Synthesis of silica-coated rhodium nanoparticles in reversed micellar solution

Silica (SiO₂)-coated rhodium (Rh) nanoparticles were prepared using a water-in-oil microemulsion of polyoxyethylene (15) cetyl ether, cyclohexane and water. SiO₂-coated Rh nanoparticles were obtained by hydrolyzing metal alkoxide (tetraethylorthosilicate, TEOS) in the solution containing Rh complex nanoparticles followed by thermal and reduction treatments. In the SiO₂-coated Rh nanoparticle, a Rh particle with an average diameter of 4.1 nm was located nearly at the center of each spherical SiO₂ particle. The SiO₂ layer was approximately 15 nm thick. Since the Rh particle was wholly surrounded by SiO₂, the Rh particle of the SiO₂-coated Rh nanoparticle exhibited an extremely high thermal stability. Furthermore, the porous structure of the SiO₂ layer could be controlled by the hydrolysis conditions of TEOS.     

Optical amplification in Er3+-doped single-mode fluoridefiber

The amplification characteristics at around 1.5 μm of a 0.9-m-long, 1000-p.p.m Er³⁺-doped single-mode fluoride fiber are discussed. By using 1.48-μm laser diodes with 55-mW launched output as a pump source, a gain of 1.75 dB was obtained at 1.530 μm. A broad bandwidth of 40 nm was obtained, which may be suitable for wavelength-division multiplexing (WDM) system use     

Olympic Technologies

The Olympic Games bring tremendous impacts to host cities, yet little attention has been paid to the variety and novelty in urban technologies that are introduced through the mega-event vehicle. This paper argues that urban transformation associated with the Olympic Games increasingly spans the technological sphere. As a path-breaker the Olympic bid of Tokyo foreshadows a technological revolution that will make the capital of Japan the most advanced urban technology metropolis in the world. This is significant, as this pioneer for the city of the future may yield many valuable insights given the rapid implementation and acceleration of technological innovation proceeding into 2020. Consequently, lessons on how this technology may impact our society can be derived.     

Early warning system for rainfall- and snowmelt-induced slope failure in seasonally cold regions

In 2005, the Japanese government launched a new nationwide early warning system for predicting debris flow and slope failure disasters based on rainfall intensity and the Soil Water Index (SWI). However, the Japanese government has not set early warning criteria in many mountain areas. In addition, the existing early warning criteria in some areas are much higher than realistic ones, and snowmelt water is not considered in the calculation of the SWI. These two factors have been the cause of many slope failures in seasonally cold regions, induced by rainfall and/or snowmelt, which were not predicted. Therefore, this study attempts to propose a new determination method for setting early warning criteria for rainfall- and/or snowmelt-induced slope failures in seasonally cold regions. For this purpose, the study firstly proposes a combination model for estimating snow density that incorporates the hourly snowmelt water into the Japanese early warning system more accurately by using meteorological monitoring data and modeled snow density. Next, based on case studies and parametric analyses for slope stability assessment, new early warning criteria are proposed for predicting three different patterns of slope failures under two typical types of precipitation (rainfall and snowmelt) conditions. Finally, a new determination method for setting early warning criteria in seasonally cold regions is proposed by referring to the existing early warning criteria near the target area, in accordance with the precipitation types and the local ground conditions of the slopes. Since the existing early warning criteria near the target area already take the effects of the variations in local geology and geography into account, the new determination method for early warning criteria can be applied to arbitrary areas in seasonally cold regions, without directly considering the local soil properties, in the actual design and maintenance works.     

Effect of BN nanoparticle content in SiC matrix on microstructure and mechanical properties of SiC/SiC composites

BN-nanoparticle-containing SiC-matrix-based composites comprising SiC fibers and lacking a fiber/matrix interface (SiC/BN + SiC composites) were fabricated by spark plasma sintering (SPS) at 1800°C for 10 min under 50 MPa in Ar. The content of added BN nanoparticles was varied from 0 to 50 vol.%. The mechanical properties of the SiC/BN + SiC composites were investigated thoroughly. The SiC/BN + SiC composites with a BN nanoparticle content of 50 vol.%, which had a bulk density of 2.73 g/cm³ and an open porosity of 5.8%, exhibited quasiductile fracture behavior, as indicated by a short nonlinear region and significantly shorter fiber pullouts owing to the relatively high modulus. The composites also exhibited high strength as well as bending, proportional limit stress, and ultimate tensile strength values of 496 ± 13, 251 ± 30, and 301 MPa ± 56 MPa, respectively, under ambient conditions. The SiC fibers with contents of BN nanoparticles above 30 vol.% were not severely damaged during SPS and adhered to the matrix to form a relatively weak fiber/matrix interface.     

Boson peak and structural heterogeneity in ternary SiO2-Al2O3-B2O3 glasses

We use low-temperature heat capacity, low-frequency Raman scattering, and THz time domain spectroscopy in order to scale the vibrational density of states and the Boson peak in SiO₂-Al₂O₃-B₂O₃ Yb-laser host glasses. When substituting B₂O₃ for SiO₂ at constant Al₂O₃ dopant level, we find an optimal value for the ratio of B/Al in terms of mixture stability, at which the excess in the electron donor capability of Al₂O₃ (relative to the SiO₂ backbone) is compensated by the more acidic B₂O₃. At this composition, Al₂O₃ plays a mediating role in the structure of aluminoborosilicate glasses, facilitating dissolution of Yb₂O₃ and admixture of B₂O₃ into the SiO₂ network.     

In Vivo Electrophysiology of Peptidergic Neurons in Deep Layers of the Lumbar Spinal Cord after Optogenetic Stimulation of Hypothalamic Paraventricular Oxytocin Neurons in Rats

The spinal ejaculation generator (SEG) is located in the central gray (lamina X) of the rat lumbar spinal cord and plays a pivotal role in the ejaculatory reflex. We recently reported that SEG neurons express the oxytocin receptor and are activated by oxytocin projections from the paraventricular nucleus of hypothalamus (PVH). However, it is unknown whether the SEG responds to oxytocin in vivo. In this study, we analyzed the characteristics of the brain–spinal cord neural circuit that controls male sexual function using a newly developed in vivo electrophysiological technique. Optogenetic stimulation of the PVH of rats expressing channel rhodopsin under the oxytocin receptor promoter increased the spontaneous firing of most lamina X SEG neurons. This is the first demonstration of the in vivo electrical response from the deeper (lamina X) neurons in the spinal cord. Furthermore, we succeeded in the in vivo whole-cell recordings of lamina X neurons. In vivo whole-cell recordings may reveal the features of lamina X SEG neurons, including differences in neurotransmitters and response to stimulation. Taken together, these results suggest that in vivo electrophysiological stimulation can elucidate the neurophysiological response of a variety of spinal neurons during male sexual behavior.     

Synthesis of Red-Light-Responsive Pheophorbide-a Tryptamine Conjugated Photosensitizers for Photodynamic Therapy

Six methyl pheophorbide-a derivatives were prepared by linking a tryptamine side chain at the C-13 ¹ , C-15 ² and C-17 ³ positions of pheophorbide-a. P repared conjugates were characterized and evaluated for their photocytotoxicity against A549 cells. The conjugate 6 a with strong absorption at 413 nm (Soret band), 663–671 nm (Q bands) and comparable fluorescence quantum yield (0.26) was found to exhibit significant cytotoxicity (659 nM). Molecular integration of pheophorbide-a and tryptamines showed synergistic effects as the most potent conjugate 6 a was identified with enhanced photocytotoxicity when compared to methyl pheophorbide-a. T he conjugate 6 a was smoothly taken up by A549 cells and exhibited intracellular localization predominantly to lysosome in the cytoplasm. Upon photoirradiation 6 a generated singlet oxygen to show potent cytotoxicity toward A549 cells.     

Induction of TNF-alpha production from human peripheral blood monocytes with beta-1,3-glucan oligomer prepared from laminarin with beta-1,3-glucanase from Bacillus clausii NM-1

We prepared a beta-1,3-glucan oligomer (DP> or = 4) from laminarin (DP: 25-30) derived from Laminaria digitata with beta-1,3-glucanase, and examined its effect on human peripheral blood monocytes. Conditioned medium prepared by incubating monocytes (MC-CM) with the beta-1,3-glucan oligomer showed strong inhibitory activity against the proliferation of human leukemic U937 cells. Since the beta-1,3-glucan oligomer had no direct cytotoxic effect on U937 cells up to 1000 microg/ml, the cytotoxicity of the MC-CM may be due to cytotoxic cytokines produced from monocytes stimulated by the beta-1,3-glucan oligomer. On the other hand, the MC-CM prepared with original laminarin had little effect on the growth of U937 cells. The cytotoxicity of the MC-CM prepared with the beta-1,3-glucan oligomer was significantly reduced by an anti-TNF-alpha antibody, but the anti-TNF-beta antibody had no effect. Our results suggest that the enzymatically depolymerized beta-1,3-glucan oligomer induces TNF-alpha production from human monocytes.