 222.2 mV in saline (p < 0.005 vs. control) and 231.0 mV in UW solution (p < 0.05 vs. control): the difference between the 24-hour values was significant (p < 0.05).     

Archiving the web using page changes patterns: a case study

A pattern is a model or a template used to summarize and describe the behavior (or the trend) of data having generally some recurrent events. Patterns have received a considerable attention in recent years and were widely studied in the data mining field. Various pattern mining approaches have been proposed and used for different applications such as network monitoring, moving object tracking, financial or medical data analysis, scientific data processing, etc. In these different contexts, discovered patterns were useful to detect anomalies, to predict data behavior (or trend) or, more generally, to simplify data processing or to improve system performance. However, to the best of our knowledge, patterns have never been used in the context of Web archiving. Web archiving is the process of continuously collecting and preserving portions of the World Wide Web for future generations. In this paper, we show how patterns of page changes can be useful tools to efficiently archive Websites. We first define our pattern model that describes the importance of page changes. Then, we present the strategy used to (i) extract the temporal evolution of page changes, (ii) discover patterns, to (iii) exploit them to improve Web archives. The archive of French public TV channels France Télévisions is chosen as a case study to validate our approach. Our experimental evaluation based on real Web pages shows the utility of patterns to improve archive quality and to optimize indexing or storing.     

An Eco-Friendly Approach to the Control of Pathogenic Microbes and Anopheles stephensi Malarial Vector Using Magnesium Oxide Nanoparticles (Mg-NPs) Fabricated by Penicillium chrysogenum

The discovery of eco-friendly, rapid, and cost-effective compounds to control diseases caused by microbes and insects are the main challenges. Herein, the magnesium oxide nanoparticles (MgO-NPs) are successfully fabricated by harnessing the metabolites secreted by Penicillium chrysogenum. The fabricated MgO-NPs were characterized using UV-Vis, XRD, TEM, DLS, EDX, FT-IR, and XPS analyses. Data showed the successful formation of crystallographic, spherical, well-dispersed MgO-NPs with sizes of 7–40 nm at a maximum wavelength of 250 nm. The EDX analysis confirms the presence of Mg and O ions as the main components with weight percentages of 13.62% and 7.76%, respectively. The activity of MgO-NPs as an antimicrobial agent was investigated against pathogens Staphylococcus aureus, Bacillus subtilis, Pseudomonas aeruginosa, Escherichia coli, and Candida albicans, and exhibited zone of inhibitions of 12.0 ± 0.0, 12.7 ± 0.9, 23.3 ± 0.8, 17.7 ± 1.6, and 14.7 ± 0.6 mm respectively, at 200 µg mL⁻¹. The activity is decreased by decreasing the MgO-NPs concentration. The biogenic MgO-NPs exhibit high efficacy against different larvae instar and pupa of Anopheles stephensi, with LC50 values of 12.5–15.5 ppm for I–IV larvae instar and 16.5 ppm for the pupa. Additionally, 5 mg/cm² of MgO-NPs showed the highest protection percentages against adults of Anopheles stephensi, with values of 100% for 150 min and 67.6% ± 1.4% for 210 min.     

Combustion synthesis of NbC/ZrO2 composites: Influence of Cr additives on the microstructure and mechanical properties

Composites of NbC/ZrO₂ reinforced with different weight ratios of Cr metal were prepared by dynamic compaction combustion from a blend of Nb₂O₅–Zr–Cr powders. Factors controlling the synthesis process, the microstructure, and the mechanical properties of the samples, such as Cr wt% and the compression loads were studied. The samples were characterized by XRD, SEM, porosity, and hardness measurements. The porosity value of the sample with no additives was high and reached 31.6 vol%. A sudden decrease in the sample porosity to 2.4 vol % was noticed for the sample containing 3.0 wt% of Cr. A high-density sample with less than 2.0 vol % porosity and maximum hardness of 1038 HV was produced using 5.0 wt% Cr under 300 MPa compression load. Detailed thermodynamic calculations for the effect of Cr additives on the physicochemical properties of the system were introduced.     

Functional and nutritional properties of modified proteins of sesame (Sesamum indicum, L.)

A study on the functional and nutritional properties of sesame (Sesamum indicum, L.) flour, concentrate and enzymatic hydrolysates, demonstrated that nitrogen solubility of the hydrolysates is improved, in water (85%) and at different pHs (91-95%), by the action of neutrasa 0.5L and alcalasa 0.6L, yielding a product with good emulsifying and improved foaming properties. Hydrolysates produced by the pH-stat method, then freeze-dried and spray-dried presented a PER of 1.1 and 0.9, respectively. The flour and the concentrate had PER values of 1.2. Supplementation of one of the hydrolysates with soya hydrolysate (1:1), improved the PER to a value similar to that of casein. Use of neutrasa 0.5L and alcalasa 0.6L enzymes, enhances the sesame protein solubility without modifying extensively the PER. Besides, it yields a dehydrated product with improved emulsifying and foaming properties.     

Lithium/V6O13 cells using silica nanoparticle-based composite electrolyte

The electrochemical behavior of Li/V₆O₁₃ cells is investigated at room temperature (22 °C) both in liquid electrolyte consisting of oligomeric poly(ethyleneglycol)dimethylether+lithium bis(trifluoromethylsulfonylimide) and composite electrolytes formed by blending the liquid electrolyte with silica nanoparticles (fumed silica). The addition of fumed silica yields a gel-like electrolyte that demonstrates the desirable property of suppressing lithium dendrite growth due to the rigidity and immobility of the electrolyte structure. The lithium/electrolyte interfacial resistance for composite gel electrolytes is less than that for the corresponding base-liquid electrolyte, and the charge-discharge cycle performance and electrochemical efficiency for the Li/V₆O₁₃ cell is significantly improved. The effect of fumed silica surface group on the electrochemical performance is discussed; the native hydrophilic silanol surface group appears better than fumed silica that is modified with a hydrophobic octyl surface moiety.     

Modification of oil palm empty fruit bunches with maleic anhydride: The effect on the tensile and dimensional stability properties of empty fruit bunch/polypropylene composites

Oil palm empty fruit bunch (EFB)‐filled polypropylene (PP) composites were produced. The EFB filler was chemically modified with maleic anhydride (MAH). The effects of the filler size and chemical modification of EFBs on the tensile and dimensional stability properties of EFB–PP composites were studied. The composites with MAH‐treated EFBs showed higher tensile strengths than those with untreated EFBs. This was attributed to the enhanced compatibility between the MAH‐treated EFBs and PP matrix, as shown in a scanning electron microscopy study. Fourier transform infrared analysis showed evidence of C?C and C?O bonds from MAH at 1630 and 1730 cm^?1, respectively. The MAH‐treated PP composites showed lower water absorption and thickness swelling than those with untreated EFBs. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 87: 827–835, 2003     

Electrical conductivity of concrete containing silica fume

The influence of silica fume on concrete properties represents an important technical research. In general, silica fume tends to improve both mechanical characteristics and durability of concrete. Thus the electrical properties of concrete containing silica fume can be studied to clarify its physical performance during hydration. The electrical conductivity of neat cement, mortar and concrete pastes was measured during setting and hardening. The ordinary Portland cement was partially replaced by different amounts of silica fume by weight. The changes in the electrical conductivity were reported during setting and hardening after gauging with water. The results of this study showed that the electrical conductivity can be used as an indication for the setting characteristics as well as the structural changes of the hardened pastes made with and without silica fume.