The effect of hydrogen on boron diffusion in SiO2

The diffusivity of boron in silicon dioxide may be increased by the introduction of hydrogen into the annealing atmosphere. In this paper we report on the diffusion characteristics of boron ion-implanted into thermally grown SiO₂. A sensitive technique was used in which the boron atoms redistributed into the substrate are characterized by electrical methods. The diffusivity of boron in thermal SiO₂ was measured over the temperature range of 950-1150°C with hydrogen partial pressure from 0 to 0.2 atm. It was found that the diffusion coefficient of boron in oxide at 1150° C increases as the square root of the hydrogen partial pressure. At fixed pressure the temperature dependence of the diffusion coefficient obeys a single-activation-energy exponential rule. At 0.1 atm partial pressure of H₂ the activation energy is 3.0 eV and the preexponential factor is 6 x 10⁵ [cm²/sec.].     

External-cavity semiconductor laser with 15 nm continuous tuning range

A 1.26 ?m optical amplifier with a facet modal reflectivity below 0.0001 has been used in a 58 mm-long grating external cavity. The lasing wavelength has been continuously tuned without mode hopping over a range of 15 nm by combined translation-rotation of the diffraction grating. A linewidth of 20 kHz has been derived from heterodyne beat frequency measurements between two tunable external-cavity lasers.     

Optimizing mechanical and magnetic properties of AlCoCrFeNi high-entropy alloy via FCC to BCC phase transformation

FCC,BCC and B2 phases,the most common phases in high-entropy alloys(HEAs),are widely investigated to tailor their mechanical and magnetic performances.The detailed investigation of FCC to BCC/B2 phase transformation of AlCoCrFeNi HEA in this paper reveals its evolution and structure-properties relations in terms of both temperature and holding duration.With increasing heat treatment temperature and duration,such transition will progress simultaneously at both the dendric core(DC)region and inter-dendric(ID)region and the volume of phase transformation from FCC to BCC phases is greater than FCC to B2 phases,resulting in increased yield strength and saturation magnetization.The obvious phase transition of the AlCoCrFeNi HEA at 1200℃can enhance its yield strength and saturation magnetization as a sacrifice of its fracture strain.However,an excellent combination of mechanical-magnetic properties was achieved when heat-treated at 1100℃for 50 h by optimizing both the transformation and the size of B2 phases.Our present study could pave ways to design the HEAs or other alloys with an optimum combination of mechanical and magnetic properties for application-oriented viewpoints.     

Speciation of arsenic, chromium, and vanadium in red mud samples from the Ajka spill site, Hungary

Results are presented from X-ray absorption spectroscopy based analysis of As, Cr, and V speciation within samples of bauxite ore processing residue (red mud) collected from the spill site at Ajka, Western Hungary. Cr K-edge XANES analysis found that Cr is present as Cr(3+) substituted into hematite, consistent with TEM analysis. V K-edge XANES spectra have E(1/2) position and pre-edge features consistent with the presence of V(5+) species, possibly associated with Ca-aluminosilicate phases. As K-edge XANES spectra identified As present as As(5+). EXAFS analysis reveals arsenate phases in red mud samples. When alkaline leachate from the spill site is neutralized with HCl, 94% As and 71% V are removed from solution during the formation of amorphous Al-oxyhydroxide. EXAFS analysis of As in this precipitate reveals the presence of arsenate Al-oxyhydroxide surface complexes. These results suggest that in the circumneutral pH, oxic conditions found in the Torna and Upper Marcal catchments, incorporation and sorption, respectively, will restrict the environmental mobility of Cr and As. V is inefficiently removed from solution by neutralization, therefore, the red mud may act as a source of mobile V(5+) where the red mud deposits are not removed from affected land.     

Real-time PCR detection and quantification of nine potential sources of fecal contamination by analysis of mitochondrial cytochrome b targets

We designed and tested real-time PCR probe/primer sets to detect and quantify Cytochrome b sequences of mitochondrial DNA (mtDNA) from nine vertebrate species of pet (dog), farm (cow, chicken, sheep, horse, pig), wildlife (Canada goose, white-tailed deer), and human. Linear ranges of the assays were from 10(1) to 10(8) copies/microl. To formally test the performance of the assays, twenty blinded fecal suspension samples were analyzed by real-time PCR to identify the source of the feces. Sixteen of the twenty samples were correctly and unambiguously identified. Average sensitivity was calculated to be 0.850, while average specificity was found to be 0.994. One beef cow sample was not detected, but mtDNA from 11 other beef cattle of both sexes and varying physiological states was found in concentrations similar (3.45 x 10(7) copies/g) to thatfound in human feces (1.1 x 10(7) copies/g). Thus, environmental conditions and sample handling are probably important factors for successful detection of fecal mtDNA. When sewage samples were analyzed, only human mtDNA (7.2 x 10(4) copies/ 100 mL) was detected. With a detection threshold of 250 copies/reaction, an efficient concentration and purification method resulted in a final detection limit for human feces of 1.8 mg/ 100 mL water.     

Inactivation of Shiga toxin-producing O157:H7 and non-O157:H7 Shiga toxin-producing Escherichia coli in brine-injected, gas-grilled steaks

We quantified translocation of Escherichia coli O157:H7 (ECOH) and non-O157:H7 verocytotoxigenic E. coli (STEC) into beef subprimals after brine injection and subsequently monitored their viability after cooking steaks cut therefrom. Beef subprimals were inoculated on the lean side with ca. 6.0 log CFU/g of a five-strain cocktail of rifampin-resistant ECOH or kanamycin-resistant STEC, and then passed once through an automatic brine-injector tenderizer, with the lean side facing upward. Brine solutions (9.9% ± 0.3% over fresh weight) consisted of 3.3% (wt/vol) of sodium tripolyphosphate and 3.3% (wt/vol) of sodium chloride, prepared both with (Lac(+), pH = 6.76) and without (Lac(-), pH = 8.02) a 25% (vol/vol) solution of a 60% potassium lactate-sodium diacetate syrup. For all samples injected with Lac(-) or Lac(+) brine, levels of ECOH or STEC recovered from the topmost 1 cm (i.e., segment 1) of a core sample obtained from tenderized subprimals ranged from ca. 4.7 to 6.3 log CFU/g; however, it was possible to recover ECOH or STEC from all six segments of all cores tested. Next, brine-injected steaks from tenderized subprimals were cooked on a commercial open-flame gas grill to internal endpoint temperatures of either 37.8 °C (100 °F), 48.8 °C (120 °F), 60 °C (140 °F), or 71.1 °C (160 °F). Regardless of brine formulation or temperature, cooking achieved reductions (expressed as log CFU per gram) of 0.3 to 4.1 of ECOH and 0.5 to 3.6 of STEC. However, fortuitous survivors were recovered even at 71.1 °C (160 °F) for ECOH and for STEC. Thus, ECOH and STEC behaved similarly, relative to translocation and thermal destruction: Tenderization via brine injection transferred both pathogens throughout subprimals and cooking highly contaminated, brine-injected steaks on a commercial gas grill at 71.1 °C (160 °F) did not kill all cells due, primarily, to nonuniform heating (i.e., cold spots) within the meat.     

Factors associated with carcass contamination by Campylobacter at slaughterhouse in cecal-carrier broilers

A study was conducted in 2009 to identify risk factors of Campylobacter spp. transmission from the digestive tract to the carcasses of standard broilers (slaughter age: 37 day, carcass weight: 1.3 kg on average). Counts of Campylobacter were performed on pools of 10 ceca and 10 neck-skins from 108 Campylobacter ceca-positive batches in three slaughterhouses. Technical and health data also was collected on the broilers: age, size, carcass weight (mean and standard deviation), condemnation rate, mortality rate and nature of treatment during the rearing period.Cecal counts varied from 4.8 to 10.2 log₁₀ cfu/g. In seventeen batches (15.7%), the skin count was below the detection limit. In the 91 batches with positive neck-skin test results, the counts varied from 2.0 to 5.2 log₁₀ cfu/g. Standard deviation of carcass weight, condemnation rate, slaughter rate and cecal count were significantly lower and growth rate higher in the 17 batches where neck-skin results were not detected positive. Multivariate analysis showed that batches with higher standard deviation of carcass weight were 5 to 9 fold more at risk of having detectable carcass contamination. Among the 91 positive neck-skin batches, only slaughter rate and cecal counts were found to have a significant but limited effect on the level of neck-skin contamination. As far as body weight homogeneity may be affected by disease, better health control can contribute to a reduction of the contamination of the broiler carcasses in Campylobacter carrier batches.