既有钢筋混凝土框架结构抗震加固若干问题探讨

针对钢筋混凝土框架结构抗震加固问题的复杂性 ,本文深入分析了抗震加固结构的受力特征 ,探讨了卸荷对加固构件承载力的影响 ,并针对抗震加固后的“隐含危险转移”问题提出了相应的对策。最后 ,提出了抗震加固的基本原则 ,可供结构抗震加固时参考     

SAAB雷达与PROVOX系统的通讯

介绍了SAAB雷达液位计和SAAB雷达系统与上位系统的通讯接口FSC以及PROVOX系统的智能设备接口卡 (IDI)等的基本内容 ,并对SAAB雷达液位计与PROVOX系统通讯的硬件连接和PROVOX系统中关于IDI卡的组态方法进行说明     

A comparison between the enhanced mass transfer in boundary and pressure driven oscillatory flow

Mass transport in pulsating flow devices using either moving boundaries or oscillating imposed pressure drops are compared with each other by means of a calculation using a simple model. We conclude that there is no difference between the two configurations as long as one is interested only in the power required to move the fluid for the convective mass transport achieved. However, the boundary driven configuration is more efficient if the power is divided by the total mass transport where both the diffusive and convective parts are taken into account, the boundary driven configuration is more efficient. The amplitude of the piston stroke in the pressure driven configuration and the amplitude in the boundary driven case are assumed to be the same, and the inertia of the moving devices themselves are ignored in this calculation.     

电子束和接触式曝光机的混合曝光技术

Ⅰ线光致抗蚀剂可以同时实用电子束和光学系统曝光，在50kV加速电压下，其曝光剂量为50-100μC/cm^2，曝光后在0.7%NaOH溶液内显影1分钟。其灵敏度比PMMA快5倍，分辩率为0.5μm。采用两方法制备CaAsPHEMT：一种用Ⅰ线光致抗蚀剂，对源、漏及栅全部都采用电子束曝光，制备了0.5μm栅长的GaAs PHEMT；另一种将源、漏及栅分割成两部分，其中精细部分由电子束曝光，其余部分由光学系统曝光，用这种方法制备了0.25μm栅长的GaAs PHEMT。Ⅰ     

Use of weibull statistics to quantify property variability in TiAl alloys

Tensile experiments have been performed on specimens of four different investment-cast TiAl-based alloys with variations in casting conditions. The average ductilities obtained in these experiments vary between approximately 0.8 to 2.0 pct plastic strain to failure in tension. By using the three-parameter form of the Weibull relation, with the 0.2 pct offset yield strength as the minimum failure strength, the resulting variability in the data can be quantified and is found to be similar for those alloys with similar microstructural scale (grain size). Large variations in lamellar volume fraction, segregation, and phase distribution have a minor influence on property variability, compared to changes in the scale of the grain structure caused by either variations in cooling rate during casting or the addition of grain refiners.     

用化学腐蚀制备多孔硅太阳电池减反射膜的研究

采用HF HNO3溶液化学腐蚀 ,在硅片上制备减反射效果优良的多孔硅太阳电池减反射膜 ,借助原子力显微镜 (AFM)和X光电子谱 (XPS)对其表面形貌和成分进行观察 ,发现该膜与电化学阳极腐蚀得到的多孔硅具有相似性 ,其主要成分为非化学配比的硅的氧化物SiOx(X <2 )。采用带积分球的光度分光计 ,测得形成多孔硅减反射膜后 ,硅片表面反射率大大下降 ,,在波长 330～ 80 0nm范围反射率只有 1 5～ 2 9%。研究指出这种强减反射作用 ,与多孔硅具有合适的折射率及其多孔特性的光陷阱作用有关     

水蒸汽喷射泵系统实用设计软件的开发

本文在Turboc环境下开发了多级蒸汽喷射泵系统的设计软件，该软件包括了压缩比优化分配、单级喷射泵结构尺寸设计和冷凝器的结构尺寸设计等内容，使设计人员能够根据具体的工艺条件，快速地完成多级喷射泵系统的设计，对于提高多级喷射泵系统的工作稳定性、节省能源具有实际意义。