一个面积和功耗优化且适用于10/100 Base-T以太网的CMOS时钟恢复电路

提出了一个新的用于10 / 10 0 Base- T以太网中面积和功耗优化的时钟恢复电路.它采用双环路的结构,加快了锁相环路的捕获和跟踪速度;采用复用的方式,通过选择信号控制电路可分别在10 Mbps或10 0 Mbps模式下独立工作且能方便地实现模式间的互换,与采用两个独立的CDR电路相比节省了一半的面积;同时,电路中采用一般的延迟单元来取代DL L,并能保证环路性能不随工艺温度等条件引起的延迟单元、延迟时间的变化而变化,从而节省了功耗.Hspice模拟结果显示,在Vdd=2 .5 V时,10 0 Mbps模式下电路的功耗约为75 m W,稳态相差为0 .3 ns;10 Mbps模式时电路功耗为5 8m W     

STRUCTURE REPRESENTATION OF THE SPECIFIC FRACTIONS FROM PINGSHUO COAL

Basic data of four fractions, PM₁, PM₆, PM₇and PM₈, derived from Pingshuo bituminous coal were obtained by ultimate analyses, mean molecular weight measure, GC/MS, ¹³C-NM R, ¹H-NM R and FTIR technigues. A method of calculating the average molecular parameters of the fractions is introduced. Based on the calculated parameters, the molecular structure models of the fractions of PM₆, PM;and PM₈are constructed. Significant structural information about the saturated hydrocarbon and aromatic hydrocarbon with heteroatom groups is given also.     

渤中28－1（BZ28－1）油田N6H水平井动态分析

本文以渤中２８－１（ＢＺ２８－１）油田Ｎ６Ｈ水平井为例，从多方面对该井的动态和产能变化进行了系统分析，所用的方法对水平井动态分析有一定的指导意义。     

微机模拟处理pH络合滴定法研究——Ⅱ.终点确定方法和最佳实验条件模拟估计程序

本文利用简便的滴定过程模型,确立了微机模拟处理实验数据,方便、准确地求解络合滴定等当点的方法。设计了最佳实验条件模拟估计程序。该法测定Zn~(2+),Pb~(2+),Cu~(2+),Fe~(3+)结果的相对误差Δ<1％。pH=6-7时,测定Ca~(2+)的相对误差为-1.61％;σ<0.001mmol,(N=5)。     

Luminescence Characterization of Mg Doped Y2O2S:Ti Long Afterglow Phosphor

Y1.94-xMgxO2S:0.06Ti (0≤x≤0.10) phosphors with long afterglow were synthesized by solid state reaction route. The photoluminescence spectra, decay curves, thermoluminescent spectra and chromaticity coordinate curves were investigated. The results show that the luminescence intensity of Y1.94-xMgxO2S:0.06Ti (0≤x≤0.10) phosphors decrease gradually with increasing Mg2 ion content, and the shape of luminescence spectra and chromaticity coordinate change as well. Furthermore, two thermoluminescent peaks in single Ti-doped Y2O2S sample are found at 91.8 and 221.5 ℃, respectively. Nevertheless, significant different spectra were found for the Mg, Ti co-doped Y2O2S samples that three thermoluminescence peaks appear at 52.3, 141.7 and 226.8 ℃, respectively. These results indicate that the co-doped Mg ion changes the inherent trap depth of single Ti-doped Y2O2S:Ti phosphor, and induces simultaneously a new trap level in the Y1.94-xMgxO2S:0.06Ti phosphor. Based on the analysis of thermoluminescent spectra, photoluminescent spectra, decay curve and crystal structure defect, it was proposed that the varied structure defect and introduced new trap level by the doped Mg2 ions should be responsible for reducing luminescence intensity and varying color in the Y1.94-xMgxO2S:0.06Ti phosphor.     

有机介质中合成二硫化钛

本文研究了硫化氢与四氯化钛在某些有机介质中的反应，并提出了一个合成二硫化钛的新方法。该法是将干燥的硫化氢通入沸腾的四氯化铁的α－氯代萘溶液中，使硫化氢和四氯化钛发生复分解反应而生成二硫化钛。方法简便易行。Ｘ－射线物相鉴定及化学分析结果表明，产物为单一物相的、符合化学计量的二硫化钛。     

坑道用水下堵漏剂的研制

坑道水下堵漏剂的研制包括F－1、F－2和F－3型。其中F－1是一种有机堵漏剂，它可以在水中固化；F－2是一种无机防水堵漏剂，施工方便；F－3是速凝型，它可在瞬间固化，能对坑道的涌水口进行堵漏。     

On the Cutoff Wavelength of Rectangular-Shaped Microshield Line by Edge Element Method

In this paper, the cutoff characteristic of rectangular-shaped microshield transmission line has been analysed by edge element method. Dependence of cutoff wavelengths on the thickness of metallic signal strip, dielectric constant of dielectric substrate and the width of the rectangular-shaped ground conductor are presented in tabular form. Numerical results in this paper have important values in design of rectangular-shaped microshield lines in microwave and millimeter wave integrated circuits.     

用Mastercam9.1软件加工汽车覆盖件模具的工艺及编程

分析汽车覆盖件模具的特点,以汽车发动机内横梁左右安装支架模具制造为实例,介绍了用Mastercam 9.1软件对汽车覆盖件模具数控加工工艺的拟定,并说明了数控加工中参数的设置及编程.     

DCS在30m~3聚合釜控制中的应用

介绍了电化厂聚合技改后的聚合釜温度控制方案,CS3000DCS在控制中的应用。实现了从进料、升温、恒温、直至反应结束的全过程自动控制,在操作站实现了动态工程流程图、控制分组、历史趋势等显示功能,可变参数在权限范围内的下载及报表打印等功能。