Estimation of vapour pressure and partial pressure of subliming compounds by low-pressure thermogravimetry

A method for the estimation of vapour pressure and partial pressure of subliming compounds under reduced pressure, using rising temperature thermogravimetry, is described in this paper. The method is based on our recently developed procedure to estimate the vapour pressure from ambient pressure thermogravimetric data using Langmuir equation. Using benzoic acid as the calibration standard, vapour pressure-temperature curves are calculated at 80, 160 and 1000 mbar for salicylic acid and vanadyl bis-2,4-pentanedionate, a precursor used for chemical vapour deposition of vanadium oxides. Using a modification of the Langmuir equation, the partial pressure of these materials at different total pressures is also determined as a function of temperature. Such data can be useful for the deposition of multi-metal oxide thin films or doped thin films by chemical vapour deposition (CVD).     

Hybrid polymer networks of unsaturated polyester–urethane as composite matrices for jute reinforcement

Reactions of unsaturated polyester resin and 4,4′ diphenyl methane diisocyanate were carried out at different NCO/OH ratios in presence of catalysts to form the hybrid polymer networks. Chain extender (1,4 butanediol) added in the hybrid network (NCO/OH ratio: 0.76) was optimized at a level of ～ 3 wt % only of the polyester resin. The curing of these networks was studied by a rigid body pendulum type (RPT) method in terms of reduced damping ratio and increased frequency. Lack of multiple glass transition temperatures, sharp Tan delta peak, and particulate composite type morphology clearly demonstrated the formation of phase mixed domains in the hybrid networks. The storage modulus and loss modulus master curves obtained by dynamic mechanical analysis indicate that hybrid polymer networks retained higher modulus at lower and intermediate frequencies over the polyester resin showing their superior time‐dependent response. Efficacy of these hybrid network resins was examined as matrices in the jute composites and compared with those of polyester resin and unsaturated polyester–polyurethane interpenetrating network matrices. It is found that the hybrid polymer network matrix composites exhibited superior physicomechanical properties under both dry and boiling water age test. Fractographic evidences such as fiber–matrix adhesion, hackle markings, and fiber breakage also supported their superior behavior over other composite matrices. © 2011 Wiley Periodicals, Inc. J Appl Polym Sci, 2011     

SPECTROSCOPIC CHARACTERIZATION OF SOLVENT SOLUBLE FRACTIONS OF PETROLEUM VACUUM RESIDUES

ABSTRACT

NMR and FTIR spectroscopic techniques were used to investigate the effect of different solvent extraction schemes on the composition and chemical nature of species of vacuum residues of two Indian crude oils (namely Jodhpur and Heera) extractable into polar (ethyl acetate) and non-polar (n-pentane and n-heptane) solvents. The obtained soluble fractions were found to consist of mainly simple aliphatic and naphthenic ring structures, while insoluble fractions consisted primarily aromatic compounds. The results were used to draw inferences on the relative utility of different extraction schemes to upgrade vacuum residues as feedstocks for secondary conversion processes in petroleum industry.     

Pressure dependent phase transitions in (Pb,Ca)TiO3: Determination of structure using high pressure synchrotron X-ray and Raman studies

Pressure dependent studies on technologically important ferroelectric material Pb_0.70Ca_0.30TiO₃ show the occurrence of a new hitherto unreported pressure dependent phase transition around 4 GPa. In the pressure range 4–14 GPa, the parent tetragonal (P4mm) phase of Pb_0.70Ca_0.30TiO₃ transforms in to a monoclinic (Cm) phase before attaining its paraelectric cubic (Pm3m) phase around 15 GPa. High pressure Raman studies reveal the presence of a critical pressure above which the ferroelectric phase starts to reappear in the paraelectric phase. This critical pressure is found to be much lower than the critical pressure observed in pure PbTiO₃. Possible reasons for this lowering of the critical pressure are presented.     

Removal of neutrophil gelatinase‐associated lipocalin by extracorporeal therapies

Neutrophil gelatinase‐associated lipocalin (NGAL) protein is an early biomarker for acute kidney injury (AKI). It is unknown if extracorporeal therapies (EC) have an effect on circulating NGAL levels. This study was designed to describe the kinetics of NGAL molecule in different EC techniques and to evaluate NGAL clearance in different operational conditions. A mock hemofiltration (HF) and hemoperfusion (HP) setup was used. NGAL was added to the blood reservoir and then measured at 30‐minute intervals from arterial, venous, and ultrafiltrate (UF) lines. Removal kinetics and NGAL sieving coefficient were calculated. In our experiments, baseline NGAL concentration averaged 452 μg/L. There was a consistent downward trend throughout the experiment. NGAL concentration in the UF was between 80 and 90 μg/L, though it showed a slight increase in the second hour. The sieving coefficient of NGAL ranged from 0.2 to 0.4 during HF and it appeared to increase with time, suggesting an initial effect of membrane adsorption. HP proved clearly that there was adsorption of NGAL by the membrane and the point of saturation occured at approximately 60 minutes from the start of circulation. Our evaluation demonstrates that NGAL can be adsorbed and ultrafiltrated with polysulfone membranes. This should be taken into consideration when using NGAL as an AKI biomarker in patients undergoing EC circulation.     

TrustTimeout后无线USB PTK的管理方法

根据无线USB规范1.0,在TrustTimeout(可信超时)后,旧的成对临时密钥(Pairwise Temporal Key,PTK)过期,需要更换.但该规范并没有明确定义何时应抛弃旧的PTK.在TrustTimeout后,无线USB主机可以立即删除PTK,或永久保留,也可以保留某段时间.本文根据这一特点提出了一种新的PTK管理方法.它有两个新颖之处:     

Catalytic hydrogenation for improvement of GaAs/Ge solar cell efficiency

Hydrogen passivation on MOCVD grown p-GaAs epilayers on Ge substrate have been studied by plasma and catalytic hydrogenation and the results were compared. The conversion efficiency of the GaAs/Ge solar cells was found to increase by 10% after catalytic hydrogenation at AM1.5. This increase in efficiency is probably due to passivation of surface dangling bonds.     

Characterization and Studies on Hydro Dynamically Stable Operation of an Angular Jet SOG for COIL

Chemical oxygen-iodine Laser (COIL) is one of the fast emerging high power laser source for near Infrared (λ=1.315μm) laser generation. The heart of the system is the singlet oxygen generator (SOG) which is a pumping source for this laser. A Jet type SOG with a novel approach was designed and fabricated. Singlet oxygen was taken out of the SOG at an angle of 40° thus avoiding the carry over of droplets, which is one of the major drawbacks of horizontal system. The preliminary results have been reported in our earlier publication. The present paper discusses the performance of this generator for various operational conditions viz. diluent's gas nitrogen / helium, basic hydrogen peroxide composition, generator pressure and gas velocity. Further, conditions for the stable operation from generator as well as chlorine injection point of view have been identified.