粒子网格混合方法模拟液滴夹带起始点

环状流动的特性对反应堆事故工况分析具有重要意义,本研究基于粒子网格混合方法对这一现象中的液滴夹带起始点问题进行了数值分析,利用网格求解流场,利用粒子模拟液膜及液滴的运动,探讨了气水流动大密度比情况下,不同流动方向,不同流体粘度,不同液膜厚度下的液滴夹带所需的临界气相流速,结果同经典关系式进行了对比,吻合良好．这一方法对于反应堆事故中的两相流动研究具有参考意义．     

Triglyceride analysis by combined argentation/nonaqueous reversed phase high performance liquid chromatography

Full analysis of triglycerides of natural fats and oils has been investigated by the combination of argentation high performance liquid chromatography (HPLC) with nonaqueous reversed phase (NARP) HPLC. An infrared detector was used in argentation HPLC, because it indicated molar responsibility to all triglycerides. After peak trapping with argentation HPLC, each triglyceride fraction was analyzed with NARP chromatography using the glyceride-selective post-column reactor detector. The results of the analyses of triglycerides of palm oil and cocoa butter by the proposed method agreed well with those reported earlier.     

Chemical response of Picea glehnii seed-epiphytic Penicillium species to Pythium vexans under in vitro competitive conditions for mycelial growth

The potential protection of Picea glehnii seedlings from damping-off by seed-epiphytic Penicillium species was investigated. We studied the chemical response of seed-epiphytic Penicillium species (Pen. cyaneum, Pen. damascenum, and Pen. implicatum) to Pythium vexans, a damping-off fungus, in vitro. Penicillium species were cultured singly or cocultured with Pyt. vexans for 14 or 18 d, and mycelial growth, pH of culture filtrate, antifungal activity of the culture filtrate against Pyt. vexans, and the amount of antifungal compound produced by each Penicillium species, were examined. The filtrate of both the single culture of Penicillium and the coculture of Penicillium and Pyt. vexans showed antifungal activity against Pyt. vexans. In a coculture with Pyt. vexans, Pen. cyaneum produced an antifungal compound (patulin) as in the single culture. Pen. damascenum cocultured with Pyt. vexans produced an antifungal compound (citrinin), as it did in the single culture and in larger amounts on day 10. Pen. implicatum produced two antifungal compounds, frequentin and palitantin, and the ratio of frequentin (with higher antifungal activity than palitantin) to palitantin was higher in the coculture with Pyt. vexans than in the single culture. Our results indicate that these Penicillium species have the ability to produce antifungal compounds and to keep antifungal activity under competitive condition with Pyt. vexans. The chemical response of these Penicillium species to Pyt. vexans may contribute to protect P. glehnii seedlings from damage by Pyt. vexans.     

Comparison between SiO2 films deposited by atomic layer deposition with SiH2[N(CH3)2]2 and SiH[N(CH3)2]3 precursors

Thin SiO₂ layers were deposited by atomic layer deposition (ALD) using either Bis-dimethylamino-silane (BDMAS: SiH₂(N(CH₃)₂)₂) or Tris-dimethylamino-silane (TDMAS: SiH(N(CH₃)₂)₃) precursors. The purpose of this study is to evaluate these precursors for their suitability for ALD of hafnium (Hf)-silicate gate dielectrics. The advantages of these precursors are that the melting points and vapor pressures are moderate. The thickness of SiO₂ deposited using ALD process is controlled by the number of growth cycles and the growth rate was different for each precursor, that for BDMAS being 1.5 times that for TDMAS at the same reactor pressure. The carbon impurity in the SiO₂ film deposited using BDMAS was about half an order of magnitude less than that using for TDMAS. Furthermore, the carbon impurity was reduced to about the detection limit of secondary ion mass spectrometry after high temperature annealing at 1000 °C during 5 s.     

Theory of Three-Dimensional Discontinuous Deformation Analysis and Its Application to a Slope Toppling at Amatoribashi, Japan

A three-dimensional (3D) rock slope toppling occurred in a discontinuous rock mass. To simulate the failure process and study the mechanism of this rock failure with contact and large displacement in 3D, a new discrete numerical method has been developed called the 3D discontinuous deformation analysis (DDA). This article first introduces the basic principles and then derives the formulas in detail. Finally, the slope failure simulation is applied as an example to investigate the applicability of this new method to rock slope failure research. The simulation results indicate the advantages of using this new method to study the mechanism of a rock slope failure with 3D behavior.     

Development of specimen and test method for strength analysis of MEMS micromirror

Specimens and fracture test methods for strength analysis of MEMS micromirrors were proposed. Bending and combined loading tests were performed, and torsion strength was estimated from those results. Two-parameter Weibull distribution was used to evaluate the fracture stresses estimated from the FEM model. The resulting scale and shape parameters were 787 MPa and 7.77 for the bending test and 517 MPa and 5.28 for the combined loading test. There was a difference in strength between the results of the bending and combined loading tests. From the load factor analysis, it was found that both geometry and stress distribution have to be considered to estimate the strength of MEMS since flaws are non-uniformly distributed. It was also found that torsional strength can be estimated on the safe side using the results of the combined loading test.     

A near-field-sensing transceiver for intrabody communication based on the electrooptic effect

This paper describes a near-field-sensing transceiver for intrabody communication, in which the human body is the transmission medium. The key component of the transceiver is an electric-field sensor implemented with an electrooptic crystal and laser light. This sensor is suitable for detection of the small and unstable electric fields produced by the human body because it has extremely high input impedance. This transceiver enables IEEE 802.3 half-duplex communication of 10 Mb/s through a person's body in an operating range of about 150 cm between the hands. The packet error rate of 0.04% is obtained at packet size of 1070 octet. This paper explains the configuration and performance of the transceiver and presents results of a communication test.     

Field Investigation of Soil Heave by a Large Diameter Chilled Gas Pipeline Experiment, Fairbanks, Alaska

A large scale 105-m-long, 0.9-m-diam chilled pipeline experiment was conducted to assess the response of a production pipeline that transits between unfrozen (seasonally frozen) and permafrost soils in discontinuous permafrost regions. Thermal and heave characteristics of the experiment for a three-year monitoring period are reported. In response to the chilled pipeline, the progressive cooling patterns within the permafrost and unfrozen soils were different, resulting in the development of a thermal boundary at the transition zone between the two thermally different soils. The absolute maximum movement of pipeline was 0.197 m near the thermal boundary, resulting in a differential heave of 0.148 m. Three distinct heave phases were identified within the unfrozen soil. Phase 1 of the first 200 days related to penetration and heave above the groundwater table and was characterized by heave rates between 0.211 and 0.237 mm/day. Phase 2 resulted in increased ice segregation due to interaction of the freez-ing front with the groundwater table. This phase lasted from approximately day200 to day 500 and corresponded to a heave rate from 0.206 to 0.313 mm/day. Phase 3 was characterized by a further decrease in the heave rate to about 0.081 mm/day and lasted from approximately day 500 to day 1,056.     

VS‐CONTROL WITH TIME‐VARYING SLIDING SECTOR — DESIGN AND APPLICATION TO PENDULUM —

In general, a Variable Structure (VS) system is designed with a sliding mode. Recently a sliding sector, designed by an algebraic Riccati equation, has been proposed to replace the sliding mode for chattering‐free VS controllers. In this paper we extend the design algorithm for the sliding sector to a time‐varying sliding sector. The time‐varying sliding sector is defined by functions dependent on both state and time, hence time‐varying uncertainty can be considered. The VS controller is designed to stabilize an uncertain system, quadratically. The design procedure for real systems is introduced via an implementation to the control of “Furuta pendulum”. To enhance the stability it is necessary to compensate the time‐varying nonlinear static friction of the actuator adequately, hence this problem is a good example to demonstrate the performance of the proposed VS control method. In the experiment, it will be shown that the VS control with the time‐varying sliding sector is superior to an orthodox chattering‐free VS control.     

Dynamic Power Integrity Control of ATE for Eliminating Overkills and Underkills in Device Testing

This paper proposes a power integrity control technique for dynamically controlling power supply voltage fluctuations for a device under test (DUT), and demonstrates its effectiveness for eliminating the overkills/underkills due to the difference of power supply impedance between an automatic test equipment (ATE) and a practical operating environment of the DUT. The proposed method injects compensation currents into the power supply nodes on the ATE system in a feed-forward manner such that the ATE power supply waveform matches with the one on the customer’s operating environment of the DUT. A method for calculating the compensation current is also described. Experimental results show that the proposed method can emulate the power supply voltage waveform under a customer’s operating condition and eliminate 95 % of overkills/underkills in the maximum operating frequency testing with 105 real silicon devices. Limitations and applications of the proposed method are also discussed.