DTM320／580型磨煤机传动齿轮轴断裂原因分析及防范措施

介绍了DTM580/320型磨煤机传动齿轮轴断裂的情况,并进行了分析;找到了断裂的原因,提出了防范措施。     

A miniature UWB planar monopole antenna with 5-GHz band-rejection filter and the time-domain characteristics

A planar monopole antenna with a staircase shape and small volume (25/spl times/26/spl times/1 mm/sup 3/) is proposed in this paper. With the use of a half-bowtie radiating element, the staircase-shape, and a modified ground plane structure, the proposed antenna has a very wide impedance bandwidth measured at about 11.6 GHz (2.9-14.5 GHz, bandwidth ratio about 1:5) below VSWR 2 including the WLAN band notched in the vicinity of 5 GHz. An omnidirectional radiation pattern is obtained. The group delay which is an indication of linearity between two proposed antennas is less than 1 ns. The electrical characteristics in terms of frequency and time domains and physical ones of the proposed antenna make it attractive for use in ultrawideband (UWB) systems.     

Operation, system architectures, and physical Layer design considerations of distributed MAC protocols for UWB

Impulse-based ultra wideband (I-UWB) is an attractive radio technology for large ad hoc and sensor networks due to its robustness to harmful multipath effects, sub-centimeter ranging ability, simple hardware, and low radiated power. To scale to large sizes, networks often implement distributed medium access control (MAC) protocols. However, most MAC protocols for I-UWB are centralized, and they target small wireless personal area networks and cellular networks. We propose three distributed MAC protocols suitable for I-UWB. Two multichannel protocols, called multichannel pulse sense multiple access (M-PSMA) and multichannel ALOHA achieve high aggregate throughput. A busy-signal protocol, called busy-signal multiple access (BSMA), reduces the energy wasted from re-transmitted packets. This paper describes the three protocols in terms of the protocol's operation, the supporting system architecture, and the I-UWB physical layer. Physical layer simulations confirm the feasibility of implementing the proposed systems and also provide parameters for network simulations. Network simulations show that the throughput of M-PSMA exceeds that of a centralized time-division multiple-access protocol and that the energy efficiency of BSMA far surpasses that of other distributed protocols.     

XML技术在控制回路识别中的应用

介绍了一种基于XML的可视化软集成电路系统,给出其设计思想和体系结构。并在总结前人控制回路识别方法的基础上,推出XML技术在回路识别方法中的应用。     

Dynamic deformation behavior of ultrafine-grained low-carbon steels fabricated by equal-channel angular pressing

The dynamic deformation behavior of ultrafine-grained low-carbon steels fabricated by equal-channel angular pressing (ECAP) was investigated in this study. Dynamic torsional tests, using a torsional Kolsky bar, were conducted on four steel specimens, two of which were annealed at 480 °C after ECAP, and then the test data were compared in terms of microstructures, tensile properties, and adiabatic shear-band formation. The equal-channel angular pressed specimen consisted of very fine, equiaxed grains of 0.2 to 0.3 μm in size, which were slightly coarsened after annealing. The dynamic torsional test results indicated that maximum shear stress decreased with increasing annealing time, whereas fracture shear strain increased. Some adiabatic shear bands were observed at the gage center of the dynamically deformed torsional specimen. Their width was smaller in the equal-channel angular pressed specimen than in the 1-hour-annealed specimen, but they were not found in the 24-hour-annealed specimen. Ultrafine, equiaxed grains of 0.05 to 0.2 μm in size were formed inside the adiabatic shear band, and their boundaries had characteristics of high-angle grain boundaries. These phenomena were explained by dynamic recrystallization due to a highly localized plastic strain and temperature rise during dynamic deformation.     

微振动对空间实验室微重力环境的影响研究

针对大型刚柔组合体空间结构(空间实验室)的特点,建立系统的动力学方程,并对机柜内设备、太阳阵的转动、宇航员活动产生的激扰力进行了简化。利用计算机建立组合体的简化模型,对空间组合体在各种微振动激扰下的加速度响应进行了仿真研究,并将这些仿真结果用于空间实验室微重力环境的预测。     

营养型发酵软饮料的研究

研究利用稻加工大米的副产品碎米为主要原料 ,加入麦芽、加酶 ,进行液化、糖化、发酵等工艺 ,研制出一种发酵营养型软饮料。本产品与啤酒相比 ,可减少原料总用量的 17% ,减少麦芽用量的 2 8.6%。     

Knight：一个通用知识挖掘工具

现有知识挖掘系统普遍存在通用性不好，发现方法单一的弱点。     

德布罗意波及其非相对论近似

通过分析德布罗意义和速度特性，说明了它是相对论意义下的波，讨论了在非相对论量子力学中，以经典能量代入德布罗意关系式进行了计算的原因。     

THEIL不等系数法在水下自航器仿真模型验证中的应用

该文讨论了ＴＨＥＩＬ不等系数法在水下自航器仿真模型验证使用时的有关问题，提出两种模型验证方案，通过数字仿真的方法讨论了ＴＨＥＩＬ不等系数对初值的不确定，随机测量噪声，不同验模方这杂的适用性。