Studies on phytosterol oxides. II: Content in some vegetable oils and in French fries prepared in these oils

Hydrogenated rapeseed oil/palm oil blend, sunflower oil and high-oleic sunflower oil, and French fries fried in these oils were assessed for contents of sterol oxidation products. Different oxidation products of phytosterols (7α- and 7β-hydroxy-sito-and campesterol, 7-ketosito- and 7-ketocampesterol, 5α,6α-epoxy-sito- and campesterol, 5β,6β-epoxy-sito-and campesterol, dihydroxysitosterol and dihydroxycampesterol) were identified and quantiated by gas chromatography (GC) and GC-mass spectroscopy. Rapeseed oil/palm oil blend contained 41 ppm total sterol oxides before frying operations. After two days of frying, this level was increased to 60 ppm. Sunflower oil and high-oleic sunflower oil had 40 and 46 ppm sterol oxides, respectively, before frying operations. After two days of frying operations, these levels increased to 57 and 56 ppm, respectively. In addition to campesterol and sitosterol oxidation products, small amounts of 7α- and 7β-hydroxystigmasterol were detected in the oil samples. Total sterol oxides in the lipids of French fries fried at 200°C in rapeseed oil/palm oil blend, sunflower oil, and high-oleic sunflower oil were 32, 37, and 54 ppm, respectively. The levels of total oxidized sterols, calculated per g sample, ranged from 2.4 to 4.0 ppm. In addition to the content of phytosterol oxides, full scan mass spectra of several oxidation products of stigmasterol are reported for the first time. Part of these results were presented at the 86th Annual Meeting of the AOCS, May 7–11, 1995, San Antonio, TX.     

Electrochemical properties of carbon-coated CaWO4 versus Li

Carbon-coated CaWO₄ nano-crystalline phases have been synthesized by ambient temperature solution precipitation method, characterized by X-ray diffraction, SEM and thermogravimetry and their electrochemical properties were studied versus Li metal. Galvanostatic cycling at a current of 60 mA/g in the voltage range 0.005-3.0 V on the 5 wt.% C-coated CaWO₄ gave a reversible capacity of 230 ± 5 mAh/g corresponding to 2.5 mol of Li, which is almost stable from 20 to 50 cycles. Under the same conditions, the 10 wt.% C-coated CaWO₄ showed a capacity of 355 ± 5 mAh/g (3.8 mol of Li) during the initial cycles, but the capacity degraded at a rate of 1.6 mAh/g per cycle in the range 5-100 cycles. A good operating voltage range was found to be 0.005-3.0 V with average discharge and charge potentials being 0.6 and 1.3 V, respectively. Coulombic efficiency in all cases was 96-98%. Cyclic voltammograms compliment the galvanostatic results. Impedance spectral data on the 10 wt.% C-coated CaWO₄ at different voltages during the first and 20th discharge-charge cycle have been interpreted in terms of the variations in the bulk and charge-transfer resistances of the composite electrode. A reaction mechanism involving the formation/decomposition of the oxide bronze, ‘Li_xWO_y’ has been proposed to explain the electrochemical cycling.     

A Scenario Based Impact Assessment of Trace Metals on Ecosystem of River Ganges Using Multivariate Analysis Coupled with Fuzzy Decision-Making Approach

The growing consciousness about the health risks associated with environmental pollutants has brought a major shift in global concern towards prevention of hazardous/trace metals discharge in water bodies. Majority of these trace metals gets accumulated in the body of aquatic lives, which are considered as potential indicators of hazardous content. This results in an ecological imbalance in the form of poisoning, diseases and even death of fish and other aquatic lives, and ultimately affect humans through food chain. Trace metals such as Cd, Cr, Cu, Mn, Ni, Pb and Zn originated from various industrial operations containing metallic solutions and agricultural practices, have been contributing significantly to cause aquatic pollution. The present study develops a novel approach of expressing sustainability of river’s ecosystem based on health of the fish by coupling fuzzy sensitivity analysis into multivariate analysis. A systematic methodology has been developed by generating monoplot, two dimensional biplot and rotated component matrix (using ‘Analyze it’ and ‘SPSS’ software), which can simultaneously identify critical trace metals and their industrial sources, critical sampling stations, and adversely affected fish species along with their interrelationships. A case study of assessing the impact of trace metals on the aquatic life of river Ganges, India has also been presented to demonstrate effectiveness of the model. The clusters pertaining to various water quality parameters have been identified using Principal Component Analysis (PCA) to determine actual sources of pollutants and their impact on aquatic life. The fuzzy sensitivity analysis reveals the cause-effect relationship of these critical parameters. The study suggests pollution control agencies to enforce appropriate regulations on the wastewater dischargers responsible for polluting river streams with a particular kind of trace metal(s).     

Design of novel compact anti-stiction and low insertion loss RF MEMS switch

A novel torsional RF MEMS capacitive switch design on silicon substrate is presented. The optimized switch topology such as reduction in up-state capacitance results in insertion loss better than ?0.1 dB till 20 GHz. Off to on state capacitance ratio is also improved by 18 fold and isolation is better than ?43 dB at 9.5 GHz. The achieved on state return loss is ?38 dB as compared to ?21 dB at 9.5 GHz. An optimized reduction in contact area and use of floating metal layer increases the switching speed from 56 to 46 μsec. It also increases the switch reliability by alleviating the stiction.     

The role of pressure on thin amorphous carbon films deposited using microwave surface wave plasma CVD

We report the effects of gas composition pressure (GCP) on the optical, structural and electrical properties of thin amorphous carbon (a-C) films grown on p-type silicon and quartz substrates by microwave surface wave plasma chemical vapor deposition (MW SWP CVD). The films, deposited at various GCPs ranging from 50 to 110 Pa, were studied by UV/VIS/NIR spectroscopy, atomic force microscopy, Raman spectroscopy, X-ray photoelectron spectroscopy and current–voltage characteristics. The optical band gap of the a-C film was tailored to a relatively high range, 2.3–2.6 eV by manipulating GCPs from 50 to 110 Pa. Also, spin density strongly depended on the band gap of the a-C films. Raman spectra showed qualitative structured changes due to sp³/sp² carbon bonding network. The surfaces of the films are found to be very smooth and uniform (RMS roughness < 0.5 nm). The photovoltaic measurements under light illumination (AM 1.5, 100 mW/cm²) show that short-circuit current density, open-circuit voltage, fill factor and photo-conversion efficiency of the film deposited at 50 Pa were 6.4 μA/cm², 126 mV, 0.164 and 1.4 × 10^− 4% respectively.     

Miscibility behavior of blend of polyesteramides of linseed oil and dehydrated castor oil with poly(methacrylic acid)

Blending of two polymers in solution is a simple and cost‐effective technique to improve upon the physical and mechanical properties of the component polymers through synergism. To obtain maximum synergy in their properties, the component polymers should be miscible with each other on molecular scale. Polymer blends of complex physicomechanical properties are being actively investigated. Poly(methacrylic acid) (PMAA), a commercial polymer, yields transparent, hard, brittle, and water‐sensitive films. It has been blended with natural polymers like dextran, collagen, and gelatin to obtain films with improved physical and mechanical characteristics. Polyesteramides, which are easily synthesized from vegetable seeds oil, a sustainable resource, have found application in surface coatings. These oligomeric products do not make free standing films in the ambient condition. The polyesteramides from vegetable seeds oil can be used to obtain blend with PMMA of improved mechanical and water absorption properties. In this study, linseed oil polyesteramide (LOPEA) and dehydrated castor oil polyesteramide (DCPEA), the source oils with different unsaturation in their fatty acid chains, were blended with PMAA through mixing in solution in the ratio DCPEA/LOPEA: PMAA as 80/20, 70/30, 60/40, 50/50, 40/60, 30/70, and 20/80. In the first instance, the miscibility of the two components was investigated in solution by viscosity and ultrasonic measurements and in solid phase through differential scanning calorimetry (DSC) and scanning electron microscopy (SEM). Moisture absorption by the blend was also studied. DCPEA and LOPEA show immiscibility with PMAA in solution phase while LOPEA with more unsaturation in the fatty acid chain of the oil was found more immiscible than DCPEA. DCPEA shows a narrow miscibility window in the solid phase while LOPEA was found immiscible with PMAA in the solid phase too. Uptake of moisture was found to be markedly reduced in the blends of DCPEA/LOPEA with PMAA. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 103: 1367–1374, 2007:     

Graft copolymerzation of poly(vinyl chloride) with styrene. I. Synthesis and characterization

Graft copolymerization of poly(vinyl chloride) (PVC) partially dehydrochlorinated by heating in nitrobenzene was investigated using styrene as monomer and anhydrous AlCl₃ as cationic initiator in the temperature range of 0–35°C. Effect of monomer, catalyst, and PVC concentration on % graft-on was also evaluated. Introduction of labile sites in PVC by partial dehydrochlorination in nitrobenzene resulted in an increase in % graft-on. Intrinsic viscosity of PVC–g–polystyrene in THF initially increased with an increase in % graft-on. At higher % graft-on a decrease in [η] was observed.     

A novel high power symmetric ZnO/carbon aerogel composite electrode for electrochemical supercapacitor

We present, for the first time, a new material of symmetric electrochemical supercapacitor in which zinc oxide (ZnO) with carbon aerogel (CA) was used as active material. Physical properties of ZnO/CA composite were characterized by X-ray diffraction (XRD) and scanning electron microscopy (SEM). It was found that ZnO has single hexagonal structure and the grain size increases with increase of ZnO compository. The result of cyclic voltammetry indicates that the specific capacitance of ZnO/CA composite in 6 M KOH electrolyte was approximately 25 F/g at 10 mV/s for 2:1 composition. AC impedance analysis reveals that ZnO with carbon aerogel powder enhanced the conductivity by reducing the internal resistance. Galvanostatic charge/discharge measurements were done at various current densities, namely 25, 50, 75, and 100 mA/cm². It was found that the cells have excellent electrochemical reversibility and capacitive characteristics in KOH electrolyte. The maximum capacitance of the ZnO/CA supercapacitor was 500 F/g at 100 mA/cm². It has been observed that the specific capacitance is constant up to 500 cycles at all current densities, which implies that the dendrite formation was controlled.