Reduction of NRRO in ball bearings for HDD spindle motors

In this paper, it is theoretically and experimentally analyzed that the non-repetitive run-out (NRRO) of a ball bearing is caused by geometrical errors of the inner and outer races and the balls, and the number of balls.

The results are summarized as follows:

(1) As for the geometrical errors of the inner and outer races, it is possible to reduce the NRRO to be less than 1 nm by choosing 12 or 18 number of balls, even if the inner and outer races have a harmonic undulation of less than the 11th order.

(2) The NRRO of a ball bearing with 12 balls is very small even if the geometrical errors of ball bearing parts are large. It was confirmed that 12 was an optimal number of balls for ball bearings used for HDD spindle motors.

     

InxGa1−xAs ohmic contacts to n-type GaAs with a tungsten nitride barrier

Significant reduction of the contact resistance of In_0.7Ga_0.3As/Ni/W contacts (which were previously developed by sputtering in our laboratory) was achieved by depositing a W₂N barrier layer between the Ni layer and W layer. The In_0.7Ga_0.3 As/Ni/W₂N/W contact prepared by the radio-frequency sputtering technique showed the lowest contact resistance of 0.2 Ωmm after annealing at 550°C for 10 s. This contact also provided a smooth surface, good reproducibility, and excellent thermal stability at 400°C. The polycrystalline W₂N layer was found to suppress the In diffusion to the contact surface, leading to improvement of the surface morphology and an increase in the total area of the In_xGa−As between metal and the GaAs substrate. These improvements are believed to reduce the contact resistance.     

Preparation of phosphoric acid resins with large cation exchange capacities from macroreticular poly(glycidyl methacrylate-co-divinylbenzene) beads and their behavior in uptake of metal ions

In order to prepare phosphoric acid resins (RGPs) with large cation exchange capacities, effects of porosity and cross-linking of the precursory poly(glycidyl methacrylate-co-divinylbenzene) beads on their functionalization with phosphoric acid were studied. Two series of precursory copolymers were prepared: one was prepared by changing the amount of divinylbenzene (1–25 mol %) but by fixing that of isobutyl acetate (porogen) at 140 vol % per monomer mixture; the other by changing the amount of the porogen (40–160 vol %) but by fixing that of the cross-linker at 10 mol %. It was clarified that porosity of the precursors plays an important role in the functionalization. Highly porous precursors were functionalized with high efficiency; for example, even the precursors containing 10 mol % of divinylbenzene resulted in RGPs having cation exchange capacities as large as 6–7 meq/g, so long as BET specific surface areas of the precursors were greater than ca. 30 m²/g. The selectivity study has revealed that RGP exhibits the characteristic metal ion selectivity. Lithium ion was adsorbed in preference to sodium and potassium ions; and so-called hard Lewis acid cations, such as uranyl, ferric, and aluminum ions, are adsorbed even from strongly acidic media (1 < pH < 2). Among common divalent metal ions, in addition, the resin exhibits the highest selectivity toward lead ion. © 1997 John Wiley & Sons, Inc. J Appl Polym Sci 63: 1327–1334, 1997     

Multiple evaluations of the removal of pollutants in road runoff by soil infiltration

Groundwater replenishment by infiltration of road runoff is expected to be a promising option for ensuring a sustainable urban water cycle. In this study, we performed a soil infiltration column test using artificial road runoff equivalent to approximately 11-12 years of rainfall to evaluate the removal of pollutants by using various chemical analyses and bioassay tests. These results indicated that soil infiltration treatment works effectively to remove most of the pollutants such as organic matter (chemical oxygen demand (CODMn) and dissolved organic carbon (DOC)), P species, polycyclic aromatic hydrocarbons (PAHs), numerous heavy metals and oestrogenic activities. Bioassay tests, including algal growth inhibition test, Microtox and mutagen formation potential (MFP) test, also revealed effective removal of toxicities by the soils. However, limited amounts of NO3, Mn, Ni, alkaline earth metals, perfluorooctane sulphonate (PFOS) and perfluorooctane sulphonamide (FOSA) were removed by the soils and they possibly reach the groundwater and cause contamination.     

Clinical application of single-shot echo-planar diffusion-weighted imaging with compressed SENSE in prostate MRI at 3T: preliminary experience

Magnetic Resonance Materials in Physics, Biology and Medicine - Image quality (IQ) of diffusion-weighted imaging (DWI) with single-shot echo-planar imaging (ssEPI) suffers from low signal-to-noise...     

1.5 nm direct-tunneling gate oxide Si MOSFET's

In this paper, normal operation of a MOSFET with an ultra-thin direct-tunneling gate oxide is reported for the first time. These high current drive n-MOSFET's were fabricated with a 1.5 nm direct-tunneling gate oxide. They operate well at gate lengths of around 0.1 μm, because the gate leakage current falls in proportional to the gate length, while the drain current increases in inverse proportion. A current drive of more than 1.0 mA/μm and a transconductance of more than 1,000 mS/mm were obtained at a gate length of 0.09 μm at room temperature. These are the highest values ever obtained with Si MOSFET's at room temperature. Further, hot-carrier reliability is shown to improve as the thickness of the gate oxide is reduced, even in the 1.5 nm case. This work clarifies that excellent performance-a transconductance of over 1,000 mS/mm at room temperature-can be obtained with Si MOSFET's if a high-capacitance gate insulator is used     

Cranial Base Synchondrosis Lacks PTHrP-Expressing Column-Forming Chondrocytes

The cranial base contains a special type of growth plate termed the synchondrosis, which functions as the growth center of the skull. The synchondrosis is composed of bidirectional opposite-facing layers of resting, proliferating, and hypertrophic chondrocytes, and lacks the secondary ossification center. In long bones, the resting zone of the epiphyseal growth plate houses a population of parathyroid hormone-related protein (PTHrP)-expressing chondrocytes that contribute to the formation of columnar chondrocytes. Whether PTHrP⁺ chondrocytes in the synchondrosis possess similar functions remains undefined. Using Pthrp-mCherry knock-in mice, we found that PTHrP⁺ chondrocytes predominantly occupied the lateral wedge-shaped area of the synchondrosis, unlike those in the femoral growth plate that reside in the resting zone within the epiphysis. In vivo cell-lineage analyses using a tamoxifen-inducible Pthrp-creER line revealed that PTHrP⁺ chondrocytes failed to establish columnar chondrocytes in the synchondrosis. Therefore, PTHrP⁺ chondrocytes in the synchondrosis do not possess column-forming capabilities, unlike those in the resting zone of the long bone growth plate. These findings support the importance of the secondary ossification center within the long bone epiphysis in establishing the stem cell niche for PTHrP⁺ chondrocytes, the absence of which may explain the lack of column-forming capabilities of PTHrP⁺ chondrocytes in the cranial base synchondrosis.     

Low-temperature thermionic emission from nitrogen-doped nanocrystalline diamond films on n-type Si grown by MPCVD

Temperature-dependent emission current–voltage measurements were carried out for nitrogen (N)-doped nanocrystalline diamond (NCD) films grown on n-type Si substrates by microwave plasma-assisted chemical vapor deposition (MP-CVD). Low threshold temperature (~ 260 °C) and low threshold electric field (~ 5 × 10^− 5 V/µm) were observed. Both the temperature dependence and the electric field dependence have shown that the obtained emission current was based on electron thermionic emission from N-doped NCD films. We have also studied the relation between nitrogen concentration and the saturation emission current. The saturation current obtained was as high as 1.4 mA at 5.6 × 10^− 3 V/µm at 670 °C when the nitrogen concentration was 2.4 × 10²⁰ cm^− 3. Low value of effective work function (1.99 eV) and relatively high value of Richardson constant (~ 70) were estimated by well fitting to Richardson–Dushman equation. The results of smaller φ and larger A′ suggest that N-doped NCD has great possibility of being a highly efficient thermionic emitter material.