生物质中元素分布特征的聚类分析研究

测定了稻草秆、小麦秆、玉米秆、棉花秆、大豆秆、玉米芯、花生壳和柳树、松树、桦树、杨树、杉树 1 2个农业生物质和林业生物质种类 2 7个样品中主要元素 K,Ca,Na,Mg,Al,Fe,P和痕量元素 As,Cr,Co,Cu,Cd,Mn,Mo,Ni,Pb,Ti,Zn,V,Si,Ba,Be,Se,Sb,Ge,Hg的含量 ,并用SPSS聚类分析法分别进行了 R型和 Q型聚类研究 ,对这些元素在生物质中的分布特征进行了研究 .结果显示 :杨木、杉木和桦木与松木和柳木归成一大类 ,经济类作物黄豆秆和棉花秆分别归类后又归入一大类 ;农业生物质稻草秆和小麦秆、玉米秆被归入一类 ;虽然 2 7种生物质样品分别取自我国东北、华东、华北和西南地区 ,在地理位置上相距极远 ,但样品聚类谱系图表明 ,元素的分布特征与生物质的种类的关系显著 ,与产地的关系不明显 ,即元素的分布特征受种类的影响大 ,而受生长环境、气候、土壤条件的影响小 .     

热熔凝聚法加工农药悬浮剂研究

介绍了采用热熔凝聚法对加工二氯喹磷酸、氟虫睛、乙霉威悬浮剂的试验结果，并测定了制剂的粒度分布、冷贮、热贮稳定性等理化性质。该法工艺简单、加工方便、节省能源、工业上切实可行。     

羰基结构与亲核加成反应

羰基化合物是一类极为重要的有机化合物，本文从(1)醛酮(2)环酮(3)α，β-不饱和羰基化合物的结构讨论了羰基结构对其亲核加成活性的影响。     

Point-based online value iteration algorithm in large POMDP

Partially observable Markov decision process (POMDP) is an ideal framework for sequential decision-making under uncertainty in stochastic domains. However, it is notoriously computationally intractable to solving POMDP in real-time system. In order to address this problem, this paper proposes a point-based online value iteration (PBOVI) algorithm which involves performing value backup at specific reachable belief points, rather than over the entire belief simplex, to speed up computation processes, exploits branch-and-bound pruning approach to prune the AND/OR tree of belief states online, and proposes a novel idea to reuse the belief states that have been searched to avoid repeated computation. The experiment and simulation results show that the proposed algorithm can simultaneously satisfy the requirement of low errors and high timeliness in real-time system.     

Collaborative representation with reduced residual for face recognition

Collaboration representation-based classification (CRC) was proposed as an alternative approach to the sparse representation method with similar efficiency. The CRC is essentially a competition scheme for the training samples to compete with each other in representing the test sample, and the training class with the minimum representation residual from the test sample wins the competition in the classification. However, the representation error is usually calculated based on the Euclidean distance between a test sample and the weighted sum of all the same-class samples. This paper exploits alternative methods of calculating the representation error in the CRC methods to reduce the representation residual in a more optimal way, so that the sample classes compete with each other in a closer range to represent the test sample. A large number of face recognition experiments on three face image databases show that the CRC methods with optimized presentation residual achieve better performance than the original CRC, and the maximum improvement in classification accuracy is up to 12 %.     

Guerbet十四醇的合成与表征

以正庚醇为原料 ,通过Guerbet反应合成Guerbet十四醇 (2 戊基壬醇 ,C14 GA)。用IR、NMR和元素分析测定了C14 GA的结构 ,并研究了反应温度和用料比对其产率的影响。实验结果如下 :(1)在较优化的反应条件下 (正庚醇的总加入量为 1mol,在实验过程中 ,先加入 1/ 3mol庚醇和 1/ 4mol的KOH ,在 16 0℃下反应 2h ,然后再加入剩下的 2 / 3mol庚醇和 4g 5 %Pd -C催化剂 ,在 15 5℃下反应 6h)合成产物 ,其产率可达到 5 4 2 0 % ;(2 )所合成的产物与试图要得到的Guerbet十四醇 (2 戊基壬醇 ,C14 GA)含有相同的基团 (2×—CH3、10×—CH2 —、1×CH、1×—CH2 —O—和 1×—OH) ,而且 ,所合成的产物中 ,w (C) =79 0 6 % ,w (H ) =13 6 2 % ,与从Guerbet十四醇分子式计算的理论值w(C) =78 5 0 % ,w (H) =14 0 1%基本一致。可见所合成的产物正是Guerbet十四醇 (C14 GA)     

ATO包裹硅酸锆的制备与应用

采用化学共沉淀技术制备了锑掺杂二氧化锡(ATO)包裹硅酸锆的导电粉体,对比了该导电粉体与ATO在防静电陶瓷中的应用效果。结果表明与掺纯ATO相比较,掺入ATO包裹硅酸锆的防静电陶瓷颜色比较浅,并且能明显减少氧化锡的用量,当陶瓷的表面电阻为107Ω/□量级时,用ATO包裹硅酸锆作为导电填料可以节省25%左右的ATO。     

炭分子筛概述

阐述了炭分子筛分离的原理，并分别从其制备原料、制备方法、产品用途等方面综述了近年来炭分子筛的新进展。     

Propylene epoxidation in a microreactor with electric heating

Gas phase propylene epoxidation on gold catalysts has attracted wide attention from industry and academia due to its high selectivity. However, it suffers from low propylene conversion and rapid catalyst deactivation. Experiments showed that propylene conversion could be increased by raising H₂, O₂, or C₃H₆ concentration in the feed, but the feed compositions were within the explosion limit. It was also shown that the activity of the used catalyst could be fully recovered, but the regeneration temperature was 280 °C, much higher than that for reaction. Therefore a microchannel reactor was devised to suppress explosion and was constructed with Fecralloy, to raise the temperature rapidly for catalyst regeneration by electric heating. In two minutes the temperature of the reactor could be raised from 50 to 300 °C. Catalysts were coated on the alloy belt by dip coating, and the performance of the reactor was evaluated under different operating conditions. Results showed that in the microreactor the overall reaction rate was controlled mainly by the intrinsic reaction rate, and also influenced by film diffusion to a certain extent. The deactivated catalyst was regenerated in the microchannel reactor and the activity was fully recovered.     

熔融石英耐火材料

阐述了熔融石英耐火材料的主要性能与应用领域。