Photoelectrochemistry of poly(3-methylthiophene), I: Surface morphology and thickness effect

Photocyclovoltammetric experiments with films of poly(3-methylthiophene) under polychromatic light irradiation show a p-type semiconductor behavior in the reduced state, with a flat band potential of 0.18 V. The photocurrent depends on film thickness and surface morphology. Films with different thickness were characterized by scanning electron microscopy, indicating a globular morphology with globule sizes changing according to the charge density used during polymer deposition. The highest photocurrent is observed for the lowest globule diameter. These films were also irradiated with monochromatic light from the electrolyte side and from the substrate side. A higher photocurrent and a photocurrent spectrum matching the absorption spectrum of the reduced form of the polymer is observed on irradiation from the electrolyte side of a 0.7 μm thick film. In contrast, for irradiation from the electrode side, the photocurrent is lower and the spectrum shows a peak at lower energy. These results were interpreted in terms of a delocalized space charge zone, different kinetics for charge transfer and mass transport across the solvent swollen polymer film and different depth of penetration of the light as a function of wavelength.     

既有钢筋混凝土框架结构抗震加固若干问题探讨

针对钢筋混凝土框架结构抗震加固问题的复杂性 ,本文深入分析了抗震加固结构的受力特征 ,探讨了卸荷对加固构件承载力的影响 ,并针对抗震加固后的“隐含危险转移”问题提出了相应的对策。最后 ,提出了抗震加固的基本原则 ,可供结构抗震加固时参考     

SAAB雷达与PROVOX系统的通讯

介绍了SAAB雷达液位计和SAAB雷达系统与上位系统的通讯接口FSC以及PROVOX系统的智能设备接口卡 (IDI)等的基本内容 ,并对SAAB雷达液位计与PROVOX系统通讯的硬件连接和PROVOX系统中关于IDI卡的组态方法进行说明     

电子束和接触式曝光机的混合曝光技术

Ⅰ线光致抗蚀剂可以同时实用电子束和光学系统曝光，在50kV加速电压下，其曝光剂量为50-100μC/cm^2，曝光后在0.7%NaOH溶液内显影1分钟。其灵敏度比PMMA快5倍，分辩率为0.5μm。采用两方法制备CaAsPHEMT：一种用Ⅰ线光致抗蚀剂，对源、漏及栅全部都采用电子束曝光，制备了0.5μm栅长的GaAs PHEMT；另一种将源、漏及栅分割成两部分，其中精细部分由电子束曝光，其余部分由光学系统曝光，用这种方法制备了0.25μm栅长的GaAs PHEMT。Ⅰ     

Use of weibull statistics to quantify property variability in TiAl alloys

Tensile experiments have been performed on specimens of four different investment-cast TiAl-based alloys with variations in casting conditions. The average ductilities obtained in these experiments vary between approximately 0.8 to 2.0 pct plastic strain to failure in tension. By using the three-parameter form of the Weibull relation, with the 0.2 pct offset yield strength as the minimum failure strength, the resulting variability in the data can be quantified and is found to be similar for those alloys with similar microstructural scale (grain size). Large variations in lamellar volume fraction, segregation, and phase distribution have a minor influence on property variability, compared to changes in the scale of the grain structure caused by either variations in cooling rate during casting or the addition of grain refiners.     

用化学腐蚀制备多孔硅太阳电池减反射膜的研究

采用HF HNO3溶液化学腐蚀 ,在硅片上制备减反射效果优良的多孔硅太阳电池减反射膜 ,借助原子力显微镜 (AFM)和X光电子谱 (XPS)对其表面形貌和成分进行观察 ,发现该膜与电化学阳极腐蚀得到的多孔硅具有相似性 ,其主要成分为非化学配比的硅的氧化物SiOx(X <2 )。采用带积分球的光度分光计 ,测得形成多孔硅减反射膜后 ,硅片表面反射率大大下降 ,,在波长 330～ 80 0nm范围反射率只有 1 5～ 2 9%。研究指出这种强减反射作用 ,与多孔硅具有合适的折射率及其多孔特性的光陷阱作用有关     

水蒸汽喷射泵系统实用设计软件的开发

本文在Turboc环境下开发了多级蒸汽喷射泵系统的设计软件，该软件包括了压缩比优化分配、单级喷射泵结构尺寸设计和冷凝器的结构尺寸设计等内容，使设计人员能够根据具体的工艺条件，快速地完成多级喷射泵系统的设计，对于提高多级喷射泵系统的工作稳定性、节省能源具有实际意义。     

Fuzzy versus quantitative association rules: a fair data-driven comparison.

As opposed to quantitative association rule mining, fuzzy association rule mining is said to prevent the overestimation of boundary cases, as can be shown by small examples. Rule mining, however, becomes interesting in large databases, where the problem of boundary cases is less apparent and can be further suppressed by using sensible partitioning methods. A data-driven approach is used to investigate if there is a significant difference between quantitative and fuzzy association rules in large databases. The influence of the choice of a particular triangular norm in this respect is also examined.     

用迭代法消除数字图像放大后的模糊

用迭代法对数字图像经过插值放大后产生的模糊问题进行了研究，把数字图像插值放大造成的模糊看成是点扩散函数与清晰图像卷积的结果，根据插值算法可以得到点扩散函数，由于数字图像解卷积是典型的解线性方程组的问题，用雅可比（Jacobi）迭代法得到了很好的结果。与频谱空间变换的方法相比，迭代法没有分母为0的问题和空间变换过程造成的舍入误差。