An equation of state for 1,1-difluroethane (HFC 152a)

An equation of state for 1,1-difluoroethane (HFC 152a, CH₃CHF₂) has been developed on the basis of reliable experimental data including PVT, liquid C_p, and saturated-liquid-density data measured by our group. It is a non-dimensionalized virial equation whose functional form is the same as that originally developed for 1,1,1,2-tetrafluoroethane (HFC 134a) in our group. The effective range is for pressures up to 15 MPa, temperatures from 230 to 450 K, and densities to 1000 kg m⁻³. The equation represents reliable PVT measurements within ± 1% in pressure for the superheated vapour and supercritical fluid, while within ±0.5% in density for the compressed liquid. In addition, it should be noted that the equation represents the other essential thermodynamic properties including vapour pressures, saturated-liquid/ vapour densities, isobaric/isochoric specific heats and sound velocity in both the liquid and gaseous phase of HFC 152a.     

New balance ground relay for parallel four-circuit transmission lines

A 66-kV network generally is grounded through a neutral grounding resistor. In this network a single-phase ground-fault current is limited to as small as 100 to 400 A. There are parallel four-circuit transmission lines mounted on the same tower in the 66-kV network. In such transmission lines, the load and the fault currents could induce circulating current that flows through the lines. Since the circulating current has zero-phase-sequence and negative-phase-sequence components, it could cause unwanted operation of a balance ground relay using zero-phase-sequence current. However, it is difficult to compensate for the circulating current by the conventional vector compensation scheme. This paper presents a new balance ground relay to deal with the circulating current. In the relay from the ground-fault inception until first tripping, the difference current Δ3I_2d of negative-phase-sequence current 3I_2d of the differential current between two protected lines is used as an input current. The Δ3I_2d is the difference current of 3I_2d between, before and during faults. After the first tripping, the difference current of positive-phase-sequence load current and zero-phase-sequence current of the forementioned differential current are used as an input current. Consequently, a higher sensitivity of the ground-fault protection for these lines has been achieved. The correct operation of the new balance ground relay was confirmed when a single-phase-ground-fault occurred in the parallel four-circuit transmission lines, to which the relay is applied.     

Application of Code Approach for Emergency Evacuation in a Rail Station

This paper presents an emergency evacuation analysis during a mid-platform train fire in an underground rail station. A time-based evacuation scenario is developed taking into account the stairway inaccessibility due to smoke blockage. The calculation approach in NFPA 130 is then applied to a parametric study of this time-based scenario and its reliability is examined using a micro-simulation model. Both methods give consistent predictions of the exiting times. The results demonstrate that with the division of the station into two zones, the exiting time could not meet the code requirements, whereas it does meet the required exiting time without the division. Such division is due to smoke blockage and creates an uneven ratio of the occupant load to the available exiting capacity. This shows that appropriate consideration of the fire and smoke effects is important for station egress evaluation. Other issues such as the fire growth rate and the pre-evacuation time are also discussed.     

Detection of failure sites by focused ion beam and nano-probing in the interconnect of three-dimensional stacked circuit structures

Focused ion beam (FIB) and nano-probing were applied for failure analysis of three-dimensional stacked circuits with copper through-silicon-vias between the stacked chips. The failure analysis was done after high temperature storage and thermal cycling tests. Passive voltage contrast in FIB allowed to pinpoint the open sites. FIB cross-sections showed the presence of opens at the bottom of the copper vias. The failure cause was suspected to be an interlayer particle, which was confirmed by optical profilometry. Nano-probing was used on another sample to pinpoint the failure location through the measurement of the local resistance within the daisy chains. The failure was traced out to be related with surface contamination.     

新型水力泵排液工艺

酸化或压裂是改造油气层措施中常规的也是最有效的方法之一。问题是酸化或压裂结束后,采取何种工艺及时返排出残酸,减少残液二次沉淀对油层的污染。同时常规TCP(油管传输负压射孔)+DST(地层测试器)二联作测试工艺在遇到低压、低渗等非自喷油层时,要想取准油层产能、压力,收集到有代表性产液样品资料,困难很大。针对以上问题,大港油田钻采院研制了新型水力喷射泵,该泵可与酸化、压裂及射孔+测试等工艺配套使用,在实现一趟施工管柱同时完成几项工作的同时,利用喷射泵深抽、连续强排的技术特点,取得了较好效果。     

The gamma-ray-induced crosslinking of polyacrylamide

The gamma-ray-induced crosslinking of polyacrylamide was carried out under various conditions. The molecular weight of the polymer before inrradiation was found to be the most important factor for crosslinking. When polymers have low molecular weights such as 80,000, the intensity of radiation, the external pressure applied, and the water content of the polymer powder became important for crosslinking. Although the polycrylamide hydrogel can be obtained directly by irradiating the monomer, it was obtained more conveniently by the irradiation of monomer—polymer mixtures. The hydrogels obtained by the radiation with a dose of over 50 kgray, absorb water by 1000–1500 wt %.     

浅谈我国电信企业信息化策略

我国电信企业要做大做强，信息化是必然的战略选择和有效的助力器。本文阐述了电信企业信息化的含义、现状，描绘了电信企业信息化的目标，从经济学、管理学、行为科学等学科的角度提出了我国电信企业信息化策略。     

高峰值功率重频脉冲固体激光器

综述了高峰值功率重频脉冲固体激光器的发展现状，对其中的Ｑ开关、腔倒空、锁模等窄脉冲技术和放大技术进行了分析，展示了高峰值功率重频脉冲固体激光器的发展前景。     

Failure probability evaluation for normally distributed load-strength model with unknown parameters

The failure probability evaluation methods for load-strength interference model are established when both load, L, and strength, S, follow normal distributions, assuming none of the normal distribution parameters are known. Based on Fisher's fiducial analysis, a failure probability evaluation method is obtained for single load application. A numerical integration method is developed to evaluate the failure probability for multiple load applications.     

Accurate estimation of environment parameters from ultrasonic data

This paper describes a robust and accurate ultrasonic sensing system for a mobile robot. The system continuously updates a local map of the environment in which obstacles are represented by straight lines or points in a robot centered coordinate frame. The presented algorithms use a Kalman filter for the reduction of the noise in the ultrasonic data and use a systematical error correction (‘bundle correction’) to reduce the uncertainty in obstacle direction. Experiments are carried out in simulation and with a real mobile robot system. Results show that the accuracy with which line parameters can be estimated is in the order of 1 degree for the orientation and about 2 cm for the position. The effect of the bundle correction is significant and maximal when the robot approaches walls under a small angle.