Fabrication of a new substrate for atomic force microscopic observation of DNA molecules from an ultrasmooth sapphire plate

A new stable substrate applicable to the observation of DNA molecules by atomic force microscopy (AFM) was fabricated from a ultrasmooth sapphire (alpha-Al2O3 single crystal) plate. The atomically ultrasmooth sapphire as obtained by high-temperature annealing has hydrophobic surfaces and could not be used for the AFM observation of DNA. However, sapphire treated with Na3PO4 aqueous solution exhibited a hydrophilic character while maintaining a smooth surface structure. The surface of the wet-treated sapphire was found by x-ray photoelectron spectroscopy and AFM to be approximately 0.3 nm. The hydrophilic surface character of the ultrasmooth sapphire plate made it easy for DNA molecules to adhere to the plate. Circular molecules of the plasmid DNA could be imaged by AFM on the hydrophilic ultrasmooth sapphire plate.     

Sensitivity of an anadically oxidized aluminium film on a surface acoustic wave sensor to humidity

The sensitivity, transient response and sensitivity mechanism of a surface acoustic wave humidity sensor using porous anodically oxidized aluminium (alumina) films as mechanical interfaces have been studied theoretically and experimentally. It is found that the sensitivity of alumina films of 1.0 μm thickness is -0.034 m/(s %RH) and is the same order as that of polyimide films. The transient response of alumina films to humidity is about one order faster than that of polyimide films. For the sensitivity mechanism, the phase-velocity change is attributed to the mechanical perturbation caused by the absorption of water molecules. The equivalent density change of alumina films between 0 and 100%RH is about 0.7%. In addition, the actual stiffness constants of alumina films are two orders less than those of bulk alumina.     

Laser spectroscopic measurement of quenching and doublet mixing rates of the Na(3P(3/2, 1/2)) doublet in a propane-air flame

We have measured the quenching rate of the Na 3P level and the doublet mixing rates of the Na 3P(3/2) and 3P(1/2) levels in a propane-air flame at atmospheric pressure. To obtain these rates, subnanosecond time-resolved fluorescence measurements were made using a mode-locked dye laser and the time-correlated single-photon counting method. Our results are 1.4 x 10(9) s(-1) for the quenching rate and 3.0 x 10(9) s(-1) for the 3P(3/2) --> 3P(1/2) mixing rate.     

Local Epidermal Endocrine Estrogen Protects Human Melanocytes against Oxidative Stress,a Novel Insight into Vitiligo Pathology

As the outermost barrier of the body, skin is a major target of oxidative stress. In the brain, estrogen has been reported synthesized locally and protects neurons from oxidative stress. Here, we explored whether estrogen is also locally synthesized in the skin to protect from oxidative stress and whether aberrant local estrogen synthesis is involved in skin disorders. Enzymes and estrogen receptor expression in skin cells were examined first by quantitative real-time PCR and Western blot analyses. Interestingly, the estrogen synthesis enzyme was mainly localized in epidermal keratinocytes and estrogen receptors were mainly expressed in melanocytes among 13 kinds of cultured human skin cells. The most abundant estrogen synthesis enzyme expressed in the epidermis was 17β-hydroxysteroid dehydrogenase 1 (HSD17β1) localized in keratinocytes, and the most dominant estrogen receptor expressed in the epidermis was G protein-coupled estrogen receptor 1 (GPER1) in melanocytes. To investigate whether keratinocyte-derived estradiol could protect melanocytes from oxidative stress, cultured human primary epidermal melanocytes (HEMn-MPs) were treated with H₂O₂ in the presence or absence of 17β estradiol or co-cultured with HSD17β1 siRNA-transfected keratinocytes. Keratinocyte-derived estradiol exhibited protective effects against H₂O₂-induced cell death. Further, reduced expression of HSD17β1 in the epidermis of skin from vitiligo patients was observed compared to the skin from healthy donors or in the normal portions of the skin in vitiligo patients. Our results suggest a possible new target for interventions that may be used in combination with current therapies for patients with vitiligo.     

Corrosion rate of magnesium and its alloys in buffered chloride solutions

The effect of the buffer capacity of test solution on the corrosion rate of cast pure (>99.95 mass%) and high-purity (>99.9999 mass%) magnesium, and AZ31 and AZ91E has been studied. Their corrosion rates were measured gravimetrically in a pH 6.5 and a pH 9 borate buffer including chloride ions, and in a conventional chloride solution. Except for the AZ91E in the pH 6.5, the corrosion rates of all the examined materials depended solely on the pH of the test solution, although the materials had a variety of purity and alloying elements. Higher buffer capacity probably masked the detrimental effect of the “cathodic impurities”. The corrosion rates measured in the buffers were considered as giving the resistivity of the passive film to anodic reactions. The high-purity magnesium had a fair corrosion resistance even in conventional chloride solution.     

Properties of aqueous solutions of several salts of α,ω-alkanediol disulfates

Several salts of α,ω-sulfates, MO₃SO(CH₂)_n OSO₃M(n=12, 14, 16, 18, and M=Li, Na, and K) were prepared from the corresponding α,ω-alkane diols. The Krafft points of these α,ω-sulfates with common counterion as estimated by electroconductivity measurements increased with the increase of the hydrocarbon chain length, and the effect of the counterions on the Krafft points of the α,ω-sulfates with the same hydrocarbon chain length was in the order : Li<Na<K. Solutions of the α,ω-sulfates, except disodium dodecanediol disulfate, showed two break points corresponding to the first and second critical micelle concentration in each plot of the electroconductivity as a function of the concentration. The existence of the second break point suggested that another aggregation of rearrangement of the existing aggregates occurs in α,ω-sulfate solutions in addition to the usual micelle formation. The first and second break points of α,ω-sulfates with sodium counterion decreased logarithmically with increasing total number of methylene groups. The relationships were given as follows: log(first break point)=−0.138Nc−0.095; log(second break point)=−0.104Nc−0.251. The effect of the counterions upon the break points of α,ω-sulfates with the same hydrocarbon chain length was in accordance with their positions in the lyotropic series.     

Studies on the nuclear magnetic resonance spectra of olefinic protons of conjugated fatty acid methyl esters

The NMR spectra of olefinic protons in the four representative conjugated fatty acid methyl esters, methylcis-9,trans-11-octadecadienoate, methyltrans-9,trans-11-octadecadienoate, methyl α eleostearate, and methyl β eleostearate, were studied. The chemical shift of each olefinic proton in these compounds was determined by considering their intramolecular environment. Coupling constants were also obtained as the results of spectral analysis.     

A novel agglomeration granulating system utilizing a centrifugal-fluidizing drive

Necessary conditions were studied for the optimum operation of agglomeration granulation. The mechanisms that would realize these conditions were investigated by several experiments.On the basis of the results obtained, a novel granulating system involving a surface wetness control mechanism has been developed.The present paper describes the mixing and dispersing characteristics of the coating vessel, the detection method for wetness control, the particular spraying units, and the operating conditions thereof, together with the characteristics of this newly developed powder coating granulation system.This system has been shown to provide an easy and reproducible granulating technique even when products below 1 mm in size are required.     

Gelation of poly(vinyl alcohol)/phenol/water solutions and gel spinning

The light transmittance of the gels of poly(vinyl alcohol) (PVA)/phenol/water solutions was examined for the entire range of phenol/water content. Excellent transparency was found for the gels with phenol contents of 70–95 vol %. In full consideration of the results for the transparency and melting temperature of the gels and the viscosity and gelation ability of solutions, the PVA solutions of 75 vol % phenol content were selected for the gel spinning. The maximum dynamic moduli of drawn filaments at 25°C (room temperature) were 42 GPa (15x) for atactic PVA and 45 GPa (14x) for syndiotacticity-rich PVA. © 1995 John Wiley & Sons, Inc.