The effect of adding devulcanized rubber on the thermomechanical properties of recycled polypropylene

This work aims to investigate the effect of adding vulcanized or partially devulcanized rubbers on recycled polypropylene (PPr), considering thermomechanical and morphological properties. The study proposes to better understand how structural changes underwent by rubber (after the devulcanization) contributed to improving the mechanical properties of the PPr. The PPr/rubber blends were prepared by a co-rotating twin-screw extruder and then were injected. The blends composed of the most devulcanized rubbers by microwaves with refined microstructure showed higher values of elongation at break and toughness. Data showed that the devulcanization process applied to the rubber interfered positively in its adhesion to the PPr. Data from dynamic mechanical analysis and atomic force microscopy indicated that the most devulcanized rubbers presented an interface more connected to PPr. These chemical interactions possibly impacted the mechanical properties of the PPr. Moreover, dilatation processes favored the fracture mechanisms of the PPr when rubber was added to it.     

Ordering tendencies in Pd-Pt, Rh-Pt, and Ag-Au alloys

First-principles quantum-mechanical calculations indicate that the mixing enthalpies for Pd-Pt and Rh-Pt solid solutions are negative, in agreement with experiment. Calculations of the diffuse-scattering intensity due to short-range order also exhibits ordering tendencies. Further, the directly calculated enthalpies of formation of ordered intermetallic compounds are negative. These ordering tendencies are in direct conflict with a 1959 prediction of Raub that Pd-Pt and Rh-Pt will phase-separate below ~760 °C (hence their mixing energy will be positive), a position that has been adopted by all binary alloy phase diagram compilations. The present authors predict that Pd_1-xPt_x will order in the L1₂, L1₀, and L1₂ structures ([001] superstructures) at compositionsx = 1/4, 1/2, and 3/4, respectively, while the ordered structures of Rh_1-xPt_x are predicted to be superlattices stacked along the [012] directions. While the calculated ordering temperatures for these intermetallic compounds are too low to enable direct growth into the ordered phase, diffuse-scattering experiments at higher temperatures should reveal ordering rather than phase-separation characteristics (i.e., off-F peaks). The situation is very similar to the case of Ag-Au, where an ordering tendency is manifested both by a diffuse scattering intensity and by a negative enthalpy of mixing. An experimental reexamination of PdPt and Rh-Pt is needed.     

Experimental study of stable surfaces for anti-slug control in multi-phase flow

Severe slugging flow is always challenging in oil & gas production, especially for the current offshore based production. The slugging flow can cause a lot of problems, such as those relevant to production safety, fatigue as well as capability. As one typical phenomenon in multi-phase flow dynamics, the slug can be avoided or eliminated by proper facility design or control of operational conditions. Based on a testing facility which can emulate a pipeline-riser or a gas-lifted production well in a scaled-down manner, this paper experimentally studies the correlations of key operational parameters with severe slugging flows. These correlations are reflected through an obtained stable surface in the parameter space, which is a natural extension of the bifurcation plot. The maximal production opportunity without compromising the stability is also studied. Relevant studies have already showed that the capability, performance and efficiency of anti-slug control can be dramatically improved if these stable surfaces can be experimentally determined beforehand. The paper concludes that obtaining the stable surface on the new developed map can significantly improve the production rate in a control scheme. Even though the production rate can be further improved by moving the stable surface using advanced control strategies, the constant inputs can in some cases be preferable due to the easier implementation.     

Morphology and composition of nanograde calcium phosphate needle-like crystals formed by simple hydrothermal treatment

Nanograde calcium phosphate needle-like crystals are prepared from wet synthesized Ca–P precipitates by simple hydrothermal treatment at 140°C and 0.3 MPa for 2 h. The morphology of these crystals is observed by transmission electron microscopy (TEM). The phase composition is tested through X-ray diffractometer (XRD) and infrared spectroscopy (IR). It is found that the morphology of these crystals is related to the activity or fresh degree of the starting Ca–P precipitates and the added fluorine ions, but is not greatly influenced by the Ca/P ratio of the precipitates. These crystals with a Ca/P ratio between 1.67 and 1.5 show a poorly crystallized apatite structure at room temperature and a biphasic (HA+–TCP) structure at 1100°C, corresponding to their Ca/P ratio. It is demonstrated that these nonstoichiometric apatite crystals contain lattice-bound water which could play an important role in the formation of bone apatite. The similarity in morphology and composition between these needle-like crystals and the apatite crystals in bone provides a possibility to make a bone-like implant consisting of these needle-like crystals and collagen, etc.     

New features of the Mott-Hubbard insulator gap of parent HTS compounds found by resonance Raman scattering and UV-excited ordinary Raman scattering

Optical absorption at the insulating gap in the parent phase of cuprate superconductors shows a broad exciton-like peak near 1.7 eV, followed by a gradual decrease in absorption persisting 1 eV above the gap. By using ultraviolet laser lines to excite Raman spectra, we have found a Raman peak 0.2 eV below the first absorption peak in insulating cuprates. The Raman peak is much narrower than the absorption peak and hasA _2g symmetry. We assign it to an exciton consisting of a hole transition from Cu to a linear combination of Cud _xy and nearest neighbor Op orbitals. We have also studied the resonance Raman profile for two-magnon Raman scattering in the same samples. We find a sharp resonance feature at about 2.7 eV, and little Raman intensity for photon energies at the 1.7 eV absorption peak. The state created at the peak must therefore be an inappropriate intermediate state for the double spin-flip Raman process.     

Natural ligands of the B cell adhesion molecule CD22 beta can be masked by 9-O-acetylation of sialic acids

CD22 beta is a B cell-restricted phosphoprotein expressed on the surface of mature resting B cells. It mediates interactions with other cells partly or exclusively via recognition of alpha 2-6-linked sialic acids on glycoconjugates. The sialylated N-linked oligosaccharides recognized best by CD22 beta are common to many glycoproteins, suggesting that additional regulatory mechanisms may exist. Since the exocyclic side chain of sialic acid is required for recognition, we explored the effects of a naturally occurring modification of the side chain, 9-O-acetylation. Semisynthetic N-linked oligosaccharides terminating with 9-O-acetylated, alpha 2-6-linked sialic acids showed markedly reduced binding to CD22 beta relative to their non-O-acetylated counterparts. Murine lymphoid cells were probed for natural CD22 beta ligands that might be O-acetylated using recombinant soluble forms of CD22 beta (CD22 beta Rg) and influenza C esterase (CHE-Fc, which specifically removes 9-O-acetyl esters from sialic acids). By flow cytometry analysis, CD22 beta Rg binding to splenic B cells and a subset of T cells was increased by pretreatment with CHE-Fc, indicating that some potential CD22 beta ligands are naturally "masked" by 9-O-acetylation. Unmasking of these CD22 beta ligands by removal of 9-O-acetyl esters from intact splenocytes substantially increases their CD22 beta-dependent adhesion in an in vitro adhesion assay. Probing of murine lymphoid tissue sections by CD22 beta Rg and CHE-Fc treatment demonstrates regionally restricted and differentially expressed patterns of distribution between masked and unmasked ligands. For example, lymph node-associated follicular B cells express high levels of CD22 beta ligands, none of which are masked by 9-O-acetylation. In contrast, the ligands on lymph node-associated dendritic cells are almost completely masked by 9-O-acetylation, suggesting that masking may regulate interactions between CD22 beta-positive B cells and dendritic cells. In the thymus, only medullary cells express CD22 beta ligands, and a significant portion of these are masked by 9-O-acetylation, particularly at the cortical-medullary junction. Thus, 9-O-acetylation of sialic acids on immune cells is in a position to negatively regulate CD22 beta adhesion events in a manner depending on both cell type and tissue localization.     

Refractive-index-profile determinations by using Lloyd's mirage

A method is presented for the experimental determination of refractive-index profiles for planar media of monotonically decreasing refractive index, such as those used for optical waveguides. The technique is based on a generalization of the classical experiment of Lloyd's mirror, involving the interference pattern formed by a point source and its mirage, i.e., its reflection in such a graded planar medium.     

A model of checkpoint behavior for applications that have I/O

Due to the increase and complexity of computer systems, reducing the overhead of fault tolerance techniques has become important in recent years. One technique in fault tolerance is checkpointing, which saves a snapshot with the information that has been computed up to a specific moment, suspending the execution of the application, consuming I/O resources and network bandwidth. Characterizing the files that are generated when performing the checkpoint of a parallel application is useful to determine the resources consumed and their impact on the I/O system. It is also important to characterize the application that performs checkpoints, and one of these characteristics is whether the application does I/O. In this paper, we present a model of checkpoint behavior for parallel applications that performs I/O; this depends on the application and on other factors such as the number of processes, the mapping of processes and the type of I/O used. These characteristics will also influence scalability, the resources consumed and their impact on the IO system. Our model describes the behavior of the checkpoint size based on the characteristics of the system and the type (or model) of I/O used, such as the number I/O aggregator processes, the buffering size utilized by the two-phase I/O optimization technique and components of collective file I/O operations. The BT benchmark and FLASH I/O are analyzed under different configurations of aggregator processes and buffer size to explain our approach. The model can be useful when selecting what type of checkpoint configuration is more appropriate according to the applications’ characteristics and resources available. Thus, the user will be able to know how much storage space the checkpoint consumes and how much the application consumes, in order to establish policies that help improve the distribution of resources.