Copper substituted nickel ferrite nanoparticles anchored onto the graphene sheets as electrode materials for supercapacitors fabrication

Nickel ferrites with high theoretical capacitance value as compared to the other metal oxides have been applied as electrode material for energy storage devices i.e. batteries and supercapacitors. High tendency towards aggregation and less specific surface area make the metal oxides poor candidate for electrochemical applications. Therefore, the improvements in the electrochemical properties of nickel ferrites (NiFe₂O₄) are required. Here, we report the synthesis of graphene nano-sheets decorated with spherical copper substituted nickel ferrite nanoparticles for supercapacitors electrode fabrication. The copper substituted and unsubstituted NiFe₂O₄ nanoparticles were prepared via wet chemical co-precipitation route. Reduced graphene oxide (rGO) was prepared via well-known Hummer's method. After structural characterization of both ferrite (Ni_1-xCu_xFe₂O₄) nanoparticles and rGO, the ferrite particles were decorated onto the graphene sheets to obtain Ni_1-xCu_xFe₂O₄@rGO nanocomposites. The confirmation of preparation of these nanocomposites was confirmed by scanning electron microscopy (SEM). The electrochemical measurements of nanoparticles and their nanocomposites (Ni_0.9Cu_0.1Fe₂O₄@rGO) confirmed that the nanocomposites due to highly conductive nature and relatively high surface area showed better capacitive behavior as compared to bare nanoparticles. This enhanced electrochemical energy storage properties of nanocomposites were attributed to the graphene and also supported by electrical (I-V) measurements. The cyclic stability experiments results showed ~65% capacitance retention after 1000 cycles. However this retention was enhanced from 65% to 75% for the copper substituted nanoparticles (Ni_0.9Cu_0.1Fe₂O₄) and 65–85% for graphene based composites. All this data suggest that these nanoparticles and their composites can be utilized for supercapacitors electrodes fabrication.     

Influence of traditional agricultural practices on mobilization of arsenic from sediments to groundwater in Bengal delta

In the wake of the idea that surface derived dissolved organic carbon (DOC) plays an important role in the mobilization of arsenic (As) from sediments to groundwater and may provide a vital tool in understanding the mechanism of As contamination (mobilization/fixation) in Bengal delta; a study has been carried out. Agricultural fields that mainly cultivate rice (paddy fields) leave significantly large quantities of organic matter/organic carbon on the surface of Bengal delta which during monsoon starts decomposing and produces DOC. The DOC thus produced percolates down with rain water and mobilizes As from the sediments. Investigations on sediment samples collected from a paddy field clearly indicate that As coming on to the surface along with the irrigation water accumulates itself in the top few meters of sediment profile. The column experiments carried out on a 9 m deep sediment profile demonstrates that DOC has a strong potential to mobilize As from the paddy fields and the water recharging the aquifer through such agricultural fields contain As well above the WHO limit thus contaminating the shallow groundwater. Experiment also demonstrates that decay of organic matter induces reducing condition in the sediments. Progressively increasing reducing conditions not only prevent the adsorption of As on mineral surfaces but also cause mobilization of previously sorbed arsenic. There seems to be a cyclic pattern where As from deeper levels comes to the surface with irrigational water, accumulates itself in the sediments, and ultimately moves down to the shallow groundwater. The extensive and continual exploitation of intermediate/deep groundwater accelerates this cyclic process and helps in the movement of shallow contaminated groundwater to the deeper levels.     

氢氧含量对低氧铜扁线焊接性的影响研究

目的 研究TIG焊接过程中低氧铜扁线氢、氧含量对扁线焊接接头的影响。方法 以规格为3 mm×2 mm的无氧铜扁线和不同氢、氧含量的低氧铜扁线为研究对象,采用氩弧焊接(TIG)方式,系统研究了不同种类扁线母材及焊接接头的微观组织和焊后力学、电学性能。结果 无氧铜扁线经TIG焊接后,焊接接头处没有产生明显的气孔,焊接接头性能良好,其抗拉强度及塑性均与母材的相当。低氢低氧、低氢高氧扁线焊接接头出现少量的气孔,破断力值分别为678 N和654 N。而高氢低氧、高氢高氧扁线焊接接头出现大量的大气孔,破断力值分别为208.7 N和126 N。不同氢氧含量的低氧铜扁线焊后导电率无明显变化。结论 低氧铜扁线焊接接头内部气孔的数量和尺寸受氢、氧含量的影响,相比之下氢元素的影响更大。     

Fatty Acid, Tocopherol and Sterol Compositions of Canadian Prairie Fruit Seed Lipids

The seeds of four prairie fruits—chokecherry (Prunus virginiana), thorny buffaloberry (Shepherdia argentea), Woods’ rose (Rosa woodsii) and hawthorn (Crataegus × mordenensis)—from Southern Alberta were investigated. The lipid contents of the seeds were found to be 10.4, 11.5, 3.7 and 3.4%, respectively. The tested seed lipids contained mainly linoleic acid in the range from 27.9 to 65.6% and oleic acid from 19.7 to 61.9%. The thorny buffaloberry and Woods’ rose seed lipids contained 29.2 and 30.8% of linolenic acid, respectively. The contents of palmitic and stearic acids ranged from 3.2 to 5.4% and 1.6 to 2.2%, respectively. The contents of total tocopherols in the chokecherry, thorny buffaloberry, Woods’ rose and hawthorn seed lipids accounted for 595, 897, 2,358 and 2,837 mg/kg, respectively. The main sterols in the lipids were β-sitosterol, Δ⁵-avenasterol, cycloartenol, campesterol, stigmasterol and gramisterol. The results of the present study show that the lipids from the seeds of the investigated prairie fruits could be a good source of valuable essential fatty acids, tocopherols and sterols, thus suggesting their application as functional foods and nutraceuticals.