新型阳离子聚丙烯酰胺微粒的研究 Ⅱ.含PEO支链阳离子聚丙烯酰胺微粒的絮凝性能

以丙烯酰胺、丙烯酰氧基乙基三甲基氯化铵、聚氧乙烯大单体和N ,N’ -亚甲基双丙烯酰胺为单体 ,进行四元反相微乳液共聚合 ,制备出新型含PEO支链的阳离子微粒絮凝剂。然后用该微粒絮凝剂分别对针叶木纸浆和特种纸白水进行了助留和絮凝性能的研究 ,结果表明 ,本新型微粒具有能单独使用、絮凝效果好和抗剪切性强等优点。     

Wave-attenuation estimation in fluid-filled steel pipes: The first longitudinal guided wave mode

Attenuations of the first (or fundamental) longitudinal guided wave modes propagating in liquid-filled steel pipes are numerically investigated. Several filling liquids transported by the steel pipe are considered in the investigation. In the numerical modeling stage, a sink is considered for abandoning standing wave modes caused by the internal liquids; hence, the attenuation dispersion curves become simpler. From the attenuation dispersion curves, two specific attenuation values corresponding to 1 MHz and 2.68 MHz are selected; then, the concept of parametric density is introduced to predict attenuation for a certain filling material. With this concept, it is possible to approximately calculate attenuation values without a complex numerical attenuation calculation. This investigation may provide fundamental data to inspectors using ultrasonic guided-wave techniques in the petrochemical industry and in the field of water supply, two branches of the economy that are always under pressure owing to the demand of increasing productivity and that are challenged owing to stricter environmental rules, thus necessitating promising, low-cost inspection techniques. The text was submitted by the authors in English.     

非对称单筒双井技术在文昌13-2油田的应用

南海西部文昌13-2油田目前共有开发井12口,油田已经没有空井槽,为充分开发油田,提高采收率,确定在文昌13-2油田A平台内挂4个?762 mm井槽,采用单筒双井技术,利用平台125t修井机,在?762 mm隔水管内下入?339.7 mm套管和?244.5mm套管,并利用?339.7 mm套管进行单筒双井的固井作业,实现了在同一井槽内完成2口不同井身结构的水平井钻完井作业。以同一槽口A16h井和A17h井为例,介绍了非对称单筒双井钻井程序、工艺特点以及钻井期间注意事项。单筒双井技术在文昌13-2平台成功的应用,充分地利用了井口平台的空间,减少了工程造价,降低了开发成本,摸索出了一套成功经验。     

新型阳离子聚丙烯酰胺微粒的研究--含PEO支链阳离子聚丙烯酰胺微粒的合成、助留性能及作用机理

本文采用反相微乳液聚合的方法合成了丙烯酰胺(AM)/丙烯酰氧基乙基三甲基氯化铵(AD-AMQUAT)/聚氧乙烯大单体(PEO-A)/N,N'-亚甲基双丙烯酰胺(Bis)的四元共聚物微粒.研究了该微粒助留剂的结构与性能.这种微粒和纸纤维能够通过离子键和氢键作用显著地增强助留效果.     

基于ANN和SA的混凝土配合比优化设计

利用模拟退火方法探讨了混凝土配合比的优化设计，并用Visual C＋＋语言编制了实用系统，得出了只要数据充分，算法的精度可以得到保证的结论，以推广该设计方法的应用。     

YAG：Ce Phosphors for WLED via Nano-Pesudoboehmite Sol-Gel Route

The sub-micron sized YAG ： Ce phosphors were synthesized via a modified sol-gel method by peptizing nano-pesudoboehmite particulate. It is found that YAG phase from the dried gel powders appears at 1000 ℃ then the pure YAG phase exists at a relatively lower sintering temperature of 1400 ℃. The smaller sizes of phosphors in the ranges of 1 - 3 μm are obtained due to the contribution of seeding effects of nano-sized alumina particles to strengthen each step of the processes. Both the excitation and emission spectra of photoluminescence of the phosphor obtained at 1400 ℃ meet well with the spectroscopic requirements of the WLED phosphors.     

动态分组传输技术(DPT)性能分析

简要介绍动态IP光纤技术DPT的传输机制及相关的空间复用协议内容,同时分析DPT的主要特点,并与其他技术如ATM,POS等进行对比,说明DPT在大型IP网络应用中的优势.     

有机电沉积涂料的新动向

阴极电沉积涂料是 2 0世纪 70年代以来发展起来的一种新的涂装方法 ,具有挥发性有机物 (VOCs)和有害空气污染物(HAPs)含量低、防蚀能力强、漆膜质量好、涂料利用率高、适合涂装结构复杂的构件和设备等特点。介绍了近年来阴极电沉积涂料研发的新动向。它们主要集中在有机双层电涂和高分子 聚电解质 /低聚物电解质复合物多层电涂体系 ,这些新的电涂体系在涂料的稳定性以及涂层的物理化学性质和力学性能方面具有明显的改进。     

三维PDP放电过程数值模拟软件

介绍了三维PDP放电过程模拟软件，该软件可较真实地反映放电单元的实际情况，对放电性能进行优化设计，且具有通用性强、界面友好、使用方便、功能完善等特点。可对不同结构、不同气体成份、不同驱动电压及波形等情况进行计算。