Temporary leukocyte depletion reduces ventricular dysfunction during prolonged postischemic reperfusion

Leukocyte depletion improves early postischemic ventricular performance in neonatal models of global myocardial ischemia. However, the rate of leukocyte reaccumulation after cardiopulmonary bypass and its subsequent impact on myocardial function is not known. This laboratory study examined the effect of leukocyte depletion on myocardial performance during the initial 6-hour period after bypass in an in situ, in vivo porcine model of neonatal cardiac surgery. Fifteen 3- to 5-day-old piglets (eight control and seven leukocyte depleted animals) were instrumented by placement of left ventricular short-axis sonomicrometry crystals and an intraventricular micromanometer catheter. Mechanical leukocyte depletion was achieved with Pall RC100 filters (Pall Biomedical, Inc., Fajardo, Puerto Rico) in the cardiopulmonary bypass circuit. Neonatal hearts were subjected to 90 minutes of hypothermic ischemia after a single dose of cold crystalloid cardioplegia. Two control animals died after the operation and were excluded from data analysis. Leukocyte filtration reduced the granulocyte count during initial myocardial reperfusion to 0.8% of control values. However, circulating granulocyte counts increased in leukocyte depleted animals throughout the postoperative period, reaching 68% of control values by 6 hours. Despite this rapid return of circulating granulocytes, animals subjected to leukocyte depletion had significantly better preservation of left ventricular performance (measured by preload recruitable stroke work, p < or = 0.02), left ventricular systolic function (measured by end-systolic pressure-volume relationship, p < or = 0.05), and ventricular compliance (p < or = 0.04) during the experiment. These changes in ventricular function were associated with a significant increase in left ventricular water content (p < or = 0.02) and tissue myeloperoxidase activity (p < or = 0.005) in control animals compared with leukocyte depleted animals. This study demonstrates that leukocyte depletion during initial reperfusion results in sustained improvement in postischemic left ventricular function despite the rapid return of granulocytes to the circulation.     

Chronic fluoride exposure does not cause detrimental, extraskeletal effects in nutritionally deficient rats

On the basis of observations that endemic fluorosis occurs more often in malnourished populations, a series of studies tested the hypothesis that deficient dietary intake of calcium, protein or energy affects fluoride metabolism so that the margin of safe fluoride exposure may be reduced. The objective of the investigation was to determine whether changes in fluoride metabolism in nutritionally deficient rats resulted in manifestation of any extraskeletal toxic fluoride effects not observed in healthy animals. This investigation included two studies, one that monitored the effect of calcium deficiency on the effects of chronic fluoride exposure, and a second study that observed fluoride effects in rats that were deficient either in protein or in energy and total nutrient intake. Control and experimental rats received drinking water containing 0, 0.26 (5), 0.79 (15) or 2.63 (50) mmol fluoride/L (mg/L) for 16 or 48 wk. Control rats were fed optimal diets and experimental rats were fed diets deficient in calcium (Study 1) or protein (Study 2). An additional group of experimental rats (Study 2) was provided with a restricted amount of diet; thus these rats were deficient in energy and total nutrient intake. The intake, excretion and retention of fluoride were monitored; after the rats were killed, tissue fluoride levels and biochemical markers of tissue function were analyzed. Bone marrow cells were harvested from some of the rats, after 48 wk of treatment, for determining the frequency of sister chromatid exchange, a marker of genetic damage. Although there were significant differences among fluoride treatment groups in fluoride excretion and retention that resulted in significantly greater fluoride levels in tissues of the experimental rats, we were unable to detect any harmful, extraskeletal biochemical, physiologic or genetic effects of fluoride in the nutritionally deficient rats.     

A new monitoring system for piping systems in fossil fired power plants

A CEC-funded project has been performed to tackle the problem of producing an advanced Life Monitoring System (LMS) which would calculate the creep and fatigue damage experienced by high temperature pipework components. Four areas were identified where existing Life Monitoring System technology could be improved:

1. 1. the inclusion of creep relaxation

2. 2. the inclusion of external loads on components

3. 3. a more accurate method of calculating thermal stresses due to temperature transients

4. 4. the inclusion of high cycle fatigue terms.

The creep relaxation problem was solved using stress reduction factors in an analytical in-elastic stress calculation. The stress reduction factors were produced for a number of common geometries and materials by means of non-linear finite element analysis. External loads were catered for by producing influence coefficients from in-elastic analysis of the particular piping system and using them to calculate bending moments at critical positions on the pipework from load and displacement measurements made at the convenient points at the pipework. The thermal stress problem was solved by producing a completely new solution based on Green's Function and Fast Fourier transforms. This allowed the thermal stress in a complex component to be calculated from simple non-intrusive thermocouple measurements made on the outside of the component. The high-cycle fatigue problem was dealt with precalculating the fatigue damage associated with standard transients and adding this damage to cumulative total when a transient occurred.

The site testing provided good practical experience and showed up problems which would not otherwise have been detected.     

Processing of Yttria-Alumina Coated Silicon Nitride Slips by Slip Casting

Si₃N₄powders coated with 6 wt% Y₂O₃and 4 wt% Al₂O₃were prepared by coprecipitation. The resulting powders were dispersed in water at different pH values and with addition of various amounts of ammonium polyacrylate (NH₄PA) to produce 32 vol% slips. The influence of the amount of NH₄PA solution added and pH on the rheological properties of 32 vol% coated Si₃N₄slips were studied. In addition, the sintered density of cast samples was determined and related to the degree of slip dispersion. The adsorption of the NH₄PA on the coated particle surface was rather high and the surface became saturated near 0.86 mg/m²at pH 9.2. High NH₄PA concentrations (1.7–3 wt%) were necessary to obtain well dispersed 32 vol% coated Si₃N₄slips at pH 9.2. The best stabilization was obtained with the addition of 2.3 wt% NH₄PA; in this condition, the viscosity reached a minimum value of 35 mPa.s at 100 s^–1. The slip viscosity increased with increasing pH from 9.2 to 10.2. Slips with low viscosities gave a more dense packing of cast samples and consequently higher sintered density values.     

Simulation of magnetic component models in electric circuitsincluding dynamic thermal effects

It is essential in the simulation of power electronics applications to model magnetic components accurately. In addition to modeling the nonlinear hysteresis behavior, eddy currents and winding losses must be included to provide a realistic model. In practice the losses in magnetic components give rise to significant temperature increases which can lead to major changes in the component behavior. In this paper a model of magnetic components is presented which integrates a nonlinear model of hysteresis, electro-magnetic windings and thermal behavior in a single model for use in circuit simulation of power electronics systems. Measurements and simulations are presented which demonstrate the accuracy of the approach for the electrical, magnetic and thermal domains across a variety of operating conditions, including static thermal conditions and dynamic self heating     

Rheological and drug‐release behaviour of a scleroglucan gel matrix at different drug loadings

The aim of this study was to investigate the drug‐loading effects on release and mechanical properties of a scleroglucan gel, with the intention of considering them in delivery systems formulations. The rheological and kinetic properties of a 2 % w/w scleroglucan gel matrix loaded with 0, 0.02, 0.04, 0.06, 0.2 and 0.4 % w/w of theophylline (Th, used as a model drug) were investigated. Rheological measurements were performed in a controlled‐stress rotational‐shear rheometer under isothermal conditions. For theophylline release from the gel a flat Franz cell was used and the kinetic parameters were derived applying a semi‐empirical power law. The influence of scleroglucan molar weight on kinetic and rheological behaviour was also studied. Results suggest two possible effects of drug loading on the gel network: in the 0.04–0.06 % w/w Th range a plasticizing effect and in the 0.2–0.4 % w/w Th range a rigidization effect. In the first range mentioned, the changes in the gel structural properties tested by means of rheological measurements are coincident with changes in drug‐release kinetics. Copyright © 2005 Society of Chemical Industry     

Rate of ammonia oxidation in a synthetic saline wastewater by a nitrifying mixed‐culture

Most of the kinetic studies on nitrification have been performed in diluted salts medium. In this work, the ammonia oxidation rate (AOR) was determined by respirometry at different ammonia (0.01 and 33.5 mg N‐NH₃ L^?1), nitrite (0–450 mg N‐NO₂^? L^?1) and nitrate (0 and 275 mg N‐NO₃^? L^?1) concentrations in a saline medium at 30 °C and pH 7.5. Sodium azide was used to uncouple the ammonia and nitrite oxidation, so as to measure independently the AOR. It was determined that ammonia causes substrate inhibition and that nitrite and nitrate exhibit product inhibition upon the AOR. The effects of ammonia, nitrite and nitrate were represented by the Andrews equation (maximal ammonia oxidation rate, r_AOMAX, = 43.2 [mg N‐NH₃ (g VSS_AO h)^?1]; half saturation constant, K_SAO, = 0.11 mg N‐NH₃ L^?1; inhibition constant K_IAO, = 7.65 mg N‐NH₃ L^?1), by the non‐competitive inhibition model (inhibition constant, K_INI, = 176 mg N‐NO₂^? L^?1) and by the partially competitive inhibition model (inhibition constant, K_INA, = 3.3 mg N‐NO₃^? L^?1; α factor = 0.24), respectively. The r_AOMAX value is smaller, and the K_SAO value larger, than the values reported in diluted salts medium; the K_IAO value is comparable to those reported. Process simulations with the kinetic model in batch nitrifying reactors showed that the inhibitory effects of nitrite and nitrate are significant for initial ammonia concentrations larger than 100 mg N‐NH₄⁺ L^?1. Copyright © 2005 Society of Chemical Industry     

N.m.r. line shape-relaxation correlation analysis of bitumen and oil sands

The first results of the analysis of bitumen and oil sands using the recently developed n.m.r. spingrouping technique are presented. The n.m.r. relaxation experiments were carried out on bitumen, and on natural and dried oil sands samples. The results indicate that the spin-grouping can resolve and quantify several components of the samples studied. The bitumen and bitumen fraction of the oil sands are resolved according to their spin-spin relaxation times into three major groups: solid-like (rigid), solid-like (mobile) and semi-liquid. The water in the oil sands exists in two different environments. Tentatively one environment is assigned to be the bridges between the sand grains, while the other is assigned to be the clay surface. One can conclude that with spin grouping of complex mixtures the decomposition (in which components are resolved according to their dynamic state) is possible. The accuracy of such resolution is of the order of a few per cent.