Structural Characteristics and Electrical Conductivity of Spark Plasma Sintered Ytterbia Co‐doped Scandia Stabilized Zirconia

The effect of replacing Sc₂O₃ with Yb₂O₃ on the structural and electrical properties of xYb₂O₃–(12–x)Sc₂O₃–88ZrO₂ has been investigated. Spark plasma sintering technique is employed to fabricate dense bulk samples from the nano‐sized powders. X‐ray diffraction and transmission electron microscopy performed on pellets indicate the existence of cubic and rhombohedral phases in 12ScSZ, and a single cubic phase in all the co‐doped compositions. However, Raman spectroscopic studies suggest the presence of a metastable tetragonal t″‐phase along with rhombohedral phases in 12ScSZ, whereas a single cubic phase in all the co‐doped compositions. Significant enhancement in the conductivity of grain and grain boundary is observed on replacing Sc₂O₃ with Yb₂O₃. In the intermediate temperature range, 1Yb11ScSZ exhibits the highest, while 12ScSZ shows the lowest conductivity values, which is attributed to corresponding phases present in that range. Through co‐doping with >1 mol% Yb₂O₃ leads to conductivity decrease, but the value remains higher than that of 12ScSZ. A sharp conductivity change is observed in 12ScSZ and 1Yb11ScSZ samples, which is attributed to partial phase transition as well to the formation of cation‐vacancy complexes. In this work, the beneficial effect of Yb₂O₃ co‐doping in 12ScSZ on the phase and conductivity has been highlighted.     

Highly selective homogeneous ethylene epoxidation in gas (ethylene)‐expanded liquid: Transport and kinetic studies

Recently a homogeneous liquid‐phase ethylene oxide (EO) process with nearly total EO selectivity, catalyzed by methyltrioxorhenium with H₂O₂ as an oxidant, was reported. Fundamental mass transfer and kinetic studies of this reaction are reported in the present work. Volumetric expansion studies revealed that the liquid reaction phase (methanol + H₂O₂/H₂O) is expanded by up to 12% by compressed ethylene in the 20–40^°C range and up to 50 bars. This represents an increase in ethylene solubility by approximately one‐order of magnitude, attributed to the unique exploitation of near‐critical ethylene (P_c = 50.76 bar; T_c = 9.5^°C). Interphase mass‐transfer coefficients for ethylene dissolution into the liquid phase were obtained experimentally. Operating at conditions that enhanced the ethylene solubility and eliminated interphase mass‐transfer limitations maximized the EO productivity (1.61–4.97 g EO/h/g cat), rendering it comparable to the conventional process. Intrinsic kinetic parameters, estimated from fixed‐time semibatch reactor studies, disclosed the moderate activation energy (57 ± 2 kJ/mol). © 2012 American Institute of Chemical Engineers AIChE J, 59: 180–187, 2013     

An index to characterize gas-solid and solid-solid mixing from average volume fraction fields

A mixing index based on solid volume fraction fields is developed for gas-solid flows. Conventional mixing indices are based on particle realizations of granular mixing and are applicable to experimental data or discrete element method simulations. However, these indices cannot be used as-is for multifluid models, and an index for characterizing mixing in gas-solid flows from continuous fields is needed. The performance of the new mixing index is tested in two applications. The first is a 3D simulation of the mixing of biomass and sand in a fluidized bed reactor, and the second is a 2D simulation of binary particle segregation in a fluidized bed. The simulations are performed using OpenFOAM®. The mixing index is used to quantify gas-solid mixing using solid volume fractions and solid-solid mixing using solid fractions. The formulation of conventional mixing indices is extended to be used with solid volume fractions fields, and methods for performance improvement are presented.     

Thermal and flow properties of oils from salmon heads

Thermal and flow properties of unrefined oils from the heads of red or pink salmon were evaluated. Major thermal degradation of the salmon oils occurred between 200 and 450°C. Red and pink salmon oils were completely decomposed at 533 and 668°C, respectively. The phase transition of salmon oils occurred over a wide range of temperatures. The melting points of −69.6 to −0.36°C and −64.7 to 20.8°C were observed for red and pink salmon oils, respectively. The enthalpy was 40 j/g for red salmon oil and 39 j/g for pink salmon oil. Specific heat capacity ranges of 0.8 to 1.6 and 1.3 to 2.3 j/g/°C were observed for red and pink salmon oils, respectively. Both salmon oils exhibited Newtonian flow behavior. Red salmon oil required higher magnitudes of energy (kj·mol⁻¹) to flow than pink salmon oil. The viscosity of salmon oils was temperature-dependent and could be predicted by the Arrhenius equation.     

Toward a CO2-free ethylene oxide process: Homogeneous ethylene oxide in gas-expanded liquids

Among industrial chemical processes, ethylene oxide manufacture emits the largest amount of CO₂ (∼2-3 million tons/yr), as byproduct from the burning of both the ethylene (feed) and ethylene oxide. Further, the conventional silver-based catalytic process presents safety challenges due to the formation of explosive ethylene oxide/O₂ mixtures in the gas phase. By judicious choice of the catalyst (methyltrioxorhenium), oxidant (H₂O₂) and reaction medium (methanol/water), a homogeneous liquid phase catalytic system has been demonstrated that eliminates CO₂ formation while producing ethylene oxide at >90% selectivity at near-ambient temperatures. Given its high volatility, the ethylene oxide is easily recovered from the reaction phase by distillation. The vicinity of the gaseous ethylene feed to its critical temperature (9 °C) is exploited to significantly increase its solubility in the liquid reaction phase by facile compression beyond the critical pressure of ethylene (∼50 bar). Since H₂O₂ is stable at typical reaction temperatures (40 °C or less), potentially explosive ethylene oxide/O₂ mixtures are avoided in the gas phase. In addition to the potential of arresting the carbon footprint of a large-scale industrial process, the demonstrated process concept shows how gas-expanded liquids can be generally exploited in homogeneous catalysis to enhance productivity.     

Rind of the rambutan, Nephelium lappaceum, a potential source of natural antioxidants

The rind of rambutan, which is normally discarded was found to contain extremely high antioxidant activity when assessed using several methods. Although having a yield of only 18%, the ethanolic rambutan rind extract had a total phenolic content of 762 ± 10 mg GAE/g extract, which is comparable to that of a commercial preparation of grape seed extract. Comparing the extract’s pro-oxidant capabilities with vitamin C, α-tocopherol, grape seed and green tea, the rind had the lowest pro-oxidant capacity. In addition, the extract at 100 μg/ml was seen to limit oxidant-induced cell death (DPPH at 50 μM) by apoptosis to an extent similar to that of grape seed. The extracts were not cytotoxic to normal mouse fibroblast cells or splenocytes while the powderised rind was seen to have heavy metals contents far below the permissible levels for nutraceuticals. Our study for the first time reveals the high phenolic content, low pro-oxidant capacity and strong antioxidant activity of the extract from rind of Nephelium lappaceum. This extract, either alone or in combination with other active principles, can be used in cosmetic, nutraceutical and pharmaceutical applications.     

Harmonic filter design using actual recorded data

This work presents a study of a harmonic filter design that minimizes harmonic distortion caused by harmonic sources such as drives. Several types of shunt harmonic filters are presented. The analysis includes the basic principles, the application of the Z-bus method and the economic aspects affecting the harmonic filter design. Offline steady state simulation programs, namely, V-HARM and HARMFLO, are used to model loads, to study variation of the harmonics, and to evaluate the effect of harmonic filters at various buses in the system. Several existing utility systems are used as test cases to check the performance of the filter. The major objectives in this study are (i) to improve the power factor, (ii) to reduce current and voltage distortion to standard limits, and (iii) to reduce resonance problems at other buses, if any. The transient analysis of harmonic filters using the Electromagnetic Transients Program (EMTP), which is essential to determine proper ratings of the filter components, is also reported     

Control of polishing of diamond films using microactuation and an atmospheric pressure plasma

In this work, the diamond deposited by hot filament chemical vapor deposition (CVD) is polished using an atmospheric pressure plasma. In order to position the film relative to the plasma, a microactuator system is designed using a stack of domed piezoelectric actuators. A dynamic model based on the physical system is developed and the model parameters are measured experimentally. A system based on laser triangulation is used to measure the position of the diamond film relative to the plasma. Control techniques are used to reduce the oscillations during actuation and to eliminate the steady state positioning error. With the application of feedback control, the overshoot is reduced to 2% and the settling time is reduced to 0.3 s. A preliminary set of experiments is performed to relate process parameters to the final surface roughness of the diamond film. The parameters studied include the film's time of exposure to the plasma, the height of the film relative to the plasma, and the distance from the film to the center of the plasma. It is found that the optimum exposure time is 15 min and the reduction of surface roughness is greatest when the distance between the film and the plasma is at a minimum. The best results are obtained when the top of the film is even in elevation with the tip of the top electrode. The diamond film is translated laterally along the plasma. When feedback control is not used, there is no change in the surface roughness. With feedback control implemented, the surface roughness of the diamond film is reduced by 33%.     

The carboxyl terminus of interferon-gamma contains a functional polybasic nuclear localization sequence

Cytokines such as interferon-gamma (IFN-gamma), which utilize the well studied JAK/STAT pathway for nuclear signal transduction, are themselves translocated to the nucleus. The exact mechanism for the nuclear import of IFN-gamma or the functional role of the nuclear translocation of ligand in signal transduction is unknown. We show in this study that nuclear localization of IFN-gamma is driven by a simple polybasic nuclear localization sequence (NLS) in its COOH terminus, as verified by its ability to specify nuclear import of a heterologous protein allophycocyanin (APC) in standard import assays in digitonin-permeabilized cells. Similar to other nuclear import signals, we show that a peptide representing amino acids 95-132 of IFN-gamma (IFN-gamma(95-132)) containing the polybasic sequence 126RKRKRSR132 was capable of specifying nuclear uptake of the autofluorescent protein, APC, in an energy-dependent fashion that required both ATP and GTP. Nuclear import was abolished when the above polybasic sequence was deleted. Moreover, deletions immediately NH2-terminal of this sequence did not affect the nuclear import. Thus, the sequence 126RKRKRSR132 is necessary and sufficient for nuclear localization. Furthermore, nuclear import was strongly blocked by competition with the cognate peptide IFN-gamma(95-132) but not the peptide IFN-gamma(95-125), which is deleted in the polybasic sequence, further confirming that the NLS properties were contained in this sequence. A peptide containing the prototypical polybasic NLS sequence of the SV40 large T-antigen was also able to inhibit the nuclear import mediated by IFN-gamma(95-132). This observation suggests that the NLS in IFN-gamma may function through the components of the Ran/importin pathway utilized by the SV40 T-NLS. Finally, we show that intact IFN-gamma, when coupled to APC, was also able to mediate its nuclear import. Again, nuclear import was blocked by the peptide IFN-gamma(95-132) and the SV40 T-NLS peptide, suggesting that intact IFN-gamma was also transported into the nucleus through the Ran/importin pathway. Previous studies have suggested a direct intracellular role for IFN-gamma in the induction of its biological activities. Based on our data in this study, we suggest that a key intracellular site of interaction of IFN-gamma is the one with the nuclear transport mechanism that occurs via the NLS in the COOH terminus of IFN-gamma.