An ant swarm-inspired energy-aware routing protocol for wireless ad-hoc networks

Primitive routing protocols for ad-hoc networks are “power hungry” and can therefore consume considerable amount of the limited amount of battery power resident in the nodes. Thus, routing in ad-hoc networks is very much energy-constrained. Continuous drainage of energy degrades battery performance as well. If a battery is allowed to intermittently remain in an idle state, it recovers some of its lost charge due to the charge recovery effect, which, in turn, results in prolonged battery life.In this paper, we use the ideas of naturally occurring ants’ foraging behavior (Dorigo and Stuetzle, 2004) [1] and based on those ideas, we design an energy-aware routing protocol, which not only incorporates the effect of power consumption in routing a packet, but also exploits the multi-path transmission properties of ant swarms and, hence, increases the battery life of a node. The efficiency of the protocol with respect to some of the existing ones has been established through simulations. It has been observed that the energy consumed in the network, the energy per packet in the case of EAAR are 60% less compared to MMBCR and the packets lost is only around 12% of what we have in AODV, in mobility scenarios.     

Connectivity preserving localized coverage algorithm for area monitoring using wireless sensor networks

Efficient network coverage and connectivity are the requisites for most Wireless Sensor Network (WSN) deployments, particularly those concerned with area monitoring. Due to the resource constraints of the sensor nodes, redundancy of coverage area must be reduced for effective utilization of the available resources. If two nodes have the same coverage area in their active state, and if both the nodes are activated simultaneously, it leads to redundancy in network and wastage of precious sensor resources. In this paper, we address the problem of network coverage and connectivity and propose an efficient solution to maintain coverage, while preserving the connectivity of the network. The proposed solution aims to cover the area of interest (AOI), while minimizing the count of the active sensor nodes. The overlap region of two sensor nodes varies with the distance between the nodes. If the distance between two sensor nodes is maximized, the overall coverage area of these nodes will also be maximized. Also, to preserve the connectivity of the network, each sensor node must be in the communication range of at least one other node. Results of simulation of the proposed solution indicate up to 95% coverage of the area, while consuming very less energy of 9.44 J per unit time in the network, simulated in an area of 2500 m².     

A learning automata-based fault-tolerant routing algorithm for mobile ad hoc networks

Reliable routing of packets in a Mobile Ad Hoc Network (MANET) has always been a major concern. The open medium and the susceptibility of the nodes of being fault-prone make the design of protocols for these networks a challenging task. The faults in these networks, which occur either due to the failure of nodes or due to reorganization, can eventuate to packet loss. Such losses degrade the performance of the routing protocols running on them. In this paper, we propose a routing algorithm, named as learning automata based fault-tolerant routing algorithm (LAFTRA), which is capable of routing in the presence of faulty nodes in MANETs using multipath routing. We have used the theory of Learning Automata (LA) for optimizing the selection of paths, reducing the overhead in the network, and for learning about the faulty nodes present in the network. The proposed algorithm can be juxtaposed to any existing routing protocol in a MANET. The results of simulation of our protocol using network simulator 2 (ns-2) shows the increase in packet delivery ratio and decrease in overhead compared to the existing protocols. The proposed protocol gains an edge over FTAR, E2FT by nearly 2% and by more than 10% when compared with AODV in terms of packet delivery ratio with nearly 30% faulty nodes in the network. The overhead generated by our protocol is lesser by 1% as compared to FTAR and by nearly 17% as compared to E2FT when there are nearly 30% faulty nodes.     

Polyaniline as a Gas-Sensor Material

Polyaniline (PANI) was synthesized by oxidative polymerization of aniline using ammonium persulfate in an acid medium. The polyaniline salt was converted to base form by treatment with ammonium hydroxide. The polyaniline base was dissolved in N-methyl pyrrolidone (NMP) for film casting. The cast film was doped with HCl for obtaining higher conductivity. Both doped and undoped PANI films were characterized by UV-visible, FTIR, and XRD analyses. The electrical conductivity of the PANI film was studied by a four-point probe method at room temperature. Finally, ammonia gas-sensing characteristics of the prepared polyaniline film were studied by measuring the change in electrical conductivity on exposure to ammonia gas at different concentrations. The influence of concentration of acid during polymerization of aniline and dopant concentration on the gas sensing characteristics of PANI film are reported in this paper.     

Common entanglement witnesses and their characteristics

We investigate the issue of finding common entanglement witness for certain class of states and extend this study to the case of Schmidt number witnesses. We also introduce the notion of common decomposable and non-decomposable witness operators which is specially useful for constructing a common witness where one of the entangled states is with a positive partial transpose. Our approach is illustrated with the help of suitable examples of qutrit systems.     

Effect of the surface roughness of conducting polypyrrole thin-film electrodes on the electrocatalytic reduction of nitrobenzene

Conducting polypyrrole (PPy) thin-film electrodes were prepared by the electropolymerization of pyrrole on gold-coated glass plates. Films of various roughnesses were obtained by the variation of the scan rates during electropolymerization. These thin films were modified by doping with 6mM of the dopant NiCl₂. The surface morphology of the films was studied by scanning electron microscopy and atomic force microscopy (AFM), which suggested films prepared with a high scan rate were rougher in nature than the films produced with a low scan rate. The electrocatalytic reduction of nitrobenzene was carried out with these electrodes with the cyclic voltammetry technique in acetonitrile containing 0.1M HClO₄ as a supporting electrolyte. The various results obtained show that the conducting PPy thin-film electrodes were catalytically active toward the electroreduction process. The modified PPy film electrodes doped with NiCl₂ were more active toward nitrobenzene electroreduction than the PPy film alone. The results indicate that the roughness of the films played a very important role in determining their catalytic activity. The PPy films that were more rough in nature were catalytically more active than the smooth films; this may have been due to the availability of more reactive sites in the case of rough films. The apparent diffusion coefficients of the PPy film electrodes were also calculated. © 2012 Wiley Periodicals, Inc. J Appl Polym Sci, 2012     

Evaluation of fire performance of organic fire retardant free acrylic based coatings applied on various building materials by cone calorimetric method

Fire performance of water‐based plaster systems containing acrylic copolymer binder and non‐flammable mineral and ceramic fillers intended for decorative coating application was determined by cone calorimetric method. The coatings were applied on common building substrate materials used in construction sector, namely, Medium Density Fibre (MDF) boards, Gypsum Boards (GIB) and Stainless Steel (SS), and the different plaster finishes attempted on these substrates were Tierrafino, Suave and Bone China respectively. Group numbers of the different test samples were also evaluated following the Kokkala method. Based on various measurements, especially heat release, smoke evolution, mass loss data and the Group number estimates, it is evident that these organic fire retardant free coatings can offer good fire safety if applied on appropriate substrates like GIB or SS. Copyright © 2016 John Wiley & Sons, Ltd.     

Hydrodynamic dispersion of reactive solute in a Hagen-Poiseuille flow of a layered liquid

An analysis of the solute dispersion in the liquid flowing through a pipe by means of Aris-Barton's ⒈method of moments',under the joint effect of some finite yield stress and irreversible absorption into the wall is presented in this paper.The liquid is considered as a three-layer liquid where the center region is Casson liquid surrounded by Newtonian liquid layer.A significant change from previous modelling exercises in the study of hydrodynamic dispersion,different molecular diffusivity has been considered for the different region yet to be constant.For all time period,finite difference implicit scheme has been adopted to solve the integral moment equation arising from the unsteady convective diffusion equation.The purpose of the study is to find the dependency of solute transport coefficients on absorption parameter,yield stress,viscosity ratio,peripheral layer variation and in addition with various diffusivity coefficients in different liquid layers.This kind of study may be useful for understanding the dispersion process in the blood flow analysis.     

Antioxidant effect of turmeric powder,nitrite and ascorbic acid on stored chicken mince

This investigation was carried out to evaluate the antioxidant effect of turmeric (turmeric 1000 ppm, turmeric 5000 ppm), nitrite (nitrite 200 ppm) and ascorbic acid (ascorbic acid 500 ppm) on raw minced chicken stored at 4 ± 1 °C. Physicochemical properties [pH, water activity, cooking loss, thiobarbituric acid (TBA) value, peroxide value (PV), free fatty acid (FFA)] were evaluated on 0, 2, 4 and 6th day of storage. Highly significant differences (P < 0.01) in pH, TBA value, PV and FFA value were noticed between treatments and between storage periods. TBA values were observed to be lowest for nitrite 200 ppm and then turmeric 5000 ppm, and there was no significant difference between nitrite 200 ppm and turmeric 5000 ppm, and both were superior to ascorbic acid 500 ppm and turmeric 1000 ppm. Among different treatments, PV was found to be lowest in turmeric 5000 ppm and highest in nitrite 200 ppm. FFA value was found to be lowest in turmeric 5000 ppm and highest in ascorbic acid 500 ppm among all treated samples. It can be concluded that turmeric has potential to replace synthetic antioxidants presently used in meat processing with many added advantages.     

Vibration frequency of graphene based composites: A multiscale approach

This paper presents a multiscale approach for vibration frequency analysis of graphene/polymer composites. The graphene is modelled at the atomistic scale, and the matrix deformation is analysed by the continuum finite element method. Inter-connectivity between graphene and polymer matrix are assumed to be bonded by van der Waals interactions at the interface. The impact of geometrical configuration (armchair and zigzag), boundary conditions and length on the overall stiffness of the graphene reinforced plastics (GRP) is studied. The natural frequency and vibrational mode shapes of GRP studied have displayed dependence on the length and also the boundary conditions. The exceptional vibrational behaviour and large stiffness displayed by GRP makes them a potential replacement for conventional composite fibres such as carbon and glass fibres.