Dual-Mode Space-Temporal Simultaneous Processing Equalizer

A tapped delayed line adaptive array antenna (TDL-AAA) and a space-temporal simultaneous processing equalizer (ST-SPE) are proposed as simple space-temporal equalizers based on minimum mean square error (MMSE) criterion. The ST-SPE has a compact hardware with a small number of taps compared to that of the TDL-AAA. The ST-SPE can reduce the computational complexity of the space-temporal joint equalization and it works effectively under the minimum phase condition such as appeared at line-of-sight (LOS) propagation environments at a high antenna height base station. However the ST-SPE cannot work under a non-minimum phase condition caused under N-LOS (non-line-of-sight). On the other hand, the TDL-AAA whose reference signal is synchronized at the center tap (TDL-AAA_C) can work even in the non-minimum phase condition. In this paper, we propose a dual-mode space-temporal simultaneous processing equalizer (Dual-mode ST-SPE) which has a simple configuration and also works in non-minimum phase condition. The Dual-mode ST-SPE can reduce the computational complexity compared to the TDL-AAA_C. Yoshihiro Ichikawa received the B.E. degree in department of communication engineering, in National Defense Academy in 1995, and M.E. and D.E. degree from Ibaraki University in 2001 and 2004, respectively. He joined the Japan Air Self Defense Force in 1995. His research interests are an adaptive algorithm, an antenna design, and an adaptive array antenna. Shigeki Obote received his B.E., M.E. and D.E. degrees in electrical and electronic engineering from Tottori University, Tottori, Japan, in 1996, 1998 and 2000, respectively. Since 2000, he has been with department of media and telecommunications engineering, faculty of engineering, Ibaraki University, Ibaraki, Japan, where he is currently a associate professor. His research interests are in adaptive array antenna and wireless communications systems. Kenichi Kagoshima received the B.E., M.E. and D.E. degrees in electronics engineering from the Tokyo Institute of Technology, Tokyo, Japan, in 1969, 1971, and 1974, respectively. He joined the Nippon Telegraph and Telephone Corporation (NTT) Laboratory in 1974 and researched and developed many kinds of radio communication antennas. Since 1997, he has been a professor at Ibaraki University, Ibaraki, Japan. Dr. Kagoshima was a Secretary and Treasure, Vice Chairman, and Chairman of the IEEE AP-S Tokyo Chapter in 1992, 1993, and 1994, respectively. He was a chair of antennas and propagation professional group of IEICE in 1999 and 2000. In 1973, he received the Yonezawa Prize for Young Engineers and 1998, best paper award from IEICE, respectively.     

Efficient electron transport in 4,4′-bis[N-(1-napthyl)-N-phenyl-amino] biphenyl and the applications in white organic light emitting devices

The electron transport capability of 4,4′-bis[N-(1-napthyl)-N-phenyl-amino] biphenyl (α-NPD) was investigated by fundamental physical measurements named as current–voltage (I–V) electrical property evaluation and displacement current measurement (DCM). In electron-dominated devices, the I–V characteristics of α-NPD were similar as that of (8-hydroxyquinolino) aluminum (Alq₃) owing to their same order of electron mobilities. The interface of Al/LiF and α-NPD was proven to be an Ohmic contact through the evaluation of I–V characteristics at low bias regime (<3 V). And an electron injection barrier, 0.21 eV, at Al/LiF/α-NPD was obtained by extrapolating the temperature dependent I–V curves. The electron transport behavior in α-NPD film was further confirmed by DCM evaluations. Furthermore, an efficient white organic light emission device was successfully fabricated by using α-NPD as hole transport layer and electron transport layer, respectively.     

Ultrafine grain formation in face centered cubic metals during severe plastic deformation

The evolution mechanisms of new high-angle boundaries as well as ultrafine grains at large strains were studied by means of multidirectional forging (MDF) of pure copper at low temperature and aluminum alloy at high temperature, where dynamic recovery operates as a main restoration process. The structural changes can be characterized by the evolution of deformation bands such as microshear or kink bands at moderate strains. Multidirectional forging accelerates the evolution of many mutually crossing microshear or kink bands developed in various directions. The misorientations between (sub)grains increased gradually with increasing cumulative strain, finally leading to the development of a new fine-grained structure. The dynamic grain formation can be resulted from in situ or continuous dynamic recrystallization which is discussed in detail.     

Suppression of natural convection heat transfer along a vertical flat plate with concavities

To clarify the effect of the suppression of natural heat transfer, the local heat transfer coefficients on a vertical cooled flat plate with circular grooves were measured by a multi‐type thermocouple method. Two flat plates with and without periodic circular grooves were tested in this experiment. The characteristics of heat transfer along the plate for both plates were compared. The local heat transfer coefficients on the periodic grooved plate became smaller than that of the flat plate. The flow pattern was changed when it passed over the grooves, and circulation was generated in the grooves in the downstream. As a result, the thickness of the thermal boundary layer on the grooved plate was more developed than the normal flat plate. © 2010 Wiley Periodicals, Inc. Heat Trans Asian Res; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/htj.20294     

Proposal of Design Criteria for Gas Entrainment from Vortex Dimples Based on a Computational Fluid Dynamics Method

Design criteria for gas entrainments (GE) from the liquid surface in a fast breeder reactor system were proposed in this paper for the two types of GE phenomena from a vortex dimple based on a computational fluid dynamics (CFD) method. The first gas entrainment phenomenon is a gas core extension directly to the outlet piping level, which induces large amount of GE to the flow system. The second is continuous bubble detachments from the tip of the vortex dimple. Based on CFD calculations for elemental experiments of the surface vortex, local CFD non-dimensional numbers were defined as the design criteria to prevent GE. In conclusion, it was found that the CFD non-dimensional numbers are useful for the design parameters of GE prevention.     

Zinc Dialkyl Phosphate (<Emphasis Type="Bold">ZP</Emphasis>) as an Anti-Wear Additive: Comparison with <Emphasis Type="Bold">ZDDP</Emphasis>

In this study, we are interested in the anti-wear properties of zinc dialkyl phosphate additive (ZP) in comparison with ‘classical’ zinc dialkyldithiophosphate (ZDDP). Friction tests were performed on a reciprocating tribometer using both ball-on-flat and cylinder-on-flat configurations under a Hertzian contact pressure of 0.9 GPa. Experiments were carried out as a function of temperature (25 and 100 °C), sliding speed (25, 50 and 100 mm/s) and additives concentrations. Ball wear scar diameters as well as friction coefficient were measured. In order to better understand the anti-wear mechanisms of these additives, friction tests were followed by surface analyses such as AES (Auger Electron Spectroscopy) and XPS (X-Ray Photoelectron Spectroscopy). Transmission Electron Microscopy (TEM) observations of the ZDDP and ZP tribofilms were also carried out to visualise the generated layers. The anti-wear capability of ZP molecule is discussed.     

Effects of additives on prebreakdown phenomena in n-hexane

Prebreakdown phenomena in n-hexane are observed in detail for positive and negative polarities by using simultaneously a high speed schlieren technique and an LED current measuring system, when an impulse voltage (1.1/225 μs) is applied to a point-to-plane electrode gap. Furthermore, the effects of several additives on the streamer propagation are investigated. Especially the effects of electron-trapping additives on negative streamer propagation and of low ionization potential additives on the positive streamer propagation, are examined, as is a correlation between the shape and the propagation velocity of the streamers     

Fast and slow electrons in liquid Ar and N2 mixtures

Fast and slow electron current signals in N₂/Ar liquid mixtures have been observed. From the fast signal, the drift velocity and life time of delocalized electrons in the liquid with N₂ molar fractions X=N₂/(N₂+Ar) below 20 mol% were obtained for field strengths E between 5 and 45 kV/cm. The mobility for delocalized electrons in the liquids was shown to decrease exponentially with X as indicated in a previous paper. However, the mobility for localized electrons was shown to increase with increasing X, but only slightly around the N₂ liquid value