Dynamic Control of a Self-Controlled Synchronous Motor Drive System

Dynamic performance of a speed control system containing a self-controlled synchronous motor is analyzed in detail. It is shown that a field voltage control combined with a margin angle control secures safe commutation of the inverter during transients that cause a large variation in the dc link current and that a current limiter enables the motor speed to change almost linearly at a maximum torque. A simple and efficient control strategy for a fast speed response without an overshoot is then proposed, and the effectiveness of this proposed control as well as the field voltage and margin angle controls is confirmed by experimental investigation.     

Rheological properties of iron oxide particle suspensions

Viscosities of γ-Fe₂O₃ dispersions in epoxy resin, phenol resin, and polyvinyl butyral solutions are measured at shear rate D from 19.2 to 384 sec^?1. Volume fraction of γ-Fe₂O₃ in these dispersions ranges from about 0.002 to 0.03. The concentration dependence of relative viscosity η/η_s is closely represented by the Mooney equation. From this equation, intrinsic viscosity [η] of suspensions is found to decrease from 46.1 at D = 19.2sec^?1 to 14 at D = 384 sec^?1 for epoxy resin solution. The high [η] value indicates the existence of flocs containing immobilized liquid. By increasing the shear rate, the average floc size is reduced to point where at an infinite shear rate, only small clusters or possibly particles remain. Of the three polymers, the lowest [η] value is obtained in the dispersion of the phenol resin solution.     

Cell distributions in and sound absorption characteristics of flexible polyurethane foams

In this article, the two-dimensional distributions of cells from the cross section of some flexible polyurethane foams were cleared, and the three-dimensional distributions of cells based on Saltykov's theory were estimated further. As a result, it was found that a mean of the two-dimensional distributions of cells was a good linear relation with a mean of the three-dimensional distributions of cells, and it was confirmed that cell structure of the foams which should have been analyzed in the three-dimensional distributions was evaluated by analysis of the two-dimensional distributions fully. It was also found that not only cell number but also cell distribution was necessary in the evaluation of flexible polyurethane foams, and cell diameter was closely related to the sound absorption coefficient in polyester-based flexible polyurethane foams. © 1997 John Wiley & Sons, Inc. J Appl Polym Sci 65: 1395–1402, 1997     

Thermal and insulating properties of epoxy/aluminum nitride composites used for thermal interface material

We synthesized an epoxy matrix composite adhesive containing aluminum nitride (AlN) powder, which was used for thermal interface materials (TIM) in high power devices. The experimental results revealed that adding AlN fillers into epoxy resin was an effective way to boost thermal conductivity and maintain electrical insulation. We also discovered a proper coupling agent that reduced the viscosity of the epoxy‐AlN composite by AlN surface treatment and increased the solid loading to 60 vol %. For the TIM sample made with the composite adhesive, we obtained a thermal conductivity of 2.70 W/(m K), which was approximately 13 times larger than that of pure epoxy. The dielectric strength of the TIM was 10 to 11 kV/mm, which was large enough for applications in high power devices. Additionally, the thermal and insulating properties of the TIM did not degrade after thermal shock testing, indicating its reliability for use in power devices. © 2011 Wiley Periodicals, Inc. J Appl Polym Sci, 2012     

Reduction mechanism of tioglycolic acid on keratin fibers using microspectrophotometry and FT-Raman spectroscopy

In order to investigate the reduction mechanism of thioglycolic acid (TG) on the keratin fibers, cross-sectional samples of white human hair treated with TG were prepared. The heterogeneous reaction between TG and keratin fibers involving the diffusion of TG into human hair was analyzed at the molecular level using microspectrophotometry and FT-Raman spectroscopy. The diffusion of TG into human hair clearly increased by increasing the treatment time and by raising pH. The TG relative concentration and the disconnected relative concentration of disulfide (–SS–) groups at various depths of the hair samples with pH 9.0 were in good agreement, indicating that the reaction rate (the disconnection of –SS– groups) was faster than the diffusion rate of TG into human hair. From these experiments, we demonstrated that TG diffuses gradually beyond the cuticle region, and toward the inside of the cortex region along with the disconnection of –SS– groups.     

Hydrocracking Marlim vacuum residue with natural limonite. Part 2: experimental cracking in a slurry-type continuous reactor

Disposable Australian iron-slurry (AL) and NiO-MoO₃-Al₂O₃ (NiMo) catalysts were used in hydrocracking experiments to convert Marlim vacuum residue (ML-VR) in a slurry-bed continuous flow reactor at temperatures of 440-460 °C, under a hydrogen pressure of 14.7 MPa and an LHSV of 0.5. The degree of conversion ranged from 54 to 83%, depending on the reaction temperature and catalyst used, with AL giving more complete conversion than NiMo. AL also proved more active in the removal of nickel. Hydrogen consumption was linearly correlated with conversion regardless of the catalyst used.     

Separation and determination of glycolipids from edible plant sources by high-performance liquid chromatography and evaporative light-scattering detection

Glycolipids from edible plant sources were accurately quantified by silica-based, normal-phase high-performance liquid chromatography using an evaporative light-scattering detector. Five major glycolipid classes (acylated steryl glucoside, steryl glucoside, ceramide monohexoside, monogalactosyldiacylglycerol, and digalactosyldiacylglycerol) were separated and determined with a binary gradient system consisting of chloroform and methanol/water (95∶5, vol/vol) without any interference from other lipid classes and pigments. The described method was applied to 48 edible plants available in Japan including cereals, legumes, vegetables, and fruits. Examined plant species contained glycolipids in wide concentration ranges, such as 5–645 mg/100 g tissue.     

Evaluation of cost reduction potential for 1 kW class SOFC stack production: Implications for SOFC technology scenario

Recently, a commercial version of a residential solid oxide fuel cell (SOFC) system with a flat tubular cell has been developed. However, the system cost still remains very high, which is a barrier to its widespread use. In this study, the potential for cost reductions in SOFC stack production was investigated in order to contribute to the viability of the widespread use of such residential SOFC systems in future. A cost analysis of 700 W SOFC stack production based on a process integration modeling was conducted. The present bottom–up approach enabled us to perform a sensitivity analysis with a variety of parameters in terms of cell design, the production process and cell performance. This allowed us to investigate the effects of these factors on the production cost, thereby revealing the quantitative impact of each technological improvement on the cost reduction potential. The present analysis also revealed innovation pathways which could result in technology scenarios where residential SOFC systems could reach a break-even point in comparison with the baseload electricity cost. The analysis of the cost reduction potential presented here provides a useful viewpoint for developing a research strategy for state-of-the-art SOFC technology.     

Tachykinins and tachykinin receptors in bone

Adrenomedullin (AM) was originally characterized in extracts of an adrenal medullary tumor. Since this original finding the peptide and its mRNA have also been found in the adrenal cortex, specifically, in the cells of the aldosterone-secreting zona glomerulosa. It is clear that the synthesis of AM is actively regulated in both cortex and medulla. Much research effort has been focused on identifying a role for AM in the adrenal gland. To date, no consistent effect on medullary catecholamine biosynthesis has been demonstrated. In the cortex the actions of AM are controversial and appear to depend on both the tissue preparation used and on the specific receptor population expressed in the individual gland. The results of further studies on the long-term actions of AM on adrenal growth and differentiation are awaited with interest.     

The measurement of hydrogen activities in molten copper using an oxide protonic conductor

We have developed a hydrogen sensor for in situ measurements of hydrogen activities in molten copper. The sensor consists of a concentration cell utilizing a proton conductor, CaZr_0.9In_0.1O_3-δ, as the solid electrolyte. The electromotive force (emf) of the cell was generated by both hydrogen and oxygen activity gradients across the cell in a high-temperature region simulating the fire refining processes of copper. However, accurate hydrogen activity in molten copper could be evaluated from the emf if oxygen activity in molten copper was determined simultaneously by another concentration cell and if the hydrogen and the oxygen activities at the reference electrode were known. The performance of the sensor was studied under various conditions. The observed good response and reliability of the sensor show that it should be a powerful tool for improvement of the fire refining process of the molten copper. Theoretical treatment of the calculation of the emf of the concentration cells using a mixed ionic conductor, i.e., protonic and oxide ionic conductor, as solid electrolytes is also discussed briefly.