Fundamental Behavior of Direct-Coupled Submicrosecond Pulse Energization in Electrostatic Precipitators

The fundamental characteristics of the direct-coupled pulse energization in electrostatic precipitators (EP's) are investigated in a test rig comprised of a coal pulverizing facility, a furnace, a gas cooling system, and an EP. The EP consisted of a corona electrode with barbed wires and a collection electrode with 300-mm duct spacing. This simulates the type of EP normally used in a coal-fired power station. The pulse-energized collection field shows a very high collection performance of more than 99 percent collection efficiency and the performance enhancement compared to the conventional dc energization, causing very severe back corona, becomes as large as H = 2.50.H is the enhancement factor in terms of the Deutsch migration velocity in the case of the very high resistivity dust of rd = 2 x 1013 ?cm at the gas temperature of Tg = 150°C. Even at the lower level of the dust resistivity at Tg = 110°C, where no back corona occurs in the dc-energized collection field, the performance enhancement is as large as H = 1.21. The mechanism of such great performance enhancement is likely to be the result of the very uniform and very intense formation of corona plasmas on the wires as a result of the very fast rise in the pulse voltage applied and a special sawtooth waveform of the operating voltage between the corona and collection electrodes.     

Effect of mixing ratio on bactericidal action of MgO–CaO powders

MgO–CaO powders were prepared with different molar ratios (MgO/CaO) at 1400 °C for 2 h in air. By using the powder samples obtained, the change in bactericidal effect as a function of MgO–CaO composition was studied by colony count method. From the XRD measurements, it was found that CaO solid solution was formed by the replacement of Mg²⁺ ion with larger Ca²⁺ ion. However, no formation of MgO solid solution was observed. The average particle size and the specific surface area of the samples used in this study were about 0.2 m and 10.5m²g^–1, respectively. The pH values of physiological saline containing powder samples increased with the increase of CaO content, and the value reached 12.1 in sample with the molar ratio (MgO/CaO) of 0.25. From the results of bactericidal tests for Staphylococcus aureus, it was found that the bactericidal effect increased with the increase of CaO content in the samples.     

Bending property and phase transformation of Ti–Ni–Cu alloy dental castings for orthodontic application

Bending property of Ti–Ni–Cu alloy castings was investigated in a three-point bending test for orthodontic application in relation to the phase transformation. The compositions of the alloys were Ti–50.8Ni and Ti–40.8Ni–10.0Cu (mol %), and four cross-sectional shapes of the specimens were selected. Heat treatment was performed at 713, 753 or 793 K for 1.8 ks. The bending load changed by the cross-sectional size and shape mainly because of the difference in the moment of inertia of area, but the load–deflection relation did not differ proportionally in the unloading process. The difference between the load values in the loading and the unloading processes was relatively small for Ti–Ni–Cu alloy. With respect to the residual deflection, there was no significant difference between Ti–Ni and Ti–Ni–Cu alloys with the same treatment condition. The load values in the loading and the unloading processes decreased by each heat treatment for Ti–Ni alloy; however, the decrease in the load values for Ti–Ni–Cu alloy was not distinct. It is proved that Ti–Ni–Cu alloy castings produce effective orthodontic force as well as stable low residual deflection, which is likely to be caused by the high and sharp thermal peaks during phase transformation.     

Hairpin-based state machine and conformational addressing: Design and experiment

In this paper, we propose a new architecture for a multi-state DNA machine whose conformation of repeated hairpin structures changes sequentially in response to input oligomers. As an application of the machine, we also propose molecular memory in which the machine is used as a memory unit. Addressing in the memory is realized through state transitions of the machine. We then describe a method for designing DNA sequences of the machine, which exhaustively checks conformational changes of the machine by dividing its secondary structure into hairpin units. The method is based on the minimum free energy of the structure, the structure transition paths, and the total frequency of optimal and suboptimal structures. DNA sequences designed by the method were tested in a chemical experiment in which a machine consisting of two hairpins was actually constructed. As a result, we verified that the multi-state DNA machine realized the expected changes in its secondary structure.     

PID landing orbit motion controller for an indoor blimp robot

Blimp robots are attractive as indoor flying robots because they can float in the air, land safely with low energy, and stay in motion for a long time compared with other flying robots. However, controlling blimp robots is difficult because they have nonlinear characteristics, are influenced by air streams, and can easily be influenced by inertia. Therefore, a robust and adaptive control system is needed for blimp robots. The applied research that has studied the features of indoor flying robots in recent years has prospered. Operating an indoor blimp robot for a long time is difficult because the payload is small, multiple batteries cannot be stacked, and the design of a thruster that gives freedom to the entire blimp robot is difficult. Therefore, an autonomous charge that allows operation for a long time is needed. We have developed a method of landing with orbital control of the charge point that gives autonomy to a blimp robot. The possibility of landing with orbital control is shown. This work was presented in part at the 10th International Symposium on Artificial Life and Robotics, Oita, Japan, February 4–6, 2005 An erratum to this article is available at .     

Quantum Communication and Information Processing with Quantum Dots

This paper reviews the single photon sources based on semiconductor quantum dots and their applications to quantum information systems. By optically pumping a system consisting of a semiconductor single quantum dot confined in a monolithic microcavity, it is possible to produce a single photon pulse stream at the Fourier transform limit with a negligible jitter. This single photon source is not only useful for BB84 quantum key distribution (QKD), but also find applications in other quantum information systems such as Ekert91/BBM92 QKD and quantum teleportation gate linear optical quantum computers.     

聚苯撑共聚物的合成与表征

研究了在不同条件下以NiCl2（bpy）为催化剂的对－二溴苯与间－二溴苯间的共缩聚反应。利用该反应可以合成出数均分子量为2400的一系列共聚物，而且部分试样在有机溶剂中具有良好的溶解性。红外光谱和紫外光谱分析表明：在共聚物中存在着对苯撑与间苯撑结构单元。DSC、TGA和X－ray分析表明：随着共聚物中间苯撑结构单元的增加，聚苯撑共聚物的玻璃化转移温度、粘流温度和结晶度降低。共聚物的四氢呋喃溶液的荧光光谱分析表明：发射光谱的最大值处于373－376nm处。而同一试样的膜，该值位移到405－436nm处。     

Low‐power‐consumption TFT‐LCD with dynamic memory embedded in the pixels

A low‐power‐consumption thin‐film‐transistor liquid‐crystal display (TFT‐LCD) with dynamic memory cells embedded in each pixel using low‐temperature poly‐Si technology has been developed. By holding data in the memory, the operating rate of the data driver can be dramatically reduced to 4 Hz. Eight levels of gray scale with low power consumption can be achieved by using the area‐ratio gray‐scale method. This TFT‐LCD can be used for displaying fine still images, with low power consumption.     

Simultaneous removal of NO/sub x/, SO/sub x/, and CO/sub 2/ at elevated temperature using a plasma-chemical hybrid process

In previous studies, the authors confirmed that the plasma-chemical combined hybrid process for controlling NO flue gas emission was extremely effective and economical in comparison with the conventional selective catalytic reduction (SCR) system and other technologies. In the present study, we carried out experiments on the simultaneous removal of NO/sub x/ and SO/sub x/ at elevated temperature using the plasma-chemical hybrid process. A series of experiments was performed to quantify all the reaction byproducts such as N/sub 2/O, CO, HNO/sub 2/, HNO/sub 3/, NO/sub 3//sup -/, and SO/sub 4//sup -/ to evaluate the simultaneous NO/sub x/ and SO/sub x/ removal efficiency. The oxidation from NO to NO/sub 2/ without decreasing NO/sub x/ concentration (i.e., minimum reaction byproducts) and with least power consumption is the key for the optimum operation of the plasma reactor. The produced NO/sub 2/ was totally converted to N/sub 2/ and Na/sub 2/SO/sub 4/ with Na/sub 2/SO/sub 3/ or Na/sub 2/S with and without NaOH using the barrier-type packed-bed plasma reactor followed by the packed-column chemical reactor. The NO/sub 2/ reduction was more effective for Na/sub 2/S than Na/sub 2/SO/sub 3/ but produces H/sub 2/S with Na/sub 2/S. For both cases at least five times the stoichiometric amount of chemicals were required for complete NO/sub 2/ reduction. Nearly 100% of NO/sub x/ and SO /sub 2/ and 40% Of CO/sub 2/ simultaneous removal were achieved with less than 5 ppm of N/sub 2/O and CO. The operating cost was less than 1/4 the SCR process. The additional SO/sub 2/ treatment system can be eliminated.     

Spatial indexing of high-dimensional data based on relative approximation

We propose a novel index structure, the A-tree (approximation tree), for similarity searches in high-dimensional data. The basic idea of the A-tree is the introduction of virtual bounding rectangles (VBRs) which contain and approximate MBRs or data objects. VBRs can be represented quite compactly and thus affect the tree configuration both quantitatively and qualitatively. First, since tree nodes can contain a large number of VBR entries, fanout becomes large, which increases search speed. More importantly, we have a free hand in arranging MBRs and VBRs in the tree nodes. Each A-tree node contains an MBR and its children VBRs. Therefore, by fetching an A-tree node, we can obtain information on the exact position of a parent MBR and the approximate position of its children. We have performed experiments using both synthetic and real data sets. For the real data sets, the A-tree outperforms the SR-tree and the VA-file in all dimensionalities up to 64 dimensions, which is the highest dimension in our experiments. Additionally, we propose a cost model for the A-tree. We verify the validity of the cost model for synthetic and real data sets. Edited by T. Sellis. Received: December 8, 2000 / Accepted: March 20, 2002 Published online: September 25, 2002