含硫化氢气井钻井过程中的腐蚀因素与防护研究

在含硫气井的钻井过程中对于HRC大于22的钻具钢材除了腐蚀疲劳之外，在pH值小于9的环境中会发生硫化物应力腐蚀破裂，这种破坏比腐蚀疲劳更突然、更快，使钻杆大量损坏。含硫气井在钻井过程中，由于湿硫化氢的出现，常常会出现油管、套管、钻井设备、钻井仪器以及对支持保护管柱的水泥环柱等腐蚀和损坏问题，为此，阐述了湿硫化氢的腐蚀特点、机理，归纳总结了影响腐蚀的因素，综述了如何在这些方面防止其腐蚀，使损失减小，为指导油管、套管防腐工程实践提供了依据。建议在钻井过程中采用碱性钻井液，其pH值可到9或更高(至pH值12)，以减缓或防止钻井过程中电化学从硫化物应力腐蚀破裂；含硫气井用的钻杆应该间歇使用。钻杆停用堆置时间可使其放氢，使钻杆恢复韧性，防止硫化物应力腐蚀断裂。     

Degree-of-polarization and eye-closure penalty associated with optical signals with orthogonal polarizations

We perform a systematic measurement of the degree-of-polarization (DOP) and eye-closure penalty for optical signals with orthogonal polarizations. We find that the symmetry of DOP is maintained for the orthogonal polarizations under both first and higher order polarization-mode dispersion (PMD), whereas the symmetry of eye-closure penalty is broken under second-order PMD. An orthogonal polarization pair can have large disparity of eye-closure penalty despite an identical DOP. We also demonstrate a novel approach to estimate the maximum eye-closure penalty asymmetry with three orthogonal polarizations on the Poincare/spl acute/ sphere.     

Finite sample size effect on minimum variance beamformers: optimum diagonal loading factor for large arrays

Minimum variance beamformers are usually complemented with diagonal loading techniques in order to provide robustness against several impairments such as imprecise knowledge of the steering vector or finite sample size effects. This paper concentrates on this last application of diagonal loading techniques, i.e., it is assumed that the steering vector is perfectly known and that diagonal loading is used to alleviate the finite sample size impairments. The analysis herein is asymptotic in the sense that it is assumed that both the number of antennas and the number of samples are high but have the same order of magnitude. Borrowing some results of random matrix theory, the authors first derive a deterministic expression that describes the asymptotic signal-to-noise-plus-interference ratio (SINR) at the output of the diagonally loaded beamformer. Then, making use of the statistical theory of large observations (also known as general statistical analysis or G-analysis), the authors derive an estimator of the optimum loading factor that is consistent when both the number of antennas and the sample size increase without bound at the same rate. Because of that, the estimator has an excellent performance even in situations where the quotient between the number of observations is low relative to the number of elements of the array.     

四川盆地及邻区上二叠统一下三叠统海槽的深水沉积特征

四川盆地及邻区广元-旺苍、城口-鄂西、开江-梁平海槽是上二叠统一下三叠统飞仙关组（P3-T1f）的深水碳酸盐沉积区。该区上二叠统上部大隆组是硅质岩、硅质泥岩、硅质灰岩组合，含放射虫、有孔虫等化石，厚125—29．0m，为海槽裂陷期凝缩沉积。三叠系飞仙关组下部为远洋沉积的暗色泥岩、微晶碎屑灰岩和重力流沉积的浊积岩、角砾灰岩组成的深水碳酸盐沉积，厚50．0～300．0m，是裂陷期后的海槽充填沉积。海槽相区沉积在晚二叠统世末达到最大海泛面沉积了大隆组。海平面缓慢下降期沉积了补偿充填性质的飞仙关组深水碳酸盐岩。海槽相区上二叠统一下三叠统飞仙关组构成了一个完整的三级层序。深水沉积物的有机碳平均值高达6．21％，是良好的烃源岩。但在海槽相区上二叠统不发育生物礁，飞仙关组缺乏鲕粒岩。     

微构造的地震识别与应用效果

胜利油田的油气勘探具有较大的剩余勘探潜力，且大部分油气蕴藏在微构造油气藏中。微构造油气藏在胜利油田的勘探开发老区均有分布，纵向上从沙四段到东营组均有发育。该类油气藏埋深浅、储层物性好、产量高，具有较高的经济效益。微构造油气藏在国内外研究较少，国内外较注重目的层沉积微构造的研究，且主要是沉积微构造对注采关系的影响。在对复杂断块的精细研究中，以前研究的重点也主要集中在应用钻井资料对断层的成因和对断层封堵性的研究上，而对微构造圈闭的成因、识别及成图，一直没有进行系统的分类研究。文章划分了微构造的类型，研究了微构造的特点，并认为构造作用、沉积作用和后期改造作用是微构造形成的３种主要原因。同时，利用地震资料对微构造圈闭的识别方法和描述技术进行了探索，形成了一套具有针对性的技术系列，取得了显著的效果，这对油气田老区的滚动勘探开发具有重要的意义。     

Formation and inhibition of free radicals in electrically stressed and aged insulating polymers

Previous work has shown that prebreakdown, electrical aging, and breakdown phenomena are directly associated with charge carriers injected from electrical contacts and their subsequent dissociative trapping and recombination. In addition, the energy released from each trapping or recombination event is dissipated in the breaking of the bonds of macromolecules, thus forming free radicals and new traps in the electrically stressed insulating polymers, as predicted by Kao's model. It is this gradual degradation process that leads to electrical aging and destructive breakdown. New experimental results are presented to confirm previous findings and a new approach to inhibit the degradation process by the incorporation of suitable dopants into the polymer. The concentration of free radicals in the polymer increases with an increasing electric field at a fixed stress time of 250 h and with increasing stress time at a fixed electric field of 833 kV cm^?1. The concentration of free radicals is directly related to the concentration of new traps created by stress. However, when suitable dopants are incorporated, the initiation voltage for the occurrence of electrical treeing and the breakdown strength are both increased. The dopants tend to create shallow traps and have little effect on the deep trap concentration. This implies that the dopants act as free‐radical scavengers that tend to satisfy the unpaired electrons of the broken bonds, which create new acceptor‐like electron traps and new shallow traps. By doing so, the shallow traps screen the deep traps, thereby reducing the energy released during trapping and recombination and the probability of breaking the macromolecular bonds and causing structural degradation. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 89: 3416–3425, 2003     

Formulation of a ceramic ink for a wide-array drop-on-demand ink-jet printer

This paper describes the methodology for simulating a reprographic ink with a ceramic ink based on a commercially available zirconia powder for direct ceramic ink-jet printing. Of over-riding importance was matching viscosity and this was tested systematically by using a mineral oil–hexane binary system. Of secondary importance was adjustment of the pressure defect behind the nozzle to compensate for small differences in surface tension. The inks tested in the wide array print-head were based on low electrical conductivity liquids to avoid damage to the electroding system. The organic binder for the zirconia ink was paraffin wax and the dispersant was a hydroxystearic acid based polyester.     

Quantum mechanical effects on noise properties of nanoelectronic devices: application to Monte Carlo simulation

A discussion about the quantum mechanical effects on noise properties of ballistic (phase-coherent) nanoscale devices is presented. It is shown that quantum noise can be understood in terms of quantum trajectories. This interpretation provides a simple and intuitive explanation of the origin of quantum noise that can be very salutary for nanoelectronic engineers. In particular, an injection model is presented that, coupled with a standard Monte Carlo algorithm, provides an accurate modeling of quantum noise. As a test, the standard results of noise in tunneling junction devices are reproduced within this approach.     

Analysis of the Scattering Characteristic of Several Waveguide Components Using Boundary Element Method

Several kinds of waveguide components such as curved waveguide bends, arbitrary angle waveguide bends and T-junctions have been analyzed with boundary element method in this paper. A new discretization method for the boundary element method to solve the waveguide discontinuities has been given. The numerical results obtained agree well with the experimental results and numerical results in other literature. Especially, the scattering characteristics of Forded E-, H-plane T-junctions in 3mm band have been analyzed using boundary element method and the calculation results are presented.