High-strength–high-modulus polyimide fibers II. Spinning and properties of fibers

The polyimides based on 3,3′,4,4′-biphenyltetracarboxylic dianhydride (BPDA) described in Part I of this series were dissolved in p-chlorophenol and spun into fibers using a coagulating bath of ethanol. The fibers as spun had in general low tenacities and low moduli, but a heat treatment at 300–500°C under tension produced a remarkable increase in strength and modulus, and fibers with a tensile strength of 26 g/den (3.1 GPa) and an initial modulus higher than 1,000 g/den (120 GPa) could be obtained. Thus, the annealed fibers of polyimides are comparable to aramid fibers in mechanical properties. To heating in air and in the saturated steam, the polyimide fibers showed higher resistance than the aramid fibers. The polyimide fibers surpassed the aramid fibers in resistance to acid treatment and ultraviolet (UV) irradiation, but were inferior in resistance to alkali treatment. The annealed fibers of polyimides displayed distinct X-ray diffraction patterns. The chain repeat distance of 20.5 Å determined on the fibers of polyimide prepared from BPDA and o-tolidine, and 20.6 Å determined on the fibers of polyimide derived from BPDA and 3,4′-diaminodiphenyl ether are reasonable when the dimensions of monomeric units and the shapes of the molecular chains are considered. The X-ray reflections of both polyimide fibers were indexed satisfactorily on the basis of postulated unit cells.     

Low core loss of Fe85Si2B8P4Cu1 nanocrystalline alloys with high Bs and B800

The Fe–Si–B–P–Cu nanocrystalline alloys exhibit high saturation magnetic flux density (B_s) as well as good soft magnetic properties such as low coercivity, high effective permeability and low magnetostriction after nanocrystallization. In this paper, the Fe₈₅Si₂B₈P₄Cu₁ alloy has been newly developed. On the viewpoint of magnetic softness, the Fe₈₅Si₂B₈P₄Cu₁ nanocrystalline alloy reveals low core loss (W) at a commercially frequency of 50 Hz in the maximum induction (B_m) range of up to 1.75 T, and the W in the B_m range of less than 1.8 T is smaller than that of the highest-graded oriented Si-steel due to high magnetic flux density at 800 A/m (B₈₀₀) of above 1.8 T and excellent magnetic softness originated from much higher Fe content and uniform nanocrystalline structure with small magnetostriction. The electrical resistivity (ρ) is relative higher than Si-steels. Thus the Fe–Si–B–P–Cu alloys are attractive for applying to magnetic parts such as motors, transducers, choke-coils and so-forth.     

Enzymatic Analysis of Positional Distribution of Fatty Acids in Solid Fat by 1,3-Selective Transesterification with Candida antarctica Lipase B

A protocol for the analysis of the positional distribution of fatty acids (FA) in solid triacylglycerols (TAG) was developed using sn-1(3) selective alcoholysis catalyzed by immobilized Candida antarctica lipase B (CALB). One part by weight of solid fat and ten parts by weight of ethanol (99.5 %) were warmed to liquefy the fat. After adding 0.44 parts by weight of CALB, the mixture was shaken at 50 °C for 10 min then at 30 °C for 2.8 h. The recovery of 2-MAG after the 3-h transesterification reaction was ca. 85 % of the maximum theoretical yield (33 mol%), with the loss of 15 % attributable to the acyl migration from sn-2 to sn-1(3). The recovery was similar to that of the solvent-free alcoholysis of structured lipids, 1,3-dipalmitoyl, 2-oleoyl glycerol and 1,3-dioleoyl, 2-palmitoyl glycerol, conducted at 30 °C for 3 h. In contrast, the acyl migration from sn-1(3) to sn-2 was hardly observed. Because the detected acyl migration was only in the direction of sn-2 to sn-1(3), and not vice versa, it is proposed to determine the FA composition of the sn-2 position of TAG by the gas chromatographic analysis of 2-MAG fraction recovered from the enzymatic reaction mixture, and the FA composition of sn-1(3) position by a mass balance using the FA composition of TAG and of the sn-2 position as inputs. The procedure was successfully applied to palm oil and shea butter, and docosahexaenoic acid (DHA)-rich single cell oil from Aurantiochytrium sp. KH105 for the first time.     

AstroSim: Collaborative Visualization of an Astrophysics Simulation in Second Life

Developed in the Second Life 3D online multiuser environment, AstroSim (astrophysics simulation) provides synchronous collaborative visualization for astronomers. Users can play, halt, and rewind simulations and annotate stars interactively to track individual stars and gain a better understanding of stellar dynamics and astrophysics phenomena. This article is part of a special issue on collaborative visualization.     

Fragmentation of the large subunit of ribulose-1,5-bisphosphate carboxylase by reactive oxygen species occurs near Gly-329

The large subunit (LSU) of ribulose-1,5-bisphosphate carboxylase/oxygenase (rubisco) in the illuminated lysates of wheat (Triticum aestivum L.) chloroplasts is broken down by reactive oxygen radicals into 37- and 16-kDa polypeptides. Analysis of the terminal amino acid residues of both fragments revealed that the C terminus of the 37-kDa fragment was Ser-328 and the N terminus of the 16-kDa fragment was Thr-330. Gly-329, which links the two fragments, was missing, suggesting that the fragmentation of the LSU in the lysates driven by oxygen-free radicals occurs at Gly-329. Purified rubisco, exposed to a hydroxyl radical-generating system, was also cleaved at the same site of the LSU. The cleavage site was positioned at the N-terminal end of the flexible loop (loop 6) within the beta/alpha-barrel domain, constituting the catalytic site of rubisco. The binding of a reaction intermediate analogue, 2-carboxyarabinitol 1,5-bisphosphate, to the active form of rubisco completely protected the enzyme from the fragmentation. The fragmentation was differentially affected by CO2, Mg2+, ribulose 1, 5-bisphosphate, or 2-carboxyarabinitol 1,5-bisphosphate. All these results indicate that the conformation of the catalytic site of the enzyme is involved as an important factor determining the breakdown of rubisco by reactive oxygen species. Reactive oxygen species generated at its catalytic site by a Fenton-type reaction may trigger the site-specific degradation of the LSU in the lysates of chloroplasts in the light.     

An investigation into the temperature sensitivity of strained andunstrained multiple quantum-well, long wavelength lasers: new insightand methods of characterization

The magnitude of the temperature rate of change of the threshold current density (J_th) is examined with respect to J_th , for a variety of unstrained and strained, long wavelength multiple quantum-well (MQW) lasers. A strong correlation is found between these parameters, and a new relationship describing the J_th -T relationship for these lasers is arrived at in terms of two new essentially temperature and length independent constants. A third constant, T_max, also appears which estimates the theoretical maximum operating temperature of the laser. It is proposed that these constants may prove to be more useful in characterizing the temperature sensitivity of semiconductor lasers than the conventional parameters T ₀ and I₀ which exhibit both a length and temperature dependence. Furthermore, an expression is found which relates the magnitude of T_max to adjustable device structural and material parameters, such as: the cavity length, L; facet reflectivity, R; transparency current density, J_tr; and, the modal gain coefficient, β. It is revealed that a close examination of this relationship may provide new insight into the physics of semiconductor lasers as well as a means for optimizing device design to obtain a high maximum operating temperature in order to eliminate the need for thermoelectric coolers in device packaging. Finally, the measured T_max, versus L characteristics of six different strained and unstrained MQW laser structures are presented     

Protective layer for high‐efficiency PDPs driven at low voltage

Abstract— The sustain pulse voltage of a panel for 66‐kPa Ne + Xe (5–30%) with an (SrCa)O protective layer is 20–40% lower than that with an MgO protective layer. The luminous efficiency of the panel with a Ne + Xe (30%) (SrCa)O protective layer is 1.5 times that of the conventional panel with a Ne + Xe (10%) MgO protective layer; the sustain pulse voltages of these panels are almost the same. The power loss caused by panel capacitance is proportional to the second power of the sustain pulse voltage. Using the (SrCa)O protective layer for Xe (5–30%), the power loss is reduced by 35–60% compared with the MgO protective layer. It follows that, using the (SrCa)O protective layer, we can increase the Xe content with little power loss and thus achieve high‐efficiency PDPs. As for MgO and CaO with Xe ions, electrons are probably ejected from only the defect states. On the other hand, as for the SrO with Xe ions, it is likely that electrons can be ejected from not only defect states but also the valance band. This seems to be the reason why the driving voltage is lower with the (SrCa)O protective layer than with the MgO protective layer.     

Therapeutic effects of prostacyclin analog on crescentic glomerulonephritis of rat

Prostacyclin (PGI2) is known to have a relaxative action on vascular smooth muscle, an inhibitory action against platelet activation and neutrophil function. Previous studies showed the preventive effects of PGI2 on lupus nephritis and Thy-1 nephritis, although the mechanism has not been clarified. Glomerular endothelial expression of intercellular adhesion molecule-1 (ICAM-1) is up-regulated in experimental and human glomerular diseases, and is known to facilitate leukocyte infiltration into the glomeruli, which ultimately induces the various glomerular injuries. In the present study, we evaluated the therapeutic effects of PGI2 on a rat model for crescentic glomerulonephritis and investigated its putative mechanism in relation to ICAM-1-mediated leukocyte recruitment. Wistar-Kyoto (WKY) rats were injected with nephrotoxic serum and received continuous intraperitoneal infusion of PGI2. PGI2 dramatically decreased proteinuria (123.0 +/- 18.8 vs. 31.6 +/- 4.5), crescent formation and deposition of fibrinogen in the glomeruli, while the deposition of rabbit IgG, rat IgG and rat C3 along the capillary walls was not changed. Furthermore, intraglomerular expression of ICAM-1 and infiltration of macrophages were significantly suppressed by administration with PGI2. In contrast, influx of CD4 or CD8 positive cells was not altered. The present results suggest that PGI2 shows the preventive effects on experimental crescentic glomerulonephritis by inhibiting intraglomerular coagulation and ICAM-1-mediated macrophage-glomerular endothelial cell adhesive pathway.     

Theory of powdered metal formation in electrochemistry—morphological instability in galvanostatic crystal growth under diffusion control

Following the presentation of the theory of powder formation in steady state electrocrystallization, some equations based on the linear instability theory in non-steady state deposition under diffusion control were derived; the galvanostatic case was then analysed using the theoretical equations obtained here.As a result, the dependences of powder growth and particle size on various physical parameters, such as current density, bulk concentration and temperature, were made quantitatively clear. Furthermore, a reliable basis was given to the induction time of powder formation which had formerly been liable to amibiguous discussion.