A self-driven active clamp forward converter using the auxiliary winding of the power transformer

This study proposes a new self-driven active clamp forward converter eliminating the extra drive circuit for the active clamp switch. The converter used the auxiliary winding of the power transformer to drive the active clamp switch and a simple RC circuit to get the dead time between the two switches. The operation principle was presented and experimental results were used to verify theoretical predictions. A 100-W (5 V/20 A) prototype converter that only exhibited 1.5-turn winding number in the auxiliary winding was sufficient to drive the active clamp switch on the input of 50 V. Finally, the measured efficiency of the converter was presented and the maximum efficiency of 91% was obtained.     

Experimental Demonstration of 1.25-Gb/s Radio-Over-Fiber Downlink Using SBS-Based Photonic Upconversion

We experimentally demonstrate a radio-over-fiber downlink system using a stimulated Brillouin scattering (SBS)-based photonic upconversion technique. The Brillouin selective amplification characteristic of SBS is incorporated to generate the 11-GHz band radio-frequency (RF) carrier. The dual-electrode Mach-Zehnder optical modulator, which is used to carry the broadband data in the optical carrier instead of the optical sideband, is adopted along with the SBS-based carrier generation setup. To vindicate the broadband capabilities of the proposed scheme, 1.25-Gb/s pseudorandom bit sequence data is carried in the optical carrier. Error-free operation of the 1.25-Gb/s downlink is achieved without critical power penalties after the 13-km fiber transmission.     

An analytical threshold-voltage model of trench-isolated MOSdevices with nonuniformly doped substrates

A simple closed-form expression of the threshold voltage is developed for trench-isolated MOS (TIMOS) devices with feature size down to the deep-submicrometer range. The analytical expression is the first developed to include the nonuniform doping effect of a narrow-gate-width device. The inverse narrow width effect can be predicted analytically from the proposed model. It was derived by modeling the gate sidewall capacitance to include the two-dimensional field-induced edge fringing effect and solving the Poisson equation to include the channel implant effect at different operating backgate biases. A two-dimensional simulation program was developed, and the simulated data were used for verification of the analytical model. Good agreements between the modeled and simulated data have been achieved for a wide range of gate widths and biases. The model is well suited for the design of the basic transistor cell in DRAM circuits using trench field oxide isolation structure     

Proton-exchange optical waveguides in Z-cut LiNbO/sub 3/ using toluic acid

Proton-exchanged planar waveguides were demonstrated in Z-cut LiNBO/sub 3/ using toluic acid as a new organic proton source. These waveguides exhibit a propagation loss of around 1 dB/cm, and a step refractive index profile with an index increase of 0.124 measured at 0.663 mu m. The diffusion rate was found to be lower than those obtained using the popular benzoic and phosphoric acids.<>     

Reliability analysis of a human operator under different levels of stress

This paper presents a reliability analysis of a human operator carrying out his jobs under different levels of stress. The failed system, which is due to self-correctable error, is restored to as-new at normal stress. Laplace transforms of state probabilities and operator reliability are derived. The mean time to human error is also given.     

Isometry-Based Shape-Adaptive Fractal Coding for Images

Fractal image coding is an effective method to eliminate the image redundancy through piecewise self-transformability. The fractal code consists of a set of contractive affine transforms. To improve the performance when a range block experiences large error, we usually partition the range block into square or nonsquare subrange blocks for two- or multilevel fractal coding. In this paper, we find an inherent property of fractal coding that can be used to decide the edge orientation of a range block. Then this property is used for shape-adaptive fractal coding (SAFC). In SAFC, the top-level range block is partitioned into square or nonsquare (rectangle or triangle) subrange blocks for multilevel fractal encoding. Here, the maximum size of the range block can be the same as that of the whole image size while the minimum size is 4×4. In SAFC, no additional computations are required to obtain the edge orientation of a range block. Instead, we propose an edge-orientation detector, where the edge orientation of a range block is obtained during the fractal encoding process. According to our simulation results, SAFC can reduce the bit rate requirement of the conventional fractal coding scheme.     

Coherent frequency/phase modulation scheme

An L-phase-levelled coherent frequency/phase modulation (LCFPM) scheme is proposed and analysed for additive white Gaussian noise channels. The optimised LCFPM scheme with L>2 is found to have superior bandwidth efficiency to the conventional dual-frequency quadrature frequency/phase modulation scheme     

Optimal operation of coreless PCB transformer-isolated gate drivecircuits with wide switching frequency range

Gate drive circuits for power MOSFETs and insulated gate bipolar transistors (IGBTs) often require electrical isolation. Coreless printed circuit board (PCB) transformers have been shown to have desirable characteristics from a few hundreds of hertz to a few megahertz and can be used for both power and signal transfer at low-power level. At low operating frequency, the magnetizing inductance has such low impedance that the driving power requirement could become excessive. This paper describes the use of a coreless PCB transformer for isolated gate drive circuits over a wide-frequency range. Based on a resonance concept, the optimal operating condition that minimizes the power consumption of the gate drive circuits is developed and verified with experiments. The coreless PCB transformer demonstrated here confirms a fundamental concept that the size and volume of a magnetic core could approach zero and become zero if the operating frequency is sufficiently high. Coreless PCB transformers do not require the manual winding procedure and thus simplify the manufacturing process of transformer-isolated gate drive circuits and low-power converters. Their sizes can be much smaller than those of typical core-based pulse transformers. The electrical isolation of a PCB is much higher than that of an optocoupler     

Adaptive Bit-Interleaved Coded OFDM With Reduced Feedback Information

If the channel is static and is perfectly known to both the transmitter and the receiver, the water-filling technique with adaptive modulation is known to be optimal (Gallager, 1968). However, for orthogonal frequency-division multiplexing (OFDM) systems, this requires intensive traffic overheads for reporting channel state information on all subcarriers to the transmitter. In this paper, we consider an adaptive modulation and coding scheme for bit-interleaved coded OFDM with reduced feedback information satisfying a specified quality of service level. We propose a rate adaptation scheme, which utilizes the estimated bit error rate for supportable transmission rates. In this scheme, a user equipment chooses a modulation and coding scheme (MCS) level, which can provide the maximum spectral efficiency based on one OFDM symbol rather than on all subchannels. Then the user needs to send back only the selected MCS level index. The proposed scheme does not require the water-filling procedure, and the amount of the feedback information reduces to a single integer value irrespective of the number of subcarriers. Simulation results show that the proposed scheme can significantly reduce the system complexity while minimizing the performance loss compared to the optimum water-filling scheme.     

A novel search method to reduce PAPR of an OFDM signal using partial transmit sequences

One of the main drawbacks of orthogonal frequency division multiplexing (OFDM) is the high peak‐to‐average power ratio (PAPR) of the transmitted OFDM signal. Partial transmit sequence (PTS) technique can improve the PAPR statistics of an OFDM signal. As ordinary PTS technique requires an exhaustive search over all combinations of allowed phase factors, the search complexity increases exponentially with the number of sub‐blocks. In this paper, we propose a novel PTS technique with reduced complexity that each level inverts twice of phase factor bits from previous level. Then we also use initial random phase sequence to find the better search way of PAPR reduction. Numerical results show that the proposed method can achieve significant reduction in search complexity with little performance degradation. Copyright © 2006 John Wiley & Sons, Ltd.