Fluid flow characterization with tube viscometer data

Pressure gradients and the corresponding mass flow rates of five different non-Newtonian fluid foods: 1% solutions of sodium alginate and CMC, 1.5% CMC solution, two different tomato ketchups, oyster sauce, in four different diameter stainless steel tubes ranging from 7.51 to 16.34 mm i.d. were recorded using a tube viscometer capable of operating in both transient and continuous flow modes. The flow was confined to the laminar flow regime and appreciable slippage occurred in all cases. Power law parameters for the tube flow obtained from the plots of wall shear stress versus apparent wall shear rate are presented for various time-independent fluids in different diameter tubes in original and slip-corrected forms. Such experimental data should prove useful in developing an understanding of flow characterization of non-Newtonian fluids.     

Generalized form of optimal teleportation witnesses

We propose a generalized form of optimal teleportation witness to demonstrate their importance in experimental detection of the larger set of entangled states useful for teleportation in higher dimensional systems. The interesting properties of our witness reveal that teleportation witness can be used to characterize mixed state entanglement using Schmidt numbers. Our results show that while every teleportation witness is also a entanglement witness, the converse is not true. Also, we show that a hermitian operator is a teleportation witness iff it is a decomposable entanglement witness. In addition, we analyze the practical significance of our study by decomposing our teleportation witness in terms of Pauli and Gell-Mann matrices, which are experimentally measurable quantities.     

Screening selected strains of probiotic lactic acid bacteria for their ability to produce biogenic amines (histamine and tyramine)

The aim of this study was to investigate the production of biogenic amines (BA), histamine and tyramine by some probiotic lactic acid bacteria (LAB). Fifteen strains representing six LAB species were screened qualitatively by growing them in a decarboxylase medium. Quantitative analysis was carried out by HPLC analysis with direct derivatization of acid extracts. Lactobacillus casei (TISTR 389) and Lactobacillus delbrueckii subsp. bulgaricus (TISTR 895) were found to produce BA. The highest levels of histamine (1820.9 ± 3.5 mg L^?1) and tyramine (5486.99 ± 47.6 mg L^?1) formation were observed for the TISTR 389 strain, while TISTR 895 produced only histamine (459.1 ± 0.63 mg L^?1) in the decarboxylase broth. Biogenic amine potential was not observed for the Lactobacillus acidophilus, Lactobacillus lactis subsp. lactis, Lactococcus lactis subsp. lactis, and Lactobacillus plantarum strains studied. This study confirmed that BA formation is strain dependent and not related to the species. Therefore, careful screening for amino acid decarboxylase activity is recommended before selecting LAB as appropriate starter or probiotic strains in food and dairy industry.     

Kinetics and Reactor Modeling of Hydrogen Production from Glycerol via Steam Reforming Process over Ni/CeO2 Catalysts

As a result of skyrocketing prices, environmental concerns and depletion associated with fossil fuels, renewable fuels are becoming attractive alternatives. In this respect, the demand for biodiesel has increased tremendously in recent years. Increased production of biodiesel has resulted in a glut of glycerol that has reduced the demand for this once valuable commodity. Consequently, finding alternative uses for glycerol is a timely proposition. One alternative is producing renewable hydrogen from this cheap commodity. Only a handful of studies have been conducted on producing hydrogen from glycerol. Previous studies have mainly focused on finding effective catalysts for glycerol steam reforming. This paper extends previous knowledge by presenting kinetic parameters in relation to glycerol steam reforming over Ni/CeO₂ and a reactor modeling. The study found that the activation energy and the reaction order for the glycerol steam reforming reaction over Ni/CeO₂ catalyst were 103.4 kJ/mol and 0.233, respectively.     

Effects of Solvents, Temperature, and Plasticizer on Film Coating of Tablets

The effects of solvent composition, temperature, solvent retention, plasticizers, and polishing on the disintegration and percent dissolution of various nonaqueous film coated tablets were studied. A mixture of isopropanol-dichloromethane used as solvent systems for the film coating of ranitidine hydrochloride tablets resulted in reduced film peel-off time, decreased disintegration time, and increased percent dissolution. The effect of prewarming the coating bed of cimetidine tablets revealed an increase in percent dissolution compared to no prewarming condition. In contrast, an increase in temperature of the tablet bed resulted in higher disintegration time and lower percent dissolution of ibuprofen tablets. Ranitidine hydrochloride film coated tablets polished with polyethylene glycol showed lower disintegration time and higher percent dissolution than those polished with beeswax. The presence of plasticizer in the coating solution resulted in decreased disintegration time and higher percent dissolution for norfloxacin tablets.     

Thermoreversible gelation of poly[hexyl isocyanate]: Effect of solvent type

The thermoreversible gelation of poly[hexyl isocyanate] (PHIC), a rather stiff polymer, has been studied in two closely-related solvents of the alcane series, namely heptane and octane. Temperature-concentrations phase diagrams have been established for both systems. The occurrence of polymer-solvent compound is suggested in heptane but not in octane. This conclusion receives further support from neutron diffraction investigations through the use of the isotopic labelling technique. Finally, it is observed that the morphology is also affected by the solvent type although still displaying a fibrillar network structure.     

Photomechanical degradation of thermoplastic elastomers

The photodegradation of thermoplastic elastomers designed for outdoor applications was studied with laboratory ultraviolet (UV) exposure in the unstrained state and under tensile strain (25 and 50%). Strained exposure caused a reduction of the strain to failure in subsequent tensile tests. For some combinations of material and exposure conditions, some recovery of extensibility occurred between 2 and 4 weeks. Microscopic examination revealed that this was probably due to embrittlement of the surface region that was sufficiently severe that surface cracks did not propagate into the interior and that the observed recovery did not correspond to repair or improvement of the material. Shielding the sample surface from UV irradiation reduced the formation of surface cracking very significantly, and it was deduced that the principal cause of degradation was photooxidation rather than ozone attack. © 2005 Wiley Periodicals, Inc. J Appl Polym Sci 99: 150–161, 2006     

Boron-doped hydrogenated amorphous carbon films grown by surface-wave mode microwave plasma chemical vapor deposition

We report the effects of boron (B) doping on optical and structural properties of the hydrogenated amorphous carbon thin films grown by surface-wave mode microwave plasma (SW-MWP) chemical vapor deposition (CVD) on n-type silicon and quartz substrates at room temperature. Argon and acetylene were used as a carrier and carbon source gases respectively. Analytical methods such as X-ray photoelectron spectroscopy (XPS), Nanopics 2100/NPX200 surface profiler, JASCO V-570 UV/VIS/NIR spectroscopy, Fourier transform infrared spectroscopy (FT-IR) and Raman spectroscopy were employed to investigate the properties of the films. Low atomic concentration of B (0.08 at.%) was found in the doped film. The optical band gap of the undoped film was 2.6 eV and it decreased to 1.9 eV for the B-doped film. Structural property shows the crystalline structure of the film and it has changed after incorporating B as a dopant. The structural modifications of the films leading to being more graphite in nature were confirmed by the Raman and FT-IR characterization.