A Review on InGaSb Growth under Microgravity and Terrestrial Conditions Towards Future Crystal Growth Project Using Chinese Recovery Satellite SJ-10

The paper reviewed the previous microgravity experiment using Chinese recovery satellite, the in-situ measurement of composition profile in the solution by X-ray penetration method and homogeneous growth of InGaSb by temperature freezing method under terrestrial condition for making clear the effect of gravity on the growth of InGaSb ternary alloy semiconductor crystals. The previous experimental results showed that the shape of solid/liquid interfaces and composition profile in the solution were significantly affected by gravity. Based on the previous microgravity experimental results, experimental conditions were investigated to grow homogeneous In _xGa _1?xSb with higher indium composition at Chinese recovery satellite SJ-10 in near future.     

The Somatropin Reference Standard (Control 951) of the National Institute of Health Sciences

Somatropin material was examined for preparation of the "Somatropin Reference Standard". The candidate material was evaluated by a domestic collaborative study in which eight laboratories participated. The protein content was determined to be 4.5 mg/Vial based on amino acid analysis. Because of the possibility of application as a chemical reference standard for assay by the HPLC method, a physico-chemical evaluation of the candidate material was also performed. By SE-HPLC, the content of polymer, dimer were determined to be 0.54%, 0.98%, respectively. By RP-HPLC, the early peak area ascribed to desamido and sulfoxide form was 1.07% of the total peak area. And for informational data, the potency of the candidate material, being estimated by three different biological methods, weight gain assay, tibia test and adiposeconversion assay is 14.8 IU/vial. Based on the above results, the candidate was authorized as the Somatropin Reference Standard of the National Institute of Health Sciences.     

A dynamically reconfigurable processor for H.264/AVC image prediction

H.264/AVC provides high video quality at substantially low bit rates. It is useful for saving and transferring video images by robot cameras. However, the computational complexity of H.264/AVC is very high. A high-speed general-purpose processor is necessary to process H.264/AVC. However, it is difficult to use such a processor for a portable device. Therefore, an application-specific processor is necessary. A dynamic reconfiguration can virtually expand the circuit area in a limited chip area. Therefore, this article proposes a dynamically reconfigurable processor for H.264/AVC image prediction. H.264/AVC contains intra- and inter-prediction processes. The intra- and inter-prediction processes are not used at the same time. The proposed processor was designed and synthesized, and dynamically reconfigures those circuits. As a result, look-up tables (LUTs) were reduced to 93%, flip-flops were reduced to 94%, and the maximum delay was about the same.     

Proteomics integrated with Escherichia coli vector-based vaccines and antigen microarrays reveals the immunogenicity of a surface sialidase-like protein of Propionibacterium acnes

Proteomics is a powerful tool for the identification of proteins, which provides a basis for rational vaccine design. However, it is still a highly technical and time‐consuming task to examine a protein's immunogenicity utilizing traditional approaches. Here, we present a platform for effectively evaluating protein immunogenicity and antibody detection. A tetanus toxin C fragment (Tet‐c) was used as a representative antigen to establish this platform. A cell wall‐anchoring sialidase‐like protein (SLP) of Propionibacterium acnes was utilized to assess the efficacy of this platform. We constructed an Escherichia coli vector‐based vaccine by overexpressing Tet‐c or SLP in E. coli and utilized an intact particle of E. coli itself as a vaccine (E. coli Tet‐c or SLP vector). After ultraviolet (UV) irradiation, the E. coli vector‐based vaccines were administered intranasally into imprinting control region mice without adding exogenous adjuvants. For antibody detection, we fabricated antigen microarrays by printing with purified recombinant proteins including Tet‐c and SLP. Our results demonstrated that detectable antibodies were elicited in mice 6 weeks after intranasal administration of UV‐irradiated E. coli vector‐based vaccines. The antibody production of Tet‐c and SLP was significantly elevated after boosting. Notably, the platform with main benefits of using E. coli itself as a vaccine carrier provides a critical template for applied proteomics aimed at screening novel vaccine targets. In addition, the novel immunogenic SLP potentially serves as an antigen candidate for the development of vaccines targeting P. acnes‐associated diseases.     

Experience with radio isotope myelography from neurosurgical aspects (author's transl)

Experience with Radio Isotope Myelography is reported here. 169Yb-DTPA as a tracer was intrathecally injected at lumbar region in twenty three patients with various spinal cord lesions. The first scanning is perfomed after comfirming by gamma-camera that the tracer reaches to the lesion, the second and the third scannings are done according to the ascending rate of the tracer. (I) Normal scintimyelogram (A) In normal case, the shape of the Radio Isotope Myelogram well corresponds the shape of anatomical subarachnoid space. (B) In normal adult cases, the tracer comes up to the cisterna magna in 20-25 minutes after the lumbar injection. Therefore, the scintimyelographic diagnosis should be made not only by the shape but also by the ascending rapidity of the tracer. (II) Abnormal scintimyelogram Abnormal scintimyelograms could be summarized as following three categories. (A) "Delay": It means delay of the ascending of the tracer. Besides, "Transient delay" found in a case of Arnord-Chiari's malformation was proposed. (B) "Partial block": It meas a defect at the level of the lesion. This "Partial block" were observed in cases of spinal cord angioma, cervical spondylosis and spinal cord tumor etc. (C) "Complete block": It means the stagnation of the tracer below the lesion. To sum up, Rario Isotope Myelography, especially in partial block, can more easily and more sensitively represent the maximum extent of the spinal cord lesion than other myelographic study or angiographic one. On the other hand, we can not qualitatively diagnose about the lesions by its indistinct border.     

气体辅助法陶瓷薄膜的制备

Ceramics （alumina） coating on sevaral materials has been successfully achieved at room temperature by gas - assisted deposition （ GAD） technique. In the GAD process the alumina powder was accelerated by jet flow with velocity of - 1000 m/s and impaeted to a substrate, thereby a fiat and dense film was deposited up to 10 μm on the substrate without arty additional heating. The crystal structttre of the alumina in an obtained GAD films seemed as amorphous like. The crystalline phase was recovered by post nnnenling at 1 300 ℃ , however, the matrix resulted in a hollow structure.     

Effect of gravity on InGaSb crystal growth

The effect of gravity on dissolution of GaSb in InSb melt and growth of InGaSb was experimentally investigated. Experiments were carried out in a GaSb(seed)/InSb/GaSb(feed) sandwich system under an imposed temperature gradient. In the experiments, the GaSb feed crystal dissolved into the InSb melt to supply the required GaSb component for the growth of In_0.1Ga_0.9Sb crystal. Two parameters were considered: (1) the inclination angle (θ) of the sample for gravity as 0° and 53°, and (2) the sample diameter (D) as 9 mm and 5mm. When θ was 0°, the interface was almost flat, indicating that convection was axisymmetric and stable. Whereas the interface was distorted towards gravitational direction when θ was 53°, indicating that solutal convection was dominant. The decrease of growth temperature and sample diameter reduced the distortion of interface and the dissolution amount of GaSb feed. The homogeneous crystals were grown at the initial growth stage by supplying the GaSb component during growth.     

Inactivation of Bacillus spores by the combination of moderate heat and low hydrostatic pressure in ketchup and potage

The combination effect of moderate heat and low hydrostatic pressure (MHP) on the reduction of Bacillus subtilis, Bacillus coagulans and Geobacillus stearothermophilus spores in food materials (potage and ketchup) was investigated. These bacterial spores were suspended in potage (pH 7), acidified potage (pH 4), neutralized ketchup (pH 7) and ketchup (pH 4). The suspensions were treated with and without pressure (100 MPa) and temperatures of 65-85 degrees C for 3 to 12 h. The bacterial spores were inactivated by 4-8 log cycles during MHP treatment in potage, acidified potage and ketchup, whereas the spores were highly resistant to long time heat treatment in potage and neutralized ketchup. The degrees of spore destruction were mostly dependent on pH and medium composition during MHP treatment. The inactivation effect in MHP treatment was higher at the pH 7 than at pH 4 both in ketchup and potage. The bacterial spores showed higher inactivation in potage than ketchup during MHP treatment.     

DC‐linked hybrid generation system with an energy storage device including photovoltaic generation and gas engine cogeneration for residential houses

For the past few years, hybrid generation systems including solar panel and gas cogeneration have been used for residential houses. Solar panels can generate electronic power at daytime but not at night. But the power consumption of residential houses usually peaks in the evening. The gas engine cogeneration system can generate electronic power without such a restriction, and it also can generate heat power to warm up a house or to produce hot water. In this paper we propose a solar panel and gas engine cogeneration hybrid system with an energy storage device, combined by a DC bus. If a blackout occurs, the system still can supply electronic power for special house loads. We propose a control scheme for the system related to the charging level of the energy storage device and the voltage of the utility grid, which can be applied to both grid‐connected and standalone operation. Finally, we report experiments designed to demonstrate system operation and calculations for loss estimation. © 2012 Wiley Periodicals, Inc. Electr Eng Jpn, 182(4): 29–46, 2013; Published online in Wiley Online Library ( wileyonlinelibrary.com ).DOI 10.1002/eej.22321