Removal of an Azo Dye from Wastewater through the Use of Two Technologies: Magnetic Cyclodextrin Polymers and Pulsed Light

Water pollution by dyes is a huge environmental problem; there is a necessity to produce new decolorization methods that are effective, cost-attractive, and acceptable in industrial use. Magnetic cyclodextrin polymers offer the advantage of easy separation from the dye solution. In this work, the β-CD-EPI-magnetic (β-cyclodextrin-epichlorohydrin) polymer was synthesized, characterized, and tested for removal of the azo dye Direct Red 83:1 from water, and the fraction of non-adsorbed dye was degraded by an advanced oxidation process. The polymer was characterized in terms of the particle size distribution and surface morphology (FE-SEM), elemental analysis (EA), differential scanning calorimetry (DSC), thermal gravimetric analysis (TGA), infrared spectrophotometry (IR), and X-ray powder diffraction (XRD). The reported results hint that 0.5 g and pH 5.0 were the best conditions to carry out both kinetic and isotherm models. A 30 min contact time was needed to reach equilibrium with a qmax of 32.0 mg/g. The results indicated that the pseudo-second-order and intraparticle diffusion models were involved in the assembly of Direct Red 83:1 onto the magnetic adsorbent. Regarding the isotherms discussed, the Freundlich model correctly reproduced the experimental data so that adsorption was confirmed to take place onto heterogeneous surfaces. The calculation of the thermodynamic parameters further demonstrates the spontaneous character of the adsorption phenomena (ΔG° = −27,556.9 J/mol) and endothermic phenomena (ΔH° = 8757.1 J/mol) at 25 °C. Furthermore, a good reusability of the polymer was evidenced after six cycles of regeneration, with a negligible decline in the adsorption extent (10%) regarding its initial capacity. Finally, the residual dye in solution after treatment with magnetic adsorbents was degraded by using an advanced oxidation process (AOP) with pulsed light and hydrogen peroxide (343 mg/L); >90% of the dye was degraded after receiving a fluence of 118 J/cm²; the discoloration followed a pseudo first-order kinetics where the degradation rate was 0.0196 cm²/J. The newly synthesized β-CD-EPI-magnetic polymer exhibited good adsorption properties and separability from water which, when complemented with a pulsed light-AOP, may offer a good alternative to remove dyes such as Direct Red 83:1 from water. It allows for the reuse of both the polymer and the dye in the dyeing process.     

Influence of Drying Temperature and Harvesting Season on Phenolic Content and Antioxidant and Antiproliferative Activities of Olive (Olea europaea) Leaf Extracts

Interest in plant compounds has increased, given recent evidence regarding their role in human health due to their pleiotropic effects. For example, plant bioactive compounds present in food products, including polyphenols, are associated with preventive effects in various diseases, such as cancer or inflammation. Breast and colorectal cancers are among the most commonly diagnosed cancers globally. Although appreciable advances have been made in treatments, new therapeutic approaches are still needed. Thus, in this study, up to 28 olive leaf extracts were obtained during different seasons and using different drying temperatures. The influence of these conditions on total polyphenolic content (measured using Folin–Ciocalteu assays), antioxidant activity (using Trolox Equivalent Antioxidant Capacity and Ferric Reducing Ability of Plasma assays) and antiproliferative capacity (using 3-(4,5-dimethylthiazol-2-yl)-2,5-diphenyltetrazolium bromide, MTT assays) was tested in breast and colorectal cancer cells. Increased phenolic composition and antioxidant and antiproliferative capacity are noted in the extracts obtained from leaves harvested in autumn, followed by summer, spring and winter. Regarding drying conditions, although there is not a general trend, conditions using the highest temperatures lead to the optimal phenolic content and antioxidant and antiproliferative activities in most cases. These results confirm previously published studies and provide evidence in support of the influence of both harvesting and drying conditions on the biological activity of olive leaf extracts.     

Pigment composition and color parameters of commercial Spanish red wine samples: linkage to quality perception

Anthocyanins play a crucial role in wine color. Thus, their analysis results essential for evaluating their contribution to perceived color in wines, attribute directly linked to quality judgements. In this context, this study was aimed at: (1) defining the color space of a relative large number of commercial oaked Spanish red wines and (2) establishing a linkage between wine coloring, anthocyanic composition, and quality perception of this set of wines. Therefore, CIELab parameters (a ₁₀*, b ₁₀*, L ₁₀*), monomeric anthocyanin contents analyzed by HPLC with ultraviolet and mass detection, and polymeric pigment content estimated by a protein precipitation assay combined with bisulfite bleaching were evaluated in a total of 58 wine samples. Principal component analysis was performed on color variables, and their correlations were discussed. The results have evidenced the important role played by the pyranoanthocyanic compounds since they seem to be the main contributors to the red color of these aged wines, and they have been demonstrated not to increase their yellow nuances. On the other hand, results highlight that, regardless of the time of aging, wines presenting more red (higher values for a ₁₀* and for low molecular weighted anthocyanins) and lower yellow nuances (lower values for b ₁₀* and T) as well as a darker color (lower in L ₁₀* and higher in CI) are in general evaluated with higher quality scores by wine experts.     

Stability of DON and DON-3-glucoside during baking as affected by the presence of food additives

The mycotoxin deoxynivalenol (DON) is one of the most common mycotoxins of cereals worldwide, and its occurrence has been widely reported in raw wheat. The free mycotoxin form is not the only route of exposure; modified forms can also be present in cereal products. Deoxynivalenol-3-glucoside (DON-3-glucoside) is a common DON plant conjugate. The mycotoxin concentration could be affected by food processing; here, we studied the stability of DON and DON-3-glucoside during baking of small doughs made from white wheat flour and other ingredients. A range of common food additives and ingredients were added to assess possible interference: ascorbic acid (E300), citric acid (E330), sorbic acid (E200), calcium propionate (E282), lecithin (E322), diacetyltartaric acid esters of fatty acid mono- and diglycerides (E472a), calcium phosphate (E341), disodium diphosphate (E450i), xanthan gum (E415), polydextrose (E1200), sorbitol (E420i), sodium bicarbonate (E500i), wheat gluten and malt flour. The DON content was reduced by 40%, and the DON-3-glucoside concentration increased by >100%, after baking for 20 min at 180°C. This confirmed that DON and DON-3-glucoside concentrations can vary during heating, and DON-3-glucoside could even increase after baking. However, DON and DON-3-glucoside are not affected significantly by the presence of the food additives tested.     

Ochratoxin A in wines,musts and grape juices from Spain

A survey on the occurrence of ochratoxin A (OTA) in 240 grape‐based beverages was carried out. Red and white wines from four different Spanish Designations of Origin (n = 160), musts (n = 20), grape juices (n = 10), ordinary wines (n = 20), special wines (Malaga, muscatel, sherry, vermouth, etc) (n = 20) and sparkling wines (n = 10) were assayed for OTA content using immunoaffinity column clean‐up and high‐performance liquid chromatography with fluorimetric detection (detection limit 0.05 µg l^?1). Forty‐three (17.9%) of the samples tested contained detectable levels of OTA. The overall mean OTA concentration in red and white wines of Designations of Origin was 0.30 and 0.18 µg l^?1 respectively (ranges 0.05–3.19 and 0.05–1.13 µg l^?1 respectively). The percentage of wine samples with detectable amounts of OTA was higher for red (18.3%) than for white (10%) wines. OTA was also found in two of 10 red ordinary wines (0.68 and 4.24 µg l^?1), whereas none of 10 white ordinary wines contained OTA. The mean OTA amount detected in sparkling wines was 0.44 µg l^?1 (range 0.14–0.71 µg l^?1). Two of 20 must samples contained OTA at low levels (0.08 and 0.18 µg l^?1), while none of 10 grape juice samples contained OTA. Highest amounts of OTA were found in special wines (45%), with a maximum of 15.25 µg l^?1 in a muscatel sample. Copyright © 2004 Society of Chemical Industry     

Computational Shelf-Life Dating: Complex Systems Approaches to Food Quality and Safety

Shelf-life is defined as the time that a product is acceptable and meets the consumers expectations regarding food quality. It is the result of the conjunction of all services in production, distribution, and consumption. Shelf-life dating is one of the most difficult tasks in food engineering. Market pressure has lead to the implementation of shelf-life by sensory analyses, which may not reflect the full quality spectra. Moreover, traditional methods for shelf-life dating and small-scale distribution chain tests cannot reproduce in a laboratory the real conditions of storage, distribution, and consumption on food quality. Today, food engineers are facing the challenges to monitor, diagnose, and control the quality and safety of food products. The advent of nanotechnology, multivariate sensors, information systems, and complex systems will revolutionize the way we manage, distribute, and consume foods. The informed consumer demands foods, under the legal standards, at low cost, high standards of nutritional, sensory, and health benefits. To accommodate the new paradigms, we herein present a critical review of shelf-life dating approaches with special emphasis in computational systems and future trends on complex systems methodologies applied to the prediction of food quality and safety.     

Lipidomic Approaches to Study HDL Metabolism in Patients with Central Obesity Diagnosed with Metabolic Syndrome

The metabolic syndrome (MetS) is a cluster of cardiovascular risk factors characterised by central obesity, atherogenic dyslipidaemia, and changes in the circulating lipidome; the underlying mechanisms that lead to this lipid remodelling have only been partially elucidated. This study used an integrated “omics” approach (untargeted whole serum lipidomics, targeted proteomics, and lipoprotein lipidomics) to study lipoprotein remodelling and HDL composition in subjects with central obesity diagnosed with MetS (vs. controls). Compared with healthy subjects, MetS patients showed higher free fatty acids, diglycerides, phosphatidylcholines, and triglycerides, particularly those enriched in products of de novo lipogenesis. On the other hand, the “lysophosphatidylcholines to phosphatidylcholines” and “cholesteryl ester to free cholesterol” ratios were reduced, pointing to a lower activity of lecithin cholesterol acyltransferase (LCAT) in MetS; LCAT activity (directly measured and predicted by lipidomic ratios) was positively correlated with high-density lipoprotein cholesterol (HDL-C) and negatively correlated with body mass index (BMI) and insulin resistance. Moreover, many phosphatidylcholines and sphingomyelins were significantly lower in the HDL of MetS patients and strongly correlated with BMI and clinical metabolic parameters. These results suggest that MetS is associated with an impairment of phospholipid metabolism in HDL, partially led by LCAT, and associated with obesity and underlying insulin resistance. This study proposes a candidate strategy to use integrated “omics” approaches to gain mechanistic insights into lipoprotein remodelling, thus deepening the knowledge regarding the molecular basis of the association between MetS and atherosclerosis.     

Impact of cycling temperatures on Fusarium verticillioides and Fusarium graminearum growth and mycotoxins production in soybean

BACKGROUND: Fusarium graminearum and F. verticillioides are two very important mycotoxigenic species as they cause diverse diseases in crops. The effects of constant and cycling temperatures on growth and mycotoxin production of these species were studied on soybean based medium and on irradiated soya beans. RESULTS: F. graminearum grew better when was incubated at 15, 20 and 15–20 °C (isothermal or cycling temperature) during 21 days of incubation. Maximum levels of zearalenone and deoxynivalenol (39.25 and 1040.4 µg g^?1, respectively) were detected on soya beans after 15 days of incubation and the optimal temperature for mycotoxin production was 15 °C for zearalenone and 20 °C for deoxynivalenol. F. verticillioides grew better at 25 °C in culture medium and at 15/20 °C and 15/25 °C on soybean seeds. Fumonisin B₁ was produced only in culture medium, and the maximum level (7.38 µg g^?1) was found at 15 °C after 7 days of incubation. CONCLUSION: When growth and mycotoxin production under cycling temperatures were predicted from the results under constant conditions, observed values were different from calculated for both species and substrate medium. Therefore, care should be taken if data at constant temperature conditions are to be extrapolated to real field conditions. Copyright © 2012 Society of Chemical Industry     

Supercomputing and grid computing on the verification of covering arrays

The Covering Arrays (CAs) are mathematical objects with minimal coverage and maximum cardinality that are a good tool for the design of experiments. A?covering array is an N×k matrix over an alphabet v s.t. each N×k subset contains at least one time each combination from {0,1,??,v?1} ^t , given a positive integer value?t. The process of ensuring that a CA contains each of the v ^t combinations is called verification of CA. In this paper, we present an algorithm for CA verification and its implementation details in three different computation paradigms: (a)?sequential approach (SA); (b)?parallel approach (PA); and (c)?Grid approach (GA). Four different PAs were compared in their performance of verifying a matrix as a CA; the PA with the best performance was included in a different experimentation where the three paradigms, SA, PA, and GA were compared in a benchmark composed by 45 possible CA instances. The results showed the limitations of the different paradigms when solving the verification of CA problem, and points out the necessity of a Grid approach to solve the problem when the size of a CA grows.