Effect of refraction on optical microscopic measurement of internal blood-vessel diameter and its correction

In optical microscopic measurement of internal blood-vessel diameters, the effect of refraction must be taken into account to ensure accuracy of the result. This effect is discussed and an analytical correction formula derived. Phantom blood vessels with known internal and external diameters were used to test the validity of the correction formula. The errors obtained prior to correction were reduced significantly after correction.     

A simple mathematical analysis on the effect of sand in Cr(VI) reduction using zero valent iron

A simple mathematical model was proposed to analyze the enhancement of Cr(VI) reduction when sand materials are added to the zero valent iron (ZVI). Natural decay of Cr(VI) in a control experiment was analyzed by using a zero-order decay reaction. Adsorption kinetics of Cr(VI) to sand was modeled as a first-order reversible process, and the reduction rate by ZVI was treated as a first-order reaction. Natural decay of Cr(VI) was also included in other experiments, i.e., the adsorption to sand, the reduction by ZVI, and both adsorption and reduction when sand and ZVI are present together. The model parameters were estimated by fitting the solution of each model to the corresponding experimental data. To observe the effect of sand addition to ZVI, both adsorption and reduction rate models were considered simultaneously including the natural decay. The solution of the combined model was fitted to the experimental data to determine the first-order adsorption and reduction rate constants when sand as well as ZVI is present. The first-order reduction rate constant in the presence of sand was about 35 times higher than that with ZVI only.     

Further results on local stability of REM algorithm with time-varying delays

This letter presents some further results on the local stability in equilibrium for Internet congestion control algorithm proposed by Low et al., (IEEE/ACM Transactions on Networking, 1999). The propagation delay d(t) is assumed to be time-varying and have maximum and minimum delay bounds (i.e., d/sub m//spl les/d(t)/spl les/d/sub M/), which is more general than the assumption (0相似文献   

Face recognition using elastic local reconstruction based on a single face image

In this paper, we propose a new face recognition algorithm based on a single frontal-view image for each face subject, which considers the effect of the face manifold structure. To compare two near-frontal face images, each face is considered a combination of a sequence of local image blocks. Each of the image blocks of one image can be reconstructed according to the corresponding local image block of the other face image. Then an elastic local reconstruction (ELR) method is proposed to measure the similarities between the image block pairs in order to measure the difference between the two face images. Our algorithm not only benefits from the face manifold structure, in terms of being robust to various image variations, but also is computationally simple because there is no need to build the face manifold. We evaluate the performance of our proposed face recognition algorithm with the use of different databases, which are produced under various conditions, e.g. lightings, expressions, perspectives, with/without glasses and occlusions. Consistent and promising experimental results were obtained, which show that our algorithm can greatly improve the recognition rates under all the different conditions.     

人脸识别研究进展

人脸识别技术在各种应用的推动下发展很快。而近几年中，为避免各种实际应用环境的限制，非约束环境下的人脸识别也得到了很大的发展。本文概述了人脸识别的一些主要方法，讨论了影响人脸识别的几个主要因素及其处理方法以及基于视频的人脸识别技术，最后指出了鲁棒的人脸识别技术的研究方向和发展前景。     

Implementation of a mechanics-based system for estimating the strength of timber

The most accurate way of determining the strength of lumber requires destructive testing. An intelligent mechanics-based lumber-grading system was developed to provide a better estimation of the strength of a board nondestructively. This system processed X-ray-extracted geometric features (of 1080 boards that eventually underwent destructive strength testing) by using finite element methods to generate associated stress fields. The stress fields were then fed to a feature-extracting-processor, which produced 26 strength predicting features. The best strength predicting features were determined from the coefficient of determination (correlation r/sup 2/) between the features and actual strengths of the boards. The coefficients of determination of each feature (or combination of features), with the actual strength of the board, were calculated and compared. A coefficient of determination of 0.4158 was achieved by using a longitudinal (along the local grain angle) maximum stress concentration (MSC) feature to predict the estimated strength of lumber.     

Reliability Analysis of Single-Degree-of-Freedom Elastoplastic Systems. II: Suboptimal Excitations

A method for constructing an approximation of the critical excitation that drives an elastoplastic system from rest to a target threshold at a specified time instant, referred to as the “suboptimal excitation,” is presented in this paper. It is based on the observations gained from study of the critical excitations in the companion paper. Essentially, for the usual case of interest where the failure time is not small compared to the natural period, the duration of the positive and negative pulses of the critical excitation are roughly equal to half of the natural period. This consideration allows for a simple intuitive approximation of the critical excitation. The amplitudes of the positive and negative pulses are obtained in closed forms using energy balance. Numerical investigations show that the critical excitations are well approximated by the suboptimal excitations.     

Free-Edge and Ply Cracking Effect in Angle-Ply Laminated Composites Subjected to In-Plane Loads

This paper presents a semianalytical method for the prediction of interlaminar stresses and displacements near the free edges and ply cracks in general angle-ply laminates subjected to biaxial extensions and/or in plane shear deformation. The method is based on a state space representation of the three-dimensional equations of elasticity. Numerical solutions are obtained by using layer refinement in the through thickness direction and Fourier series expansion in the other directions. By this approach, an angle-ply laminate may be composed of an arbitrary number of monoclinic layers and each layer may have different material property and thickness. This method guarantees continuous fields of all interlaminar stresses across interfaces between material layers. Numerical results are compared with those obtained from other methods. It is found that the theory provides a satisfactory approximation to the stress singularities near the free edges and ply cracks. Numerical solutions for antisymmetric laminates under extension and general laminates under shearing are new in the literature and can be used as benchmarks for validating new models.     

Supramedullary modulation of sympathetic vasomotor function

1. Supramedullary structures including the ventral medial prefrontal cortex (MPFC) and the midbrain cuneiform nucleus (CnF) project directly and indirectly to premotor sympatho-excitatory neurons of the rostral ventrolateral medulla (RVLM) that are critically involved in the generation of sympathetic vasomotor tone. 2. Electrophysiological studies have demonstrated that activation of depressor sites within the MPFC is associated with splanchnic sympathetic vasomotor inhibition and inhibition of the activity of RVLM sympathoexcitatory neurons. 3. Antidromic mapping and anatomical studies support the notion that a relay in the nucleus tractus solitarius is involved in the cardiovascular response to MPFC stimulation. 4. The midbrain CnF, which lies adjacent to the midbrain periaqueductal grey, is a sympathoexcitatory region of the midbrain reticular formation. Sympathoexcitatory responses evoked from the CnF are associated with short-latency excitation of RVLM neurons. 5. Cuneiform nucleus stimulation induces the expression of mRNA for the immediate early genes c-fos and NGFI-A in mid-brain, pontine and hypothalamic structures. 6. The MPFC and CnF are supramedullary structures with opposing modulatory influences on sympathetic vasomotor drive, whose roles in cardiovascular control mechanisms warrant further investigation.