Maleated Natural Rubber as a Coupling Agent for Recycled High Density Polyethylene/Natural Rubber/Kenaf Powder Biocomposites

Kenaf powder (KP) was incorporated into recycled high density polyethylene (rHDPE)/natural rubber (NR) blend using an internal mixer at 165°C and rotor speed of 50 rpm. The tensile strength and elongation at break of the composites decreased, while the tensile modulus increased with increasing filler loading. The water absorption was found to increase as the filler content increased. The maleic anhydride grafted natural rubber was prepared and used to enhance the composites performance. The addition of MANR as a coupling agent improved the tensile properties of rHDPE/NR/KP biocomposites. The water absorption was also reduced with the addition of MANR.     

Applicability of the generalized scaling law to a pile-inclined ground system subject to liquefaction-induced lateral spreading

The generalized scaling law is based on the concept of two-stage scaling and allows currently available centrifuge facilities to model a large-scale prototype expanding over the spatial dimension ranging from 30 m or larger subject to earthquake motions. This paper presents the results of investigation on the applicability of the generalized scaling law to the fully nonlinear regime of soil-structure system with the induced strain level of 10% in the order of magnitude. The centrifuge model tests performed in this study under the modeling of models scheme consist of a pile model embedded in a inclined ground subject to liquefaction-induced lateral spreading. Four different centrifugal accelerations ranging from 13g to 50g are used whereas the actual size of the physical model is kept constant with an overall scaling factor of 1/100. The models are exposed to tapered sinusoidal input accelerations of frequency 0.59 Hz and amplitude 3.0 m/s² in prototype scale, and the results are compared in terms of prototype by applying the generalized scaling law. As for the response of the ground during shaking, essentially identical accelerations and excess pore water pressures are recorded for all cases, while the lateral displacement shows a variation ranging from 5% to 9% in terms of shear strain due to a slight variation in experimental conditions (e.g., input peak acceleration, achieved density distribution). Practically the same responses are measured among the cases in the dissipation phase of excess pore water pressure. With regard to pile behavior, nearly identical responses for the lateral displacements and bending moments are obtained for all cases both during and after shaking. These results demonstrated that the generalized scaling law is applicable to the fully nonlinear regime of soil-structure system subject to the cumulative shear strain in the order of 10% due to cyclic mobility of sands during earthquakes.     

Novel functional polymers: Poly(dimethylsiloxane)–polyamide multiblock copolymer. III. Synthesis and surface properties of disiloxane–aromatic polyamide multiblock copolymer

Disiloxane–aromatic polyamide(aramid) multiblock copolymers(2SiPASs) were synthesized using 1,3-bis(3-aminopropyl)-1,1,3,3-tetramethyldisiloxane(BATS) as an analog of aramidsilicone resin consisting of aromatic polyamide and poly(dimethylsiloxane) (PDMS). 2SiPASs afford a transparent and toughened plastic film. The surface properties of 2SiPAS were investigated by X-ray photoelectron spectroscopy (xps) and static contact angle measurement. The results of surface analysis suggested that BATS content of the 2SiPAS surface increased with increasing BATS content in bulk. The interaction between the platelets and the 2SiPAS surface was found to be very weak when the BATS content reached 26 wt % in bulk. © 1996 John Wiley & Sons, Inc.     

Selective permeation of sour gases through polymeric membranes modified by sulfolanes. I. Study of selective permeation of CO2 through modified polymeric membranes determined on different systems

Several sulfolanes such as 3-methylsulfolane, sulfolane, and 3-sulfolene were tested as modifiers in poly(trimethylsilyl methyl methacrylate) (PTMSMMA) and poly(trimethylsilyl propyne) (PMSP) to improve the selectivity of CO₂. The gas permeabilities for the PTMSMMA-blend membranes containing high 3-methylsulfolane content were determined on a nonvacuum system in which the membranes started to be measured at their steady states at 30°C; those for all the other membranes were determined in a vacuum system in which those membranes were measured after they reached their unsteady states at 30°C. The PTMSMMA-blend membrane containing 40% 3-methylsulfolane was found to give the best separation of CO₂ under the conditions in this study compared to all the PTMSMMA-blend membranes and the others prepared in our work; its ideal separation factors for CO₂ over N₂ were above 40 and its permeability coefficients of CO₂ increased to above 250 Barrer. The modifications of PMSP membranes by impregnating with sulfolane and blending with sulfolene were found to be effective in improving the selectivity for CO₂ over N₂ for the PMSP membrane. The ideal separation factors for CO₂ over N₂ for the modified PMSP membranes impregnated with 30% sulfolane and blended with 25% 3-sulfolene were improved to above 10 and 13, respectively. © 1996 John Wiley & Sons, Inc.     

Water permeation properties of SiO2-RSiO3/2 (R = methyl,vinyl, phenyl) thin films prepared by the sol-gel method on nylon-6 substrate

Nylon-6 substrates were coated with SiO₂-RSiO_3/2 (R = methyl, vinyl, phenyl) thin films by the sol-gel method, and their water permeability was evaluated Tetraethoxysilane (TEOS) and trifunctional alkoxides such as methyltriethoxysilane (MTES), vinyltriethoxysilane (VTES), and phenyltriethoxysilane (PhTES) were used as starting materials. Water permeability coefficients of the nylon-6 substrates coated with these SiO₂-RSiO_3/2 thin films were increased with an increase in the content of these trialkoxysilanes in the films. The water permeability coefficients of these coated nylon-6 substrates were smaller in the order of the systems TEOS-PhTES < TEOS-VTES < TEOS-MTES in the relatively low content of the trialkoxysilanes. © 1996 John Wiley & Sons, Inc.     

Numerical analysis of a dual refluxed PSA process during simultaneous removal and concentration of carbon dioxide dilute gas from air

The simultaneous removal and concentration of carbon dioxide present in ambient air were carried out by a dual refluxed Pressure Swing Adsorption (PSA) process with intermediate feed inlet position. The feed inlet position divides each column into rectifying and stripping sections from which enriched and lean gases can be simultaneously produced. A simple isothermal model with negligible axial dispersion and pressure drops through the PSA beds was developed to investigate the effects of various combinations of the operating variables and to analyze semi-quantitatively the effects of the main characteristic parameters such as the dimensionless feed inlet position (Z_R/L_T) and the stripping-reflux ratio (R_r). A good agreement between the model prediction and the experimental results was obtained. Moreover, an optimum feed inlet position was found and it corresponded to a position where the carbon dioxide mole ratio in the feed flux and that in the upstream flux leaving the stripping section were equal. The carbon dioxide mole ratio in the enriched product (Y_E) as well as that in the lean product (Y_L) were strongly dependent on the ratio of feed/enriched product flow rates (Q_F/Q_E) and the ratio of feed/lean product flow rates (Q_F/Q_L). Although the pressure ratio (P_a/P_d) was crucially important for the separation performance, a smaller value of R_r was sufficient to reach a performance which is unattainable in conventional PSA processes.     

Supercritical CO2 extraction of essential oils and cuticular waxes from peppermint leaves

Essential oils and cuticular waxes were extracted from peppermint leaves with supercritical carbon dioxide in a semicontinuous-flow extractor. The effects of CO₂ flow rate and pressure on the extraction rate were studied within the flow rate range of (4·1–9·8) × 10⁻⁵ kg s⁻¹ and the pressure range of 10–30 MPa. Flow rate effect indicated that the intraparticle diffusion resistance was not dominant in this process. The extraction rate of cuticular waxes increased remarkably with the pressure, whereas that of essential oils was almost constant as compared with cuticular waxes. The concentration of cuticular waxes at the exit of the extractor was close to the solubility of triacontane while that of essential oils was much lower than the solubility of 1-menthol.     

Structural and Functional Change in Albino Rat Retina Induced by Various Visible Light Wavelengths

The effects of visible light, from short to long wavelengths, on the retina were investigated functionally and histologically. The left eyes of Sprague–Dawley albino rats (6-weeks old, n = 6 for each wavelength) were exposed to seven narrow-band wavelengths (central wavelengths, 421, 441, 459, 501, 541, 581, and 615 nm) with bandwidths of 16 to 29 nm (half bandwidth, ±8–14.5 nm) using a xenon lamp source with bandpass filters at the retinal radiant exposures of 340 and 680 J/cm². The right unexposed eyes served as controls. Seven days after exposure, flash electroretinograms (ERGs) were recorded, and the outer nuclear layer (ONL) thickness was measured. Compared to the unexposed eyes, significant reductions in the a- and b-wave ERG amplitudes were seen in eyes exposed to 460-nm or shorter wavelengths of light. The ONL thickness near the optic nerve head also tended to decrease with exposure to shorter wavelengths. The decreased ERG amplitudes and ONL thicknesses were most prominent in eyes exposed to 420-nm light at both radiant exposures. When the wavelengths were the same, the higher the amount of radiant exposure and the stronger the damage. Compared to the unexposed eyes, the a- and b-waves did not decrease significantly in eyes exposed to 500-nm or longer wavelength light. The results indicate that the retinal damage induced by visible light observed in albino rats depends on the wavelength and energy level of the exposed light.     

Intermittent administration of brain-derived neurotrophic factor (BDNF) ameliorates glucose metabolism and prevents pancreatic exhaustion in diabetic mice

We previously demonstrated that repetitive administration of brain-derived neurotrophic factor (BDNF) ameliorates glucose metabolism and energy expenditure in obese diabetic db/db mice. However, we have not evaluated in detail the effect of single or intermittent BDNF administration on glucose metabolism in a diabetic animal model. The objectives of this study were to examine the dose-response effect and dosing interval of BDNF administration in db/db mice and to evaluate the effect of intermittent BDNF administration on pancreatic function in db/db mice. We evaluated the dose-response effect of BDNF by single administration in db/db mice. First, single administration of BDNF greater than 70 mg/kg significantly reduced blood glucose concentration one day after administered, and the BDNF effect was maintained for 6 d. Next, the effects of BDNF administered twice a week at 4, 10, 25, and 62.5 mg/kg on blood glucose concentration, and the effects of BDNF administered once a week at 10, 20, 30, 50, and 70 mg/kg on blood glucose concentration were examined in db/db mice. In the intermittent treatment studies, BDNF dose-dependently ameliorated glucose metabolism by not only the twice-a-week administration but also the once-a-week administration. Lastly, because BDNF reduces the food intake of obese hyperphagic diabetic mice, the effects of BDNF administered once or twice a week on the blood glucose concentration and plasma and pancreatic insulin concentrations in db/db mice were compared with those of the vehicle under pair-fed conditions. Under pair-fed conditions, the intermittent administration of BDNF (25 mg/kg, twice a week, or 50 mg/kg, once a week) significantly reduced the blood glucose concentration and increased the plasma and pancreatic insulin concentrations compared with those in the pair-fed vehicle-treated db/db mice. This indicates that the prolonged hypoglycemic effect of BDNF is not simply due to the reduction of food intake. In conclusion, we demonstrated that the intermittent administration of BDNF ameliorates glucose metabolism and prevents pancreatic exhaustion in obese diabetic mice. These findings indicate that BDNF may have potential as a unique hypoglycemic agent for the treatment of diabetes at a fundamental level with good patient compliance.     

Isolation and characterization of the Shiga toxin gene (stx)-bearing Escherichia coli O157 and non-O157 from retail meats in Shandong Province, China, and characterization of the O157-derived stx2 phages

Infection by Shiga toxin (Stx)-producing Escherichia coli of non-O157 and O157 serotypes are rare in China, but infection by O157 serotype was found in Shandong Province and three other provinces in China. To understand the reason for these rare infections and to determine the safety of retail meats in Shandong Province, we examined the distribution of Shiga toxin gene (stx)-bearing E. coli in retail meats and characterized the isolated stx-bearing strains. We used hybridization with DNA probes and isolated stx1- and/or stx2-positive E. coli from 31 (58%) of 53 retail meat samples, with beef showing the highest frequency (68%). Of 42 stx-positive isolates, none belonged to O157. Using the O157-specific immunomagnetic bead technique, we isolated E. coli O157 carrying the eae and stx2 genes from eight beef samples (26%). These strains produced little or no Stx2 and carried a unique q gene. Replication of the stx2 phages was detected in these strains, whereas stx2 phage replication was not detected in our previous study in which we examined similar stx2-bearing E. coli O157 strains from other Asian countries. Analysis of E. coli C600 lysogenized with the stx2 phages found in this study suggests that the lack of Stx2 production is due to changes in non-q gene region(s) of the phage genome or chromosomal mutation(s) in the host. Our data and reports by other workers suggest it is necessary to determine if various stx2-bearing E. coli O157 strains producing Stx2 to varying degrees are distributed in meats in various locations in China.