Upgrading of aspen poplar wood oil over HZSM-5 zeolite catalyst

Thermally fractionated components of an oil prepared by the liquefaction of aspen poplar wood have been upgraded using a HZSM-5 zeolite catalyst to yield products rich in benzene, toluene, xylenes and higher molecular weight aromatics. The effect of reactor temperatures on the relative abundance of these products has been studied.     

45 GHz self-pulsation with narrow linewidth in quantum dot Fabry-Perot semiconductor lasers at 1.5 /spl mu/m

Self-pulsation at 45 GHz repetition frequency has been demonstrated in 1.5 /spl mu/m monolithic single-section quantum dot Fabry-Perot semiconductor lasers without saturable absorber. The mode-beating exhibits a narrow linewidth below 100 kHz, demonstrating high phase correlation between these modes. Such modelocked lasers open ways to low timing-jitter components for clock recovery or millimetre-wave generation in wireless transmission applications.     

Semiconductor-insulator structures in the phototargets of vidicons sensitive in the middle infrared region of the spectrum

The kinetics of electronic processes in vidicon phototargets based on semiconductor-insulator structures with a narrow-gap semiconductor is considered taking into account charge drain in the insulator layer and relaxation of the nonequilibrium depletion region in the semiconductor layer. The integration time, threshold sensitivity, and resolution at various intensities of incident radiation are estimated.     

Channel capacity and state estimation for state-dependent Gaussian channels

We formulate a problem of state information transmission over a state-dependent channel with states known at the transmitter. In particular, we solve a problem of minimizing the mean-squared channel state estimation error E/spl par/S/sup n/ - S/spl circ//sup n//spl par/ for a state-dependent additive Gaussian channel Y/sup n/ = X/sup n/ + S/sup n/ + Z/sup n/ with an independent and identically distributed (i.i.d.) Gaussian state sequence S/sup n/ = (S/sub 1/, ..., S/sub n/) known at the transmitter and an unknown i.i.d. additive Gaussian noise Z/sup n/. We show that a simple technique of direct state amplification (i.e., X/sup n/ = /spl alpha/S/sup n/), where the transmitter uses its entire power budget to amplify the channel state, yields the minimum mean-squared state estimation error. This same channel can also be used to send additional independent information at the expense of a higher channel state estimation error. We characterize the optimal tradeoff between the rate R of the independent information that can be reliably transmitted and the mean-squared state estimation error D. We show that any optimal (R, D) tradeoff pair can be achieved via a simple power-sharing technique, whereby the transmitter power is appropriately allocated between pure information transmission and state amplification.     

Field observations on the occurrence of new indicators of disinfection efficiency

This paper summarizes studies on the presence of acid-fast and yeast organisms in wastewater and water treatment plants and in surface water. These organisms were found to satisfy three of Bonde's criteria for indicator organisms: presence whenever pathogens are likely to be present; resistance at least equal to that of pathogens; and lack of regrowth in the post-treatment environment. This, plus prior data, indicates that these organisms are at least as acceptable as indicators of disinfection efficiency than the coliform group.     

Purification of Ellagic Acid by UF Membranes

Ellagic acid (2, 3, 7, 8‐tetrahydroxy(1)benzopyrano(5, 4, 3‐cde)(1)benzopyran‐5, 10‐dione) was selected as a model pollutant which is present in the tannic fraction of cork processing wastewater. The ultrafiltration of aqueous ellagic acid solutions through three membranes was studied in tangential UF laboratory equipment. Two of the membranes were polyethersulfone (Biomax10K and Biomax5K, with MWCO of 10000 and 5000 Da, respectively), and the third made of regenerated cellulose (Ultracel5K, with MWCO of 5000 Da). The water hydraulic permeability was evaluated for each membrane. The evolution of the permeate flow rate with processing time was followed, and the influence of the main operating variables (feed flow rate, trans‐membrane pressure and nature of the membranes) on the permeate flux was also established. According to the hypothesis of the film theory, the intrinsic and apparent rejection coefficients, as well as the mass transfer coefficients, were also determined, and the values obtained were discussed as a function of the operating conditions used.     

Connecting the second exhaust-heat boiler to the operating first one under the conditions of flow circuits of combined-cycle plants with two gas-turbine units and one steam turbine

Problems arising with connecting the second exhaust-heat boiler to the first exhaust-heat boiler under load in the case of flow circuits of combined-cycle plants of type PGU-450 are considered. Similar problems exist for two-boiler single-turbine units of type PGU-325 and for two-boiler single-turbine units of traditional steampower plants with an output of 200–300 MW upon connection of the second furnace of a two-furnace boiler to the operating first furnace. Analysis of the temperature-induced stressed state and of the cyclic strength of thick-walled elements of the steam-water conduit of PGU-450 and of two-furnace boilers of two-boiler single-turbine units with an output of 200–300 MW (the check valve, the inlet header of the water economizer) is used for determining the steam temperature differences in the high-pressure conduits to the steam turbine and the order of connection of the second exhaust-heat boiler to the operating fist one. Modes of enabling a two-boiler single-turbine unit of a combined-cycle plant, which are most “rigid” from the standpoint of thermal strength, are determined. __________ Translated from élektricheskie Stantsii, No. 2, February 2006, pp. 11–17.     

Exceptions that prove the rule--Using a theory of motivated social cognition to account for ideological incongruities and political anomalies: Reply to Greenberg and Jonas (2003).

A meta-analysis by J. T. Jost, J. Glaser, A. W. Kruglanski, and F. J. Sulloway (2003) concluded that political conservatism is partially motivated by the management of uncertainty and threat. In this reply to J. Greenberg and E. Jonas (2003), conceptual issues are clarified, numerous political anomalies are explained, and alleged counterexamples are incorporated with a dynamic model that takes into account differences between "young" and "old" movements. Studies directly pitting the rigidity-of-the-right hypothesis against the ideological extremity hypothesis demonstrate strong support for the former. Medium to large effect sizes describe relations between political conservatism and dogmatism and intolerance of ambiguity; lack of openness to experience; uncertainty avoidance; personal needs for order, structure, and closure; fear of death; and system threat. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Crushing behaviour of the energy absorbing 'tensor skin' panels

ABSTRACT Research results concerning the simulation of the crushing behaviour of composite systems with energy absorption characteristics are presented in the present work. The study is focused on the ‘tensor skin’ concept, an energy absorbing composite system that was originally developed to improve the crashworthiness of helicopters under water impact and which is promising for utilization in the construction of the lower part of composite fuselage aircraft. The ‘tensor skin’ concept comprises a folded or corrugated composite construction, which upon loading unfolds by forming ‘plastic hinges’, leading to an increase in the load bearing capability of the structure. The numerical modelling issues and the critical aspects of the simulation are discussed. Verification of the numerical simulation procedure is performed by experimental work. The experimental results utilized to assess and validate the numerical procedure were derived within the European Research Project ‘Design for Crash Survivability – CRASURV’ (BRITE – Aeronautics Area). The results of the simulations are generally in good agreement with experimental data.