直吹式制粉系统一次风量测量装置的改造

电站锅炉系统中一、二次风风量及制粉通风量是重要的控制参数之一,在测量上,传统采用机翼型测量装置。但这种测量装置工作并不稳定、不准确,并影响锅炉自动投入率。造成的原因主要是被测量对象为含尘气流、且测量装置所处的位置没有足够的直管段。通过市场调研与反复比较,最后选择了文丘里测量装置,在安庆电厂2号锅炉（320 MW机组）直吹式制粉系统的进行了相应的改造,测试结果稳定准确,取得了明显的改造效果。     

氨氯地平对高血压患者颈动脉内膜中层厚度的影响

目的:观察氨氯地平对原发性高血压病人颈动脉内膜中层厚度的影响.方法:选择134例1、2级高血压病人,随机分为两组,A组氨氯地平5-10mg,每日1次;B组吲哒帕胺1.5g,每日1次;治疗12周.如血压不达标可加用ACEI或ARB类药物.结果:治疗2周后两组血压均明显下降,4周后血压趋于达标并稳定,两组的降压幅度无显著差别.12周后与治疗前比较,两组IMT均降低,A组IMT降低更明显,两组比较有显著差异.结论:氨氯地平对逆转原发性高血压病人颈动脉IMT的效果显著.     

Spray-drying of alumina powder for APS: effect of slurry properties and drying conditions upon particle size and morphology of feedstock

In this paper, effects of variables concerning slurry properties and drying conditions on the particle size and morphology of feedstock were discussed. The results indicated that, the increase of powder loading increased D ₅₀ and volume content but reduced recovery rate slightly. Other variables, such as inlet temperature, showed a maximum on the desired property. The particle size of resulting feedstock increased with the rise of feeding rate of slurry, however, decreased with the increase of atomization pressure based on the premise that atomization pressure was enough to force slurry to form the liquid membrane. For preparation of spherical feedstock, optimized variables were as follows: 60 wt.% powder in slurry, 2 wt.% PVA in slurry, inlet temperature of 60°C, atomization pressure of 13 × 10³ KPa and feeding rate of 12 ml min^?1. The volume content of feedstocks with 10–45 μm was above 65% and for D ₅₀ it was 15·42 μm. In addition, according to the heat and mass transfer equation, the drying mechanism was established, which was well in agreement with the experimental results.     

Advances in Digital Front-End and Software RF Processing： Part II

In the first editorial of this two-part special issue, we pointed out that one of the biggest trends in wireless broadband, radar, sonar, and broadcasting technology is software RF processing and digital front-end [1]. This     

Red bean extract reduces inflammation and increases survival in a murine sepsis model

This study used in vitro and in vivo experimental models to investigate the anti-inflammatory potential of the butanol fraction of red bean ethanol extract (BF-RBEE), which contains the biologically active molecule catechin-7-β-d-glucopyranoside. Treatment with BF-RBEE inhibited nitric oxide production in lipopolysaccharide (LPS)-stimulated macrophages through suppression of extracellular signalregulated kinase and IκBα activation. In an in vivo murine sepsis model, oral administration of BF-RBEE improved mouse survival. Specifically, the survival rate of mice injected with LPS was 0 and 40% in ICR and BALB/c mice, respectively, whereas the survival of mice co-treated with BF-RBEE was 100% in both mouse types. This increase in survival with the BF-RBEE administration was correlated with decreased tumor-necrosis factor-α and interferon-γ and increased interleukin-10. Oral administration of BF-RBEE also inhibited total and ovalbumin-specific IgE production in experimental mice. These results suggest the possible usefulness of red beans in the treatment of inflammatory diseases.     

Effect of Interface Properties on Mechanical Behavior of 3D Four-Directional Braided Composites with Large Braid Angle Subjected to Uniaxial Tension

A Representative Volume Cell (RVC) chosen to epitomize the entire three dimensional four-directional braided composites is investigated to evaluate the mechanical behavior of the material by computational micromechanics. In addition to including several damage modes of braid yarn and matrix within the braided composites, the numerical model also takes into account interface damage mode by using a Cohesive Zone Model (CZM). A parametrical study is conducted to evaluate the influence of interface properties on the macro stress-strain curve and the interaction of different failure modes of the braided composites under uniaxial tensile loading. The interface damage evolution of the braided composites with large braid angle is also provided further. Preliminary results indicate that the interface damage, which is one of the key factors to cause the nonlinearity of the stress-strain relationship, can decrease the elastic modulus but not obviously control the ultimate strength of the braided composites with large braid angle.     

水处理剂用量对缓蚀阻垢性能的影响

冷却水长期循环使用后,会出现腐蚀、结垢、微生物滋生等问题,影响系统的正常运行。通过对循环冷却水系统进行合理的水质处理,同时采用腐蚀在线监测技术对系统的腐蚀状况进行监测,保证了循环水系统安全、稳定运行。     

MEUF去除废水中重金属和有机物及其浓缩液的处理

胶团强化超滤(MEUF)是一种表面活性剂和超滤相结合的处理含重金属或有机污染物废水的新技术。详细介绍了MEUF技术的原理、表面活性剂的选择、影响处理效果的主要因素,同时针对MEUF技术目前存在的浓缩液处理和表面活性剂回收的问题作了详细的阐述,综述了近年来MEUF技术应用的最新研究成果,并就此技术存在的问题和发展前景作了相关分析,实践表明该技术具有很好的应用前景。     

浆态床合成气制二甲醚反应器数学模拟

建立了包括液相返混和催化剂颗粒沉降的合成气一步法制二甲醚浆态床反应器的数学模型,模拟计算了空速、原料气组成、反应温度、反应压力等反应条件对反应的影响。计算结果表明,CO转化率和二甲醚的选择性随温度增加、压力增大而提高,在一定温度、压力条件下,CO转化率随空速增大而减小,合成气含有一定量的CO2有利于CO转化率增加。