WiMAX系统中载波与采样钟同步的研究

IEEE802．16协议采用的OFDMA技术提供了两种子信道使用方式，分别为FUSC和PUSC，结合FUSC的固有结构特点，对导频配置方法和采样钟同步算法进行更深入的忱化。提出了一种更精确的载波和采样钟同步方案。仿真结果表明，此方案所得到的载波同步估计值比普通算法更加准确，同步性能也随之有了很大的改善。     

Intermittent Phenomena in Switched Systems With High Coupling Strengths

In this paper, one kind of intermittency generated by a discontinuous system is studied. Although this system, which is composed of two switched subsystems coupled with a high strength, is nonsmooth, the mechanism of this kind of intermittency can be analyzed with several explicit relations between the intermittency characteristics and the system control parameters. In particular, estimates of "steady-state" values of the system (in the laminar phases) and a critical value for this intermittency can be derived, which are helpful in relevant control systems design. Moreover, some power laws for the observed intermittency are obtained and discussed     

预应力钢-混凝土组合梁的应用与研究

回顾了预应力钢 混凝土组合梁国内外应用与研究历史 ,分析了现有规范及理论的不足 ,并指出了有待解决的问题。     

低乙烯含量抗冲聚丙烯的结构表征

采用二甲苯为溶剂，将不同乙烯含量（５％￣１５％质量）的抗冲聚丙烯用特定程序进行分级，将各样品分为室温下可溶于甲苯和不可溶于甲苯的两部分。使用＾１３Ｃ－ＮＭＲ方法和ＦＴ－ＩＲ方法对各组分进行表征，明确了乙烯链段在聚丙烯链上的分布，并在此基础上提出了产生这种链结构的聚合工艺的特点。     

Stress distribution on [100] Si wafer mapped by novel I-V analysis of MOS tunneling diodes

The current-voltage (I-V) characteristics of metal-oxide-semiconductor tunneling diodes distributed over a 3-in Si wafer were analyzed to investigate the stress distribution on the wafer. Generally, the substrate injection saturation current (J/sub sat/) decreases as the gate injection leakage current (J/sub g/) increases, the latter being dominated by oxide thickness via a trap related mechanism. A universal curve to fit all analyzed data was found and it is suggested that devices with extremely high (low) J/sub sat/ at a given J/sub g/ should be located in areas of the silicon lattice with relatively high external compressive (tensile) stress because of the stress-induced bandgap variation effect. The mapped locations of the highly stressed devices on a 3-in [100] Si wafer correspond to the patterns of slips caused by thermal stress during rapid thermal processing, as described in previous reports.     

螺旋翅片管的换热计算

本文引入区域平均表面传热系数的概念。在实验研究的基础上进行了肋基和肋端温度分布预测及肋片换热数值计算。     

烃类在三甘醇和四甘醇中无限稀释活度系数的测定与关联

用气相色谱法分别测定了苯、甲苯、乙苯、正庚烷、正辛烷、正壬烷和正癸烷在三甘醇和四甘醇中的无限稀释活度系数 ,测定温度范围为 5 0～ 13 0℃。用修正的UNIFAC模型 (Dortmund)对上述不同温度下的无限稀释活度系数实验数据进行关联 ,得到了三甘醇和四甘醇与其它基团的相互作用参数 ,并将计算结果与实测值进行了比较。     

智能温湿度测控仪

本文提出一种利用MCS-51系列单片机实现温湿度自动检测和控制的智能仪表,文中对仪器的工作原理、硬件组成和软件设计作了较为详细的介绍。     

Synthesis of ultrafine LiCoO2 powders by the sol-gel method

Ultrafine high-temperature (HT) LiCoO₂ powders were synthesized by the sol-gel method using polyacrylic acid (PAA) as a chelating agent. The decomposition process of the gel precursor was examined to determine the crystallization temperature and the dependence of the physicochemical properties of HT-LiCoO₂ powders on the PAA quantity was extensively investigated. Polycrystalline HT-LiCoO₂ powders, composed of very uniformly sized ultrafine particulates with an average particle size of 30–50 nm and a specific surface area of 2.3–17 m²g^–1, could be obtained at the lower calcination temperature of 550 °C and the shorter calcination time of 1 h compared to the solid-state reaction.     

CAD OF MILLIMETER WAVE OSCILLATORS WITH THE FDHB TECHNIQUE

In this paper the modelling, analysis and optimization of millimeter wave oscillatorsare investigated by using the a frequency-domain harmonic balance technique (FDHB), where theexternal-circuit impedances looking outside from the active device are calculated with a combinedtechnique of modes expansion, Galerkin, and collocation methods. The optimization results arein agreement with the experimental ones, which show the reliability of the presented model andoptimization.