A method to modify coordinates of detectors in positron emission tomography systems

A new method to modify coordinates of detectors in any positron emission tomography (PET) system using a radioactive point source is developed. This method is based on selecting a centered detector in each detector block of PET and measuring coincidence counts between the two centered detectors in opposite detector blocks to find the coordinates of their LOR (Line of Response). Due to slight misalignment of detector positions, measured LORs may not intersect at a single point. Based on the proposed method, the coordinates of detectors can be measured with very high accuracy and the coordinate of the center of the gantry (which is normally the same as the center of field of view) can be defined correctly. The results of the application of our method to a small animal PET system (FinePET), which was recently developed at Tohoku University, Japan, are shown here. The method is expected to contribute to the design and development of PET systems which can realize a very high spatial resolution of less than 1 mm FWHM.     

Proportional hazards models with random effects to examine centre effects in multicentre cancer clinical trials

In randomized clinical trials comparing treatment effects on diseases such as cancer, a multicentre trial is usually conducted to accrue the required number of patients within a reasonable period of time. The fundamental point of conducting a multicentre trial is that all participating investigators must agree to follow the common study protocol. However, even with every attempt having been made to standardize the methods for diagnosing severity of disease and evaluating response to treatment, for example, they might be applied differently at different centres, and these may vary from comprehensive cancer centres to university hospitals to community hospitals. Therefore, in multicentre trials there is likely to be some degree of variation (heterogeneity) among centres in both the baseline risks and the treatment effects. While we estimate the overall treatment effect using a summary measure such as hazard ratio and usually interpret it as an average treatment effect over the centre, it is necessary to examine the homogeneity of the observed treatment effects across centres, that is, treatment-by-centre interaction. If the data are reasonably consistent with homogeneity of the observed treatment effects across centres, a single summary measure is adequate to describe the trial results and those results will contribute to the scientific generalization, the process of synthesizing knowledge from observations. On the other hand, if heterogeneity of treatment effects is found, we should carefully interpret the trial results and investigate the reason why the variation is seen. In the analyses of multicentre trials, a random effects approach is often used to model the centre effects. In this article, we focus on the proportional hazards models with random effects to examine centre variation in the treatment effects as well as the baseline risks, and review the parameter estimation procedures, frequentist approach-penalized maximum likelihood method--and Bayesian approach--Gibbs sampling method. We also briefly review the models for bivariate responses. We present a few real data examples from the biometrical literature to highlight the issues.     

Massive ascites as an initial sign, plasmacytoma of the cervical supine, and hyperammonemic consciousness disturbance in a patient with biclonal type multiple myeloma

Etomidate-induced suppression of cortisol biosynthesis is a result of a blockade of 11-beta-hydroxylation in the adrenal gland, mediated by the imidazol radical of etomidate. Since the generation of steroids requires reductive and energy rich equivalents, the present study examined whether supplementation with ascorbic acid or xylitol, a major source of NADPH, could attenuate adrenal suppression by etomidate in human subjects by promoting the turnover rate of 11-beta-hydroxylase. During continuous etomidate/alfentanil anaesthesia for pelviscopic surgery 30 female patients received either Ringer's lactate, xylitol (0.25 g kg-1 h-1) or ascorbic acid (0.5 g h-1) intravenously (i.v.). The plasma concentrations of cortisol, aldosterone and dehydroepiandrosterone (DHEA) were recorded for 5 h after end of surgery and a stimulation with synthetic ACTH was performed. The results showed no evidence of a clinically relevant attenuating effect of ascorbic acid or xylitol on etomidate-induced adrenocortical suppression. However, the observed suppression of cortisol levels was not enough to allow an attenuating affect to be measured.     

Improvement of bitumen-waste product in leachability—Leachability of bitumen product containing BWR's evaporator concentrate

The method has been developed to improve the bitumen product which incorporates an evaporator concentrate from a BWR, with respect to the swelling and leaching. The leachability of the product has been measured by the method recommended by the IAEA. The swelling of the product is successfully prevented by the addition of calcium chloride. The specimen containing the waste up to Wa/B (Weight ratio of Na₂SO₄ + CaCl₂ and bitumen) = 60:40 shows no pronounced swelling, when it is immersed in water. The cumulative fractions of ¹³⁷Cs and ⁶⁰Co leached from a specimen which does not contain CaCl₂ are 0.65 and 0.2 at the leaching time of 30 days. On the hand, the corresponding value at 100 days for the specimen with calcium chloride addition is 5 × 10^?4 for ¹³⁷Cs and 1 × 10^?4 for ⁶⁰Co. The coating of the specimen surface with a fresh bitumen (5 mm thickness) reduces the leachability further. These results indicate that this method is effective to improve the bitumen product incorporating BWR's evaporator concentrate.     

Preparation of β-FeSi2 substrates by molten salt method

Large-sized β-FeSi₂ substrates were successfully prepared for the first time from the silicide bulk crystal grown by the molten salt method. The structural, electrical and optical properties of the as-grown β-FeSi₂ bulk crystals were also investigated. The crystal is single phase β-FeSi₂, and polycrystalline with no preferable growth crystallographic orientations. It was also determined that the β-FeSi₂ shows a p-type conduction, and the hole concentration and the Hall mobility at room temperature were about 10¹⁷ cm^− 3 and 10 cm²/Vs, respectively. In addition, the PL emission around 0.8 eV was realized from the β-FeSi₂ bulk crystal. This simple vacuum-free growth technique of β-FeSi₂ and the large-sized substrate preparation procedure encourage us to develop future silicide-based electronics.     

Radiation crosslinking of propylene-vinylsilane copolymer

Summary It has been found that a propylene-vinylsilane copolymer (a few mole % of vinlysilane) is crosslinked by radiation (-ray or electron beam) effectively. The mixture of the copolymer and a propylene homopolymer has been also crosslinked by radiation. It is proposed that the crosslinking reaction is due to the coupling of silyl-radical of vinylsilane unit with carbon-radical of propylene unit.     

Post-irradiation studies on knock-out and pseudo-recoil releases of fission products from fissioning UO2

By using post-irradiation techniques, in-pile releases of ¹³³Xe, ^85mKr, ⁸⁸Kr, ⁸⁷Kr and ¹³⁸Xe from UO₂ fissioning at low temperatures below about 200° C are studied: these are analyzed into a time-dependent knock-out and time-independent pseudo-recoil releases. For the latter, a “self knock-out” mechanism is proposed: when a fission fragment loses thoroughly its energy near the UO₂ surface and stops there, it will knock out the surface substances and accordingly the fragment (i.e. the fission product) will be released. The effective thickness of the layer where the self knock-out occurs is found to be ~7Å. As for the knock-out release, the following is estimated from its dependence on various factors: the knock-out release of fission products occurs from the surface layer with the effective thickness of ~20Å: the shape of UO₂ matrix knocked out by one fission fragment passing through the surface is equivalent to a cylinder ~32Å diameter by ~27Å thick, (i.e. the knock-out coefficient for UO₂ is ~660 uranium atoms per knock-out event). On the basis of the above estimations, the conclusions derived from the past in-pile studies of fission gas releases are evaluated.     

基于三维人脸成像系统的复数域人脸识别方法

三维人脸识别是模式识别和人工智能领域的研究热点。提出了一种利用人脸图像的二维灰度信息和三维深度信息进行人脸识别的算法。首先利用相关型图像传感器构成三维实时人脸成像系统,并将获得的三维人脸物理数据用复数形式表达。再将特征脸（Eigenface）方法和Fisherface方法拓展到复数域,提出了复数域特征脸方法和复数域Fisherface方法。改进的复数域人脸识别方法在三维实时成像系统的人脸数据库中进行的人脸识别实验表明,复数域的三维人脸识别方法明显优于传统的人脸识别方法。